- 您現在的位置：買賣IC網 > PDF目錄97870 > DS87C520-MCL (DALLAS SEMICONDUCTOR) 8-BIT, OTPROM, MICROCONTROLLER, PDIP40 PDF資料下載
參數資料
| 型號： | DS87C520-MCL |
| 廠商： | DALLAS SEMICONDUCTOR |
| 元件分類： | Microcontroller |
| 英文描述： | 8-BIT, OTPROM, MICROCONTROLLER, PDIP40 |
| 封裝： | 0.600 INCH, PLASTIC, DIP-40 |
| 文件頁數： | 3/42頁 |
| 文件大?。?/td> | 832K |
| 代理商： | DS87C520-MCL |
第1頁第2頁當前第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁
DS87C520/DS83C520
11 of 42
DATA MEMORY ACCESS CONTROL Table 3
DME1
DME0
DATA MEMEORY ADDRESS
MEMORY FUNCTION
0
0000h-FFFFh
External Data Memory *Default condition
0
1
0000h-03FFh
0400h-FFFFh
Internal SRAM Data Memory
External Data Memory
1
0
Reserved
1
0000h-03FFh
0400h-FFFBh
FFFCh
FFFDh-FFFFh
Internal SRAM Data Memory
Reserved - no external access
Read access to the status of lock bits
Reserved - no external access
Notes on the status byte read at FFFCh with DME1, 0 = 1, 1: Bits 2-0 reflect the programmed status of
the security lock bits LB2-LB0. They are individually set to a logic 1 to correspond to a security lock bit
that has been programmed. These status bits allow software to verify that the part has been locked before
running if desired. The bits are read only.
Note: After internal MOVX SRAM has been initialized, changing DME0/1 bits will have no effect on the
contents of the SRAM.
STRETCH MEMORY CYCLE
The DS87C520/DS83C520 allows software to adjust the speed of off-chip data memory access. The
microcontroller is capable of performing the MOVX in as few as two instruction cycles. The on-chip
SRAM uses this speed and any MOVX instruction directed internally uses two cycles. However, the time
can be stretched for interface to external devices. This allows access to both fast memory and slow
memory or peripherals with no glue logic. Even in high-speed systems, it may not be necessary or
desirable to perform off-chip data memory access at full speed. In addition, there are a variety of memory
mapped peripherals such as LCDs or UARTs that are slow.
The Stretch MOVX is controlled by the Clock Control Register at SFR location 8Eh as described below.
It allows the user to select a Stretch value between 0 and 7. A Stretch of 0 will result in a two-machine
cycle MOVX. A Stretch of 7 will result in a MOVX of nine machine cycles. Software can dynamically
change this value depending on the particular memory or peripheral.
On reset, the Stretch value will default to a 1, resulting in a three-cycle MOVX for any external access.
Therefore, off-chip RAM access is not at full speed. This is a convenience to existing designs that may
not have fast RAM in place. Internal SRAM access is always at full speed regardless of the Stretch
setting. When desiring maximum speed, software should select a Stretch value of 0. When using very
slow RAM or peripherals, select a larger Stretch value. Note that this affects data memory only and the
only way to slow program memory (ROM) access is to use a slower crystal.
Using a Stretch value between 1 and 7 causes the microcontroller to stretch the read/write strobe and all
related timing. Also, setup and hold times are increased by 1 clock when using any Stretch greater than 0.
This results in a wider read/write strobe and relaxed interface timing, allowing more time for
memory/peripherals to respond. The timing of the variable speed MOVX is in the Electrical
Specifications. Table 4 shows the resulting strobe widths for each Stretch value. The memory Stretch
uses the Clock Control Special Function Register at SFR location 8Eh. The Stretch value is selected using
bits CKCON.2-0. In the table, these bits are referred to as M2 through M0. The first Stretch (default)
allows the use of common 120 ns RAMs without dramatically lengthening the memory access.
相關PDF資料 |
PDF描述 |
|---|---|
| DS87C520-QNL | 8-BIT, OTPROM, 33 MHz, MICROCONTROLLER, PQCC44 |
| DS87C520-QCL | 8-BIT, OTPROM, 33 MHz, MICROCONTROLLER, PQCC44 |
| DS87C520-ECL | 8-BIT, OTPROM, 33 MHz, MICROCONTROLLER, PQFP44 |
| DS87C520-MNL | 8-BIT, OTPROM, 33 MHz, MICROCONTROLLER, PDIP40 |
| DS87C520-ENL | 8-BIT, OTPROM, 33 MHz, MICROCONTROLLER, PQFP44 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS87C520-MCL+ | 功能描述:8位微控制器 -MCU EPROM/ROM High-Speed RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| DS87C520-MNL | 功能描述:8位微控制器 -MCU EPROM/ROM High-Speed RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| DS87C520-MNL+ | 功能描述:8位微控制器 -MCU EPROM/ROM High-Speed RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| DS87C520-QCL | 功能描述:8位微控制器 -MCU EPROM/ROM High-Speed RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| DS87C520-QCL/T&R | 制造商:Maxim Integrated Products 功能描述:MICRO,OTP,HI SPD 44PLCC 33MHZ TRL - Tape and Reel 制造商:Maxim Integrated Products 功能描述:IC MCU EPROM/ROM 33MHZ HS 44PLCC |
發布緊急采購，3分鐘左右您將得到回復。