- 您現在的位置：買賣IC網 > PDF目錄97899 > EL2160CS-T7 180MHz Current Feedback Amplifier PDF資料下載
參數資料
| 型號： | EL2160CS-T7 |
| 元件分類： | 運算放大器 |
| 英文描述： | 180MHz Current Feedback Amplifier |
| 中文描述： | 180Mhz的電流反饋放大器 |
| 文件頁數： | 5/18頁 |
| 文件大小： | 566K |
| 代理商： | EL2160CS-T7 |
13
EL2160C
180MHz Current Feedback Amplifier
E
L
21
60
C
The EL2160C consumes typically 8.5mA and maximum
11.0mA. The worst case power in an IC occurs when the
output voltage is at half supply, if it can go that far, or its
maximum values if it cannot reach half supply. If we set
the two PDMAX equations equal to each other, and solve
for VS, we can get a family of curves for various loads
and output voltages according to:
The following curves show supply voltage (±VS) vs
RLOAD for various output voltage swings for the 2 dif-
ferent packages. The curves assume worst case
conditions of TA = +85°C and IS = 11mA.
The curves do not include heat removal or forcing air, or
the simple fact that the package will probably be
attached to a circuit board, which can also provide some
form of heat removal. Larger temperature and voltage
ranges are possible with heat removal and forcing air
past the part.
Current Limit
The EL2160C has an internal current limit that protects
the circuit in the event of the output being shorted to
ground. This limit is set at 100mA nominally and
reduces with junction temperature. At a junction temper-
ature of 150°C, the current limits at about 65mA. If the
output is shorted to ground, the power dissipation could
be well over 1W. Heat removal is required in order for
the EL2160C to survive an indefinite short.
Driving Cables and Capacitive Loads
When used as a cable driver, double termination is
always recommended for reflection-free performance.
For those applications, the back termination series resis-
tor will decouple the EL2160C from the capacitive cable
and allow extensive capacitive drive. However, other
applications may have high capacitive loads without ter-
mination resistors. In these applications, an additional
small value (5
–50) resistor in series with the output
will eliminate most peaking. The gain resistor, RG, can
be chosen to make up for the gain loss created by this
additional series resistor at the output.
VS
RL
TMAX-TAMAX
()
×
θJA
----------------------------------------------------------
VOUT
()
2
(
IS RL ) VOUT
+
×
[]
÷
+
=
Supply Voltage vs RLOAD for Various VOUT
(8-Pin SO Package)
Supply Voltage vs RLOAD for
Various VOUT (PDIP Package)
相關PDF資料 |
PDF描述 |
|---|---|
| EL2170CN | 70 MHz/1 mA Current Mode Feedback Amplifiers |
| EL2170CS | 70 MHz/1 mA Current Mode Feedback Amplifiers |
| EL2170CW | 70 MHz/1 mA Current Mode Feedback Amplifiers |
| EL2170C | 70 MHz/1 mA Single Current Mode Feedback Amplifier(70 MHz/1 mA，單路電流模式反饋放大器) |
| EL2176C | 70 MHz/1 mA Current Mode Feedback Amp w/Disable |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EL2166 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:110MHz Current Feedback Amplifier with Disable |
| EL2166CN | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:110MHz Current Feedback Amplifier with Disable |
| EL2166CS | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:110MHz Current Feedback Amplifier with Disable |
| EL216-V | 功能描述:晶體管輸出光電耦合器 Optocouplers RoHS:否 制造商:Vishay Semiconductors 輸入類型:DC 最大集電極/發射極電壓:70 V 最大集電極/發射極飽和電壓:0.4 V 絕緣電壓:5300 Vrms 電流傳遞比:100 % to 200 % 最大正向二極管電壓:1.65 V 最大輸入二極管電流:60 mA 最大集電極電流:100 mA 最大功率耗散:100 mW 最大工作溫度:+ 110 C 最小工作溫度:- 55 C 封裝 / 箱體:DIP-4 封裝:Bulk |
| EL217 | 功能描述:晶體管輸出光電耦合器 Optocouplers RoHS:否 制造商:Vishay Semiconductors 輸入類型:DC 最大集電極/發射極電壓:70 V 最大集電極/發射極飽和電壓:0.4 V 絕緣電壓:5300 Vrms 電流傳遞比:100 % to 200 % 最大正向二極管電壓:1.65 V 最大輸入二極管電流:60 mA 最大集電極電流:100 mA 最大功率耗散:100 mW 最大工作溫度:+ 110 C 最小工作溫度:- 55 C 封裝 / 箱體:DIP-4 封裝:Bulk |
發布緊急采購，3分鐘左右您將得到回復。