參數資料
型號: DS2153Q
廠商: MAXIM INTEGRATED PRODUCTS INC
元件分類: Digital Transmission Controller
英文描述: DATACOM, FRAMER, PQCC44
封裝: 0.652 INCH, PLASTIC, LCC-44
文件頁數: 7/18頁
文件大?。?/td> 292K
代理商: DS2153Q
MAX13442E/MAX13443E/MAX13444E
±15kV ESD-Protected, ±80V Fault-Protected,
Fail-Safe RS-485/J1708 Transceivers
______________________________________________________________________________________
15
Applications Information
128 Transceivers on the Bus
The MAX13442E/MAX13443E/MAX13444E transceivers
1/4-unit-load receiver input impedance (48k
Ω) allows
up to 128 transceivers connected in parallel on one
communication line. Connect any combination of these
devices, and/or other RS-485 devices, for a maximum
of 32-unit loads to the line.
Reduced EMI and Reflections
The MAX13442E/MAX13444E are slew-rate limited,
minimizing EMI and reducing reflections caused by
improperly terminated cables. Figure 11 shows the dri-
ver output waveform and its Fourier analysis of a
125kHz signal transmitted by a MAX13443E. High-fre-
quency harmonic components with large amplitudes
are evident.
Figure 12 shows the same signal displayed for the
MAX13442E transmitting under the same conditions.
Figure 12’s high-frequency harmonic components are
much lower in amplitude, compared with Figure 11’s,
and the potential for EMI is significantly reduced.
In general, a transmitter’s rise time relates directly to
the length of an unterminated stub, which can be driven
with only minor waveform reflections. The following
equation expresses this relationship conservatively:
length = tRISE / (10 x 1.5ns/ft)
where tRISE is the transmitter’s rise time.
For example, the MAX13442E’s rise time is typically
800ns, which results in excellent waveforms with a stub
length up to 53ft. A system can work well with longer
unterminated stubs, even with severe reflections, if the
waveform settles out before the UART samples them.
RS-485 Applications
The MAX13442E/MAX13443E/MAX13444E transceivers
provide bidirectional data communications on multi-
point bus transmission lines. Figure 13 shows a typical
network application circuit. The RS-485 standard cov-
ers line lengths up to 4000ft. To minimize reflections
and reduce data errors, terminate the signal line at both
ends in its characteristic impedance, and keep stub
lengths off the main line as short as possible.
5.00MHz
500kHz/div
0
20dB/div
2V/div
Figure 11. Driver Output Waveform and FFT Plot of the
MAX13443E Transmitting a 125kHz Signal
5.00MHz
500kHz/div
0
20dB/div
2V/div
Figure 12. Driver Output Waveform and FFT Plot of the
MAX13442E Transmitting a 125kHz Signal
相關PDF資料
PDF描述
DS2154L DATACOM, FRAMER, PQFP100
DS21554L DATACOM, PCM TRANSCEIVER, PQFP100
DS21554LN DATACOM, PCM TRANSCEIVER, PQFP100
DS2155G DATACOM, FRAMER, PBGA100
DS21600SN PLL BASED CLOCK DRIVER, 2 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PDSO16
相關代理商/技術參數
參數描述
DS2153Q-A5 功能描述:IC TXRX E1 1-CHIP 5V 44-PLCC RoHS:否 類別:集成電路 (IC) >> 接口 - 電信 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS 產品變化通告:Product Discontinuation 06/Feb/2012 標準包裝:750 系列:*
DS2153Q-A5/T&R 制造商:Maxim Integrated Products 功能描述:IC TXRX E1 1-CHIP 5V 44-PLCC
DS2153Q-A5/T&R 功能描述:IC TXRX E1 1-CHIP 5V 44-PLCC RoHS:否 類別:集成電路 (IC) >> 接口 - 電信 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS 產品變化通告:Product Discontinuation 06/Feb/2012 標準包裝:750 系列:*
DS2153Q-A7 功能描述:網絡控制器與處理器 IC RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流(最大值):595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
DS2153Q-A7/T&R 制造商:Maxim Integrated Products 功能描述:E1 SINGLE CHIP XCVR REV A7 T&R - Tape and Reel