參數資料
型號: DS275E
廠商: MAXIM INTEGRATED PRODUCTS INC
元件分類: Line Driver or Receiver
英文描述: LINE TRANSCEIVER, PDSO14
封裝: TSSOP-14
文件頁數: 1/30頁
文件大?。?/td> 987K
代理商: DS275E
MAX14820
IO-Link Device Transceiver
19-5787; Rev 6; 3/14
General Description
The MAX14820 transceiver is suitable for IO-Link
devices and 24V binary sensors/actuators. All specified
IO-Link data rates are supported. In IO-Link applica-
tions, the transceiver acts as the physical layer interface
to a microcontroller running the data-link layer protocol.
Additional 24V digital inputs and outputs are provided.
Two internal linear regulators generate common sensor
and actuator power requirements: 5V and 3.3V.
On-board C/Q and DO drivers are independently config-
urable for push-pull, high-side (PNP), or low-side (NPN)
operation. The device detects the IO-Link C/Q wake-up
condition and generates a wake-up signal on the active-
low WU output. The C/Q and DI inputs have selectable
current loads for use in actuators.
An SPI interface allows configuration and monitoring of
the devices. Extensive alarm conditions are detected and
communicated through the IRQ output and the SPI inter-
face. The devices feature reverse-polarity, short-circuit,
and thermal protection. All power lines are monitored for
undervoltage conditions.
The C/Q driver is specified for sinking/sourcing 300mA.
The DO driver is specified for sinking/sourcing 135mA.
The device is available in a 4mm x 4mm, 24-pin TQFN
package, and is specified over the extended -40NC to
+85NC temperature range.
Applications
IO-Link Sensors
Industrial Sensors and Actuators
IO-Link Actuators
Features
S
IO-Link Specification v.1.0 and v.1.1 Physical Layer
Compliant
S
Supports COM1, COM2, and COM3 Data Rates
S
IO-Link Device Wake-up Detection
S
Push-Pull, High-Side, or Low-Side Outputs
S
300mA Specified C/Q Output Drive
S
1F C/Q and DO Load-Drive Capability
S
Auxiliary 24V, 135mA Digital Output
S
Auxiliary 24V Digital Input
S
Optional 6mA/7mA Current Loads at Both 24V Inputs
S
5V and 3.3V Linear Regulators
S
Reverse-Polarity Protected 24V Supply Output
S
EMI Emission Control Through Slew-Controlled Driver
S
SPI Interface for Configuration and Monitoring
S
2.5V to 5V Logic Interface Levels
S
Reverse-Polarity and Short-Circuit Protection on All
24V Inputs/Outputs
S
High-Temperature Warning and Thermal Shutdown
S
Extensive Fault Monitoring and Reporting
S
-40NC to +85NC Operating Temperature Range
S
4mm x 4mm TQFN Package
IO-Link is a registered trademark of Profibus User Organization (PNO).
SPI is a trademark of Motorola, Inc.
Ordering Information appears at end of data sheet.
Typical Operating Circuit
For related parts and recommended products to use with this part, refer to: www.maximintegrated.com/MAX14820.related
EVALUATION KIT AVAILABLE
1
2
4
3
10k
MAX14820
0.8
1F
0.1F
VCC
UV
GPIO2
LDOIN
DO
SPI
C/Q
L+
L-
GND
DI
GND
VP
V5
VCC
LDO33
VL
TXQ
MICROCONTROLLER
WU
IRQ
RX
TXC
TX
TXEN
RTS
LO
GPIO1
3.3V
5V
10
For pricing, delivery, and ordering information, please contact Maxim Direct at
1-888-629-4642, or visit Maxim Integrated’s website at www.maximintegrated.com.
相關PDF資料
PDF描述
DS275 LINE TRANSCEIVER, PDIP8
DS276S LINE TRANSCEIVER, PDSO8
DS276 LINE TRANSCEIVER, PDIP8
DS3112N DATACOM, FRAMER, PBGA256
DS3112 DATACOM, FRAMER, PBGA256
相關代理商/技術參數
參數描述
DS275E/T&R 制造商:Rochester Electronics LLC 功能描述: 制造商:Maxim Integrated Products 功能描述:IC TXRX LINE-PWR RS232 14-TSSOP
DS275E/T&R 功能描述:RS-232接口集成電路 RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝:
DS275E+ 功能描述:RS-232接口集成電路 RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝:
DS275E+T&R 制造商:Maxim Integrated Products 功能描述:IC TXRX LINE-PWR RS232 14-TSSOP
DS275E+T&R 功能描述:RS-232接口集成電路 RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: