- 您現在的位置：買賣IC網 > PDF目錄97868 > DS2404S-001 (MAXIM INTEGRATED PRODUCTS INC) 0 TIMER(S), REAL TIME CLOCK, PDSO16 PDF資料下載
參數資料
| 型號： | DS2404S-001 |
| 廠商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分類： | Timer or RTC |
| 英文描述： | 0 TIMER(S), REAL TIME CLOCK, PDSO16 |
| 封裝： | 0.300 INCH, SOIC-16 |
| 文件頁數： | 16/31頁 |
| 文件大?。?/td> | 1591K |
| 代理商： | DS2404S-001 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁
DS2404
23 of 29
Battery Operate Mode
Figure 17 shows the necessary connections for operating the DS2404 in Battery Operate mode.
BATTERY OPERATE MODE Figure 17
VCC
Pin 1 & 16
Ground
VBATB
Pin 9
Ground
VBATO
Pin 10
2.8 to 5.5V
The VBATO pin is normally connected to any standard 3 V lithium cell or other energy source. The Battery
Operate mode also minimizes the power-consumption in applications where battery backup is not
required and the VBATO lead is directly connected to the system’s 5V supply.
NOTE:
In Battery Operate mode, the voltage on DQ must never exceed the voltage on VBATO if the 3-wire
interface is used. This restriction does not apply to the 1-Wire interface.
DEVICE OPERATION MODES
With its two ports and two power modes the DS2404 can be operated in several ways. While the
maximum voltage on the 1-Wire port (I/O) is always 6V, the maximum voltage on the 3-wire port (DQ)
depends on the power mode and actual operating voltage. A particular port is selected by setting the
control lines to a state that makes the other port inactive. See Table 1 for details.
When using the 3-wire port only and the DS2404 is wired for VCC Operate Mode (Battery Backed) the
1 Wire I/O pin can be used as counter input. This mode requires that the I/O lead is connected to VCC
through a 5k
Ω (typical) resistor. To enable communication through the 3-wire port a reset/presence
sequence has to be performed on the 1-Wire port after the system has powered up.
相關PDF資料 |
PDF描述 |
|---|---|
| DS2404B | 0 TIMER(S), REAL TIME CLOCK, PDSO16 |
| DS2404 | 0 TIMER(S), REAL TIME CLOCK, PDIP16 |
| DS2405P | SPECIALTY MEMORY CIRCUIT, PDSO6 |
| DS2405 | SPECIALTY MEMORY CIRCUIT, PBCY3 |
| DS2405Z | SPECIALTY MEMORY CIRCUIT, PDSO4 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS2404S-001/T&R | 制造商:Maxim Integrated Products 功能描述:ECONORAM/TIME, SOIC16-TRL (GENERIC) - Tape and Reel |
| DS2404S-001+ | 制造商:Maxim Integrated Products 功能描述:REAL TIME CLOCK SERL 512BYTE 16SOIC - Rail/Tube |
| DS2404S-001+T&R | 制造商:Maxim Integrated Products 功能描述:REAL TIME CLOCK SERL 512BYTE 16SOIC - Tape and Reel |
| DS2404S-C01 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Peripheral IC |
| DS2405 | 功能描述:接口 - 專用 RoHS:否 制造商:Texas Instruments 產品類型:1080p60 Image Sensor Receiver 工作電源電壓:1.8 V 電源電流:89 mA 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:BGA-59 |
發布緊急采購，3分鐘左右您將得到回復。