參數資料
型號: DS4301U-200+
廠商: Maxim Integrated Products
文件頁數: 7/7頁
文件大?。?/td> 0K
描述: IC POT DIG NV 200K 32POS 8-USOP
產品培訓模塊: Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
標準包裝: 50
接片: 32
電阻(歐姆): 200k
電路數: 1
溫度系數: 標準值 ±250 ppm/°C
存儲器類型: 非易失
接口: 3 線(芯片選擇,遞增,增/減)
電源電壓: 2.4 V ~ 5.5 V
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 8-TSSOP,8-MSOP(0.118",3.00mm 寬)
供應商設備封裝: 8-uMAX
包裝: 管件
DS4301
Nonvolatile, 32-Position Digital Potentiometer
Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are
implied. Maxim reserves the right to change the circuitry and specifications without notice at any time.
Maxim Integrated Products, 120 San Gabriel Drive, Sunnyvale, CA 94086 408-737-7600 _____________________ 7
2003 Maxim Integrated Products
Printed USA
is a registered trademark of Maxim Integrated Products.
cycled to the device, the wiper setting that was just
stored is the setting loaded on power-up.
Wiper storage does not have to occur immediately after
a change in wiper position. At anytime the current wiper
position can be stored to the EEPROM by simply issu-
ing a low pulse to the CS pin for tCLP while the INC pin
remains in a high state. The wiper does not move dur-
ing this action and the current wiper setting is stored in
EEPROM after tWST.
For applications that require a specific wiper setting to
be loaded on power-up and never changed, write the
desired wiper setting to the EEPROM, then tie CS to
VCC. Every time power is cycled to the DS4301, the
desired wiper setting is loaded from EEPROM, and
since CS is tied to VCC, no changes can be made to
the wiper setting.
EEPROM Characteristics
There is a limit to the number of times the EEPROM can
be written to before a wear-out occurs (see the
Nonvolatile Memory Characteristics table). After EEP-
ROM wear-out occurs, the wiper can still be adjusted,
however accurately storing the wiper position is no
longer possible. When power is removed from the part,
the current wiper position is lost. Upon power-up, the
wiper setting stored in EEPROM is loaded within tWLT of
VCC reaching a stable voltage level greater than or
equal to VCC MIN. If EEPROM wear-out has occurred,
the wiper setting that is loaded is unknown.
Application Information
To achieve the best results when using the DS4301,
decouple the power supply with a 0.01F or 0.1F
capacitor. Use a high-quality ceramic surface-mount
capacitor when possible. Surface-mount components
minimize lead inductance, improving performace.
Ceramic capacitors tend to have adequate high-
frequency response for decoupling applications.
Chip Information
TRANSISTOR COUNT: 3512
SUBSTRATE INFO: P-substrate
Package Information
For the latest package outline information, go to
www.maxim-ic.com/DallasPackInfo.
相關PDF資料
PDF描述
DS1307ZN IC RTC SERIAL 512K IND 8-SOIC
X9250US24Z IC XDCP QUAD 256TP 50K 24-SOIC
MAX5386NATE+ IC DGTL POT 256TAP DUAL 16-TQFN
VI-23H-MY-F3 CONVERTER MOD DC/DC 52V 50W
MAX5160NEUA+ IC DGTL POT LO PWR 32 TAP 8-UMAX
相關代理商/技術參數
參數描述
DS4301U-200/T&R 制造商:Maxim Integrated Products 功能描述:IC POT DIG NV 200K 32POS 8-USOP
DS4301U-200/T&R 功能描述:數字電位計 IC RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
DS4301U-200+ 功能描述:數字電位計 IC Nonvolatile 32-Position RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
DS4301U-200+T&R 制造商:Maxim Integrated Products 功能描述:DGTL POTENTIOMETER 32POS 200KOHM SGL 8USOP - Tape and Reel 制造商:Maxim Integrated Products 功能描述:Digital Potentiometer ICs Nonvolatile 32-Position
DS4301U-200+T&R 功能描述:數字電位計 IC Nonvolatile 32-Position RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel