- 鎮ㄧ従(xi脿n)鍦ㄧ殑浣嶇疆锛�璨疯常IC缍�(w菐ng) > PDF鐩寗1994 > DS3231MZ+ (Maxim Integrated Products)IC RTC I2C 8SOIC PDF璩囨枡涓嬭級
鍙冩暩(sh霉)璩囨枡
| 鍨嬭櫉锛� | DS3231MZ+ |
| 寤犲晢锛� | Maxim Integrated Products |
| 鏂囦欢闋佹暩(sh霉)锛� | 5/20闋� |
| 鏂囦欢澶у皬锛� | 0K |
| 鎻忚堪锛� | IC RTC I2C 8SOIC |
| 鐢�(ch菐n)鍝佸煿瑷�(x霉n)妯″锛� | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 妯�(bi膩o)婧�(zh菙n)鍖呰锛� | 100 |
| 椤炲瀷锛� | 鏅傞悩/鏃ユ |
| 鐗归粸锛� | 璀﹀牨鍣�锛岄枏骞�锛屾柟娉㈣几鍑� |
| 鏅傞枔鏍煎紡锛� | HH:MM:SS锛�12/24 灏忔檪锛� |
| 鏁�(sh霉)鎿�(j霉)鏍煎紡锛� | YY-MM-DD-dd |
| 鎺ュ彛锛� | I²C锛�2 绶氫覆鍙� |
| 闆绘簮闆诲锛� | 2.3 V ~ 5.5 V |
| 闆诲 - 闆绘簮锛岄浕姹狅細 | 2.3 V ~ 5.5 V |
| 宸ヤ綔婧害锛� | -40°C ~ 85°C |
| 瀹夎椤炲瀷锛� | 琛ㄩ潰璨艰 |
| 灏佽/澶栨锛� | 8-SOIC锛�0.154"锛�3.90mm 瀵級 |
| 渚涙噳(y墨ng)鍟嗚ō(sh猫)鍌欏皝瑁濓細 | 8-SOIC |
| 鍖呰锛� | 绠′欢 |
绗�1闋�绗�2闋�绗�3闋�绗�4闋�鐣�(d膩ng)鍓嶇5闋�绗�6闋�绗�7闋�绗�8闋�绗�9闋�绗�10闋�绗�11闋�绗�12闋�绗�13闋�绗�14闋�绗�15闋�绗�16闋�绗�17闋�绗�18闋�绗�19闋�绗�20闋�
卤5ppm, I2C Real-Time Clock
13
Maxim Integrated
DS3231M
Control Register (0Eh)
BIT 7
BIT 6
BIT 5
BIT 4
BIT 3
BIT 2
BIT 1
BIT 0
EOSC
BBSQW
CONV
NA
INTCN
A2IE
A1IE
0
1
0
BIT 7
EOSC: Enable oscillator. When set to logic 0, the oscillator is started. When set to logic 1, the oscillator is
stopped when the device switches to VBAT. This bit is clear (logic 0) when power is first applied. When the
device is powered by VCC, the oscillator is always on regardless of the status of the EOSC bit. When the oscil-
lator is disabled, all register data is static.
BIT 6
BBSQW: Battery-backed square-wave enable. When set to logic 1 with INTCN = 0 and VCC < VPF, this bit
enables the 1Hz square wave. When BBSQW is logic 0, INT/SQW goes high impedance when VCC falls below
VPF. This bit is disabled (logic 0) when power is first applied.
BIT 5
CONV: Convert temperature. Setting this bit to 1 forces the temperature sensor to convert the temperature
into digital code and execute the temperature compensate algorithm to update the oscillator鈥檚 accuracy. The
device cannot be forced to execute the temperature-compensate algorithm faster than once per second. A
user-initiated temperature conversion does not affect the internal update cycle. The CONV bit remains at a 1
from the time it is written until the temperature conversion is completed, at which time both CONV and BSY go
to 0. The CONV bit should be used when monitoring the status of a user-initiated conversion. See Figure 7 for
more details.
BITS 4:3
NA: Not applicable. These bits have no affect on the device and can be set to either 0 or 1.
BIT 2
INTCN: Interrupt control. This bit controls the INT/SQW output signal. When the INTCN bit is set to logic 0, a
1Hz square wave is output on INT/SQW. When the INTCN bit is set to logic 1, a match between the timekeep-
ing registers and either of the alarm registers activates the INT/SQW output (if the alarm is also enabled). The
corresponding alarm flag is always set regardless of the state of the INTCN bit. The INTCN bit is set to a logic
1 when power is first applied.
BIT 1
A2IE: Alarm 2 interrupt enable. When set to logic 1, this bit permits the alarm 2 flag (A2F) bit in the status reg-
ister to assert INT/SQW (when INTCN = 1). When the A2IE bit is set to logic 0 or INTCN is set to logic 0, the
A2F bit does not initiate an interrupt signal. The A2IE bit is disabled (logic 0) when power is first applied.
BIT 0
A1IE: Alarm 1 interrupt enable. When set to logic 1, this bit permits the alarm 1 flag (A1F) bit in the status reg-
ister to assert INT/SQW (when INTCN = 1). When the A1IE bit is set to logic 0 or INTCN is set to logic 0, the
A1F bit does not initiate an interrupt signal. The A1IE bit is disabled (logic 0) when power is first applied
.
鐩搁棞(gu膩n)PDF璩囨枡 |
PDF鎻忚堪 |
|---|---|
| DS3231SN#T&R | IC RTC W/TCXO 16-SOIC |
| DS3232MZ+ | IC RTC W/SRAM I2C 8SOIC |
| DS3232SN#T&R | IC RTC W/TCXO 20-SOIC |
| DS3234S# | IC RTC W/TCXO 20-SOIC |
| DS32C35-33#T&R | IC RTC ACCURATE I2C 3.3V 20-SOIC |
鐩搁棞(gu膩n)浠ｇ悊鍟�/鎶€琛�(sh霉)鍙冩暩(sh霉) |
鍙冩暩(sh霉)鎻忚堪 |
|---|---|
| DS3231MZ/V+ | 鍔熻兘鎻忚堪:瀵︽檪鏅傞悩 TRC/TCMO MEMS 8L RoHS:鍚� 鍒堕€犲晢:Microchip Technology 鍔熻兘:Clock, Calendar. Alarm RTC 绺界窔鎺ュ彛:I2C 鏃ユ湡鏍煎紡:DW:DM:M:Y 鏅傞枔鏍煎紡:HH:MM:SS RTC 瀛樺劜瀹归噺:64 B 闆绘簮闆诲-鏈€澶�:5.5 V 闆绘簮闆诲-鏈€灏�:1.8 V 鏈€澶у伐浣滄韩搴�:+ 85 C 鏈€灏忓伐浣滄韩搴�: 瀹夎棰�(f膿ng)鏍�:Through Hole 灏佽 / 绠遍珨:PDIP-8 灏佽:Tube |
| DS3231MZ/V+T | 鍔熻兘鎻忚堪:瀵︽檪鏅傞悩 TRC/TCMO MEMS 8L RoHS:鍚� 鍒堕€犲晢:Microchip Technology 鍔熻兘:Clock, Calendar. Alarm RTC 绺界窔鎺ュ彛:I2C 鏃ユ湡鏍煎紡:DW:DM:M:Y 鏅傞枔鏍煎紡:HH:MM:SS RTC 瀛樺劜瀹归噺:64 B 闆绘簮闆诲-鏈€澶�:5.5 V 闆绘簮闆诲-鏈€灏�:1.8 V 鏈€澶у伐浣滄韩搴�:+ 85 C 鏈€灏忓伐浣滄韩搴�: 瀹夎棰�(f膿ng)鏍�:Through Hole 灏佽 / 绠遍珨:PDIP-8 灏佽:Tube |
| DS3231MZ+ | 鍔熻兘鎻忚堪:瀵︽檪鏅傞悩 5+/-ppm RTC RoHS:鍚� 鍒堕€犲晢:Microchip Technology 鍔熻兘:Clock, Calendar. Alarm RTC 绺界窔鎺ュ彛:I2C 鏃ユ湡鏍煎紡:DW:DM:M:Y 鏅傞枔鏍煎紡:HH:MM:SS RTC 瀛樺劜瀹归噺:64 B 闆绘簮闆诲-鏈€澶�:5.5 V 闆绘簮闆诲-鏈€灏�:1.8 V 鏈€澶у伐浣滄韩搴�:+ 85 C 鏈€灏忓伐浣滄韩搴�: 瀹夎棰�(f膿ng)鏍�:Through Hole 灏佽 / 绠遍珨:PDIP-8 灏佽:Tube |
| DS3231MZ+TRL | 鍔熻兘鎻忚堪:瀵︽檪鏅傞悩 5+/-ppm RTC RoHS:鍚� 鍒堕€犲晢:Microchip Technology 鍔熻兘:Clock, Calendar. Alarm RTC 绺界窔鎺ュ彛:I2C 鏃ユ湡鏍煎紡:DW:DM:M:Y 鏅傞枔鏍煎紡:HH:MM:SS RTC 瀛樺劜瀹归噺:64 B 闆绘簮闆诲-鏈€澶�:5.5 V 闆绘簮闆诲-鏈€灏�:1.8 V 鏈€澶у伐浣滄韩搴�:+ 85 C 鏈€灏忓伐浣滄韩搴�: 瀹夎棰�(f膿ng)鏍�:Through Hole 灏佽 / 绠遍珨:PDIP-8 灏佽:Tube |
| DS3231MZEVKIT# | 鍔熻兘鎻忚堪:鏅傞悩鍜屽畾鏅傚櫒闁嬬櫦(f膩)宸ュ叿 Evaluation kit for t he +/-5ppm, I2C Real RoHS:鍚� 鍒堕€犲晢:Texas Instruments 鐢�(ch菐n)鍝�:Evaluation Modules 椤炲瀷:Clock Conditioners 宸ュ叿鐢ㄤ簬瑭曚及:LMK04100B 闋荤巼:122.8 MHz 宸ヤ綔闆绘簮闆诲:3.3 V |
鐧�(f膩)甯冪穵鎬ラ噰璩�锛�3鍒嗛悩宸﹀彸鎮ㄥ皣寰楀埌鍥炲京(f霉)銆�
