- 您現在的位置：買賣IC網 > PDF目錄3289 > EL5191ACSZ-T13 (Intersil)IC AMP CFA SNGL 1GHZ 8-SOIC PDF資料下載
參數資料
| 型號： | EL5191ACSZ-T13 |
| 廠商： | Intersil |
| 文件頁數： | 8/20頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC AMP CFA SNGL 1GHZ 8-SOIC |
| 標準包裝： | 2,500 |
| 放大器類型： | 電流反饋 |
| 電路數： | 1 |
| 轉換速率： | 2800 V/µs |
| -3db帶寬： | 1GHz |
| 電流 - 輸入偏壓： | 40µA |
| 電壓 - 輸入偏移： | 1000µV |
| 電流 - 電源： | 9mA |
| 電流 - 輸出 / 通道： | 120mA |
| 電壓 - 電源，單路/雙路(±)： | 5 V ~ 10 V，±2.5 V ~ 5 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 8-SOIC |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁
16
FN7180.3
May 16, 2007
As supply voltages continue to decrease, it becomes
necessary to provide input and output voltage ranges that
can get as close as possible to the supply voltages. The
EL5191 has an input range which extends to within 2V of
either supply. So, for example, on ±5V supplies, the EL5191
has an input range which spans ±3V. The output range of the
EL5191 is also quite large, extending to within 1V of the
supply rail. On a ±5V supply, the output is therefore capable
of swinging from -4V to +4V. Single-supply output range is
larger because of the increased negative swing due to the
external pull-down resistor to ground.
Video Performance
For good video performance, an amplifier is required to
maintain the same output impedance and the same
frequency response as DC levels are changed at the output.
This is especially difficult when driving a standard video load
of 150
Ω, because of the change in output current with DC
level. Previously, good differential gain could only be
achieved by running high idle currents through the output
transistors (to reduce variations in output impedance.)
These currents were typically comparable to the entire 9mA
supply current of each EL5191 amplifier. Special circuitry
has been incorporated in the EL5191 to reduce the variation
of output impedance with current output. This results in dG
and dP specifications of 0.035% and 0.04°, while driving
150
Ω at a gain of 2.
Video performance has also been measured with a 500
Ω
load at a gain of +1. Under these conditions, the EL5191 has
dG and dP specifications of 0.02% and 0.02°, respectively.
Output Drive Capability
In spite of its low 9mA of supply current, the EL5191 is
capable of providing a minimum of ±95mA of output current.
With a minimum of ±95mA of output drive, the EL5191 is
capable of driving 50
Ω loads to both rails, making it an
excellent choice for driving isolation transformers in
telecommunications applications.
Driving Cables and Capacitive Loads
When used as a cable driver, double termination is always
recommended for reflection-free performance. For those
applications, the back-termination series resistor will
decouple the EL5191 from the cable and allow extensive
capacitive drive. However, other applications may have high
capacitive loads without a back-termination resistor. In these
applications, a small series resistor (usually between 5
Ω and
50
Ω) can be placed in series with the output to eliminate
most peaking. The gain resistor (RG) can then be chosen to
make up for any gain loss which may be created by this
additional resistor at the output. In many cases it is also
possible to simply increase the value of the feedback
resistor (RF) to reduce the peaking.
Current Limiting
The EL5191 has no internal current-limiting circuitry. If the
output is shorted, it is possible to exceed the Absolute
Maximum Rating for output current or power dissipation,
potentially resulting in the destruction of the device.
Power Dissipation
With the high output drive capability of the EL5191, it is
possible to exceed the +125°C Absolute Maximum junction
temperature under certain very high load current conditions.
Generally speaking when RL falls below about 25Ω, it is
important to calculate the maximum junction temperature
(TJMAX) for the application to determine if power supply
voltages, load conditions, or package type need to be
modified for the EL5191 to remain in the safe operating area.
These parameters are calculated as follows:
where:
TMAX = Maximum ambient temperature
θJA = Thermal resistance of the package
n = Number of amplifiers in the package
PDMAX = Maximum power dissipation of each amplifier in
the package
PDMAX for each amplifier can be calculated as follows:
where:
VS = Supply voltage
ISMAX = Maximum supply current of 1A
VOUTMAX = Maximum output voltage (required)
RL = Load resistance
T
JMAX
T
MAX
θ
JA
nPD
MAX
×
()
+
=
PD
MAX
2
(
V
S
I
SMAX )
V
S
(
- V
OUTMAX )
V
OUTMAX
R
L
----------------------------
×
+
×
=
EL5191, EL5191A
相關PDF資料 |
PDF描述 |
|---|---|
| 1-535512-7 | CONN RECEPT 14POS .100 RT/A DUAL |
| VC08LC18A500DP | VARISTOR TVS ESD 18VDC 30A 0805 |
| EL5251IYZ-T7 | IC VFA 200MHZ DUAL 8-MSOP |
| EL5191ACSZ-T7 | IC AMP CFA SNGL 1GHZ 8-SOIC |
| 5-535585-8 | 16 MODIV VRT DR CE RCPT ASSY |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EL5191ACSZ-T7 | 功能描述:IC AMP CFA SNGL 1GHZ 8-SOIC RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 其它有關文件:Automotive Product Guide 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- 放大器類型:通用 電路數:1 輸出類型:滿擺幅 轉換速率:3 V/µs 增益帶寬積:10MHz -3db帶寬:- 電流 - 輸入偏壓:1pA 電壓 - 輸入偏移:70µV 電流 - 電源:2.5mA 電流 - 輸出 / 通道:48mA 電壓 - 電源，單路/雙路(±):2.7 V ~ 5.5 V，±1.35 V ~ 2.75 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-6 包裝:Digi-Reel® 其它名稱:MAX4475AUT#TG16DKR |
| EL5191ACW-T7 | 制造商:Intersil Corporation 功能描述:OP AMP SGL CURRENT FDBK 5V/10V 6PIN SOT-23 - Tape and Reel |
| EL5191ACW-T7A | 制造商:Intersil Corporation 功能描述:OP AMP SGL CURRENT FDBK 5V/10V 5PIN SOT-23 - Tape and Reel |
| EL5191ACWZ-T7 | 制造商:Intersil Corporation 功能描述:OP AMP SGL CURRENT FDBK 5V/10V 6PIN SOT-23 - Tape and Reel |
| EL5191ACWZ-T7A | 制造商:Intersil Corporation 功能描述:OP AMP SGL CURRENT FDBK 5V/10V 6PIN SOT-23 - Tape and Reel |
發布緊急采購，3分鐘左右您將得到回復。