- 您現在的位置：買賣IC網 > Datasheet目錄40 > DS2740U+T&R (Maxim Integrated)IC CURRENT GAUGE(15BIT) 8UMAX Datasheet資料下載
參數資料
| 型號： | DS2740U+T&R |
| 廠商： | Maxim Integrated |
| 文件頁數： | 6/16頁 |
| 文件大?。?/td> | 304K |
| 描述： | IC CURRENT GAUGE(15BIT) 8UMAX |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 3,000 |
| 功能： | 電流計（15 位） |
| 輸入電壓： | 2.7 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-TSSOP，8-MSOP（0.118"，3.00mm 寬） |
| 供應商設備封裝： | 8-uMAX |
| 包裝： | 帶卷 (TR) |
DS2740
6 of 16
CURRENT RESOLUTION (1 LSB)
R
SNS
PART
CONVERSION
TIME
V
IS1
- V
IS2
20m?
15m?
10m?
5m?
DS2740U
3.515s
1.5625糣 78.13糀 104.2糀 156.3糀 312.5糀
DS2740BU
0.878s
6.250糣 312.5糀 416.7糀 625糀
1.250mA
Every 1024th conversion, the ADC measures its input offset to facilitate offset correction. Offset
correction occurs approximately once per hour in the DS2740U and four times per hour in the
DS2740BU. The resulting correction factor is applied to the subsequent 1023 measurements. During the
offset correction conversion, the ADC does not measure the IS1 to IS2 signal. A maximum error of
1/1024 in the accumulated current register (ACR) is possible, however, to reduce the error, the current
measurement just prior to the offset conversion is displayed in the current register and is substituted for
the dropped current measurement in the current accumulation process. The typical error due to offset
correction is much less than 1/1024.
CURRENT ACCUMULATOR
Current measurements are internally summed, or accumulated, at the completion of each conversion
period with the results displayed in the ACR. The accuracy of the ACR is dependent on both the current
measurement and the conversion timebase. The ACR has a range of ?04.8mVh with a LSb of
6.25糣h. Additional registers hold fractional results of each accumulation, however, these bits are not
user accessible.
Read and write access is allowed to the ACR. Whenever the ACR is written, fractional accumulation
results are cleared. Also, a write forces the ADC to measure its offset and update the offset correction
factor. The current measurement and accumulation begin with the second conversion following a write to
the ACR. Figure 4 describes the ACR address, format, and resolution.
Figure 4. CURRENT ACCUMULATOR FORMAT
MSBAddress 10h LSBAddress 11h
S 2
14
2
13
2
12
2
11
2
10
2
9
2
8
2
7
2
6
2
5
2
4
2
3
2
2
2
1
2
0
MSb LSb MSb LSb
Units: 6.25糣h/R
SNS
ACR LSB
R
SNS
PART
UPDATE
INTERVAL
V
IS1
- V
IS2
20m?
15m?
10m?
5m?
DS2740U
3.515s
DS2740BU 0.878s
6.25糣h 312.5糀h 416.7糀h 625糀h
1.250mAh
相關PDF資料 |
PDF描述 |
|---|---|
| DS28EA00U+T&R | IC THERMOMETER 1-WIRE 8-USOP |
| DS3920T-001+ | IC CURRENT MIRROR 5:1 SOT23-6 |
| DS4560LS-LO+T | IC SWITCH HOT-PLUG 12V 8-SOIC |
| DS600U+T&R | IC SENSOR TEMP 8-USOP |
| DS620U+ | IC THERMOMETER/STAT DIG 8MSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS2741 | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:Current Monitor and Accumulator with Integrated Sense Resistor |
| DS2741_09 | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:Current Monitor and Accumulator with Integrated Sense Resistor |
| DS2741N+ | 功能描述:電池管理 RoHS:否 制造商:Texas Instruments 電池類型:Li-Ion 輸出電壓:5 V 輸出電流:4.5 A 工作電源電壓:3.9 V to 17 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:VQFN-24 封裝:Reel |
| DS2741N+T | 功能描述:電池管理 Current Monitor & Accumulator RoHS:否 制造商:Texas Instruments 電池類型:Li-Ion 輸出電壓:5 V 輸出電流:4.5 A 工作電源電壓:3.9 V to 17 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:VQFN-24 封裝:Reel |
| DS2745 | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:Low-Cost I2C Battery Monitor |
發布緊急采購，3分鐘左右您將得到回復。