- 您現在的位置：買賣IC網 > PDF目錄11005 > DS21352LN+ (Maxim Integrated Products)IC TXRX T1 1-CHIP 3.3V 100-LQFP PDF資料下載
參數資料
| 型號： | DS21352LN+ |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 103/137頁 |
| 文件大小： | 0K |
| 描述： | IC TXRX T1 1-CHIP 3.3V 100-LQFP |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 90 |
| 功能： | 單芯片收發器 |
| 接口： | HDLC，T1 |
| 電路數： | 1 |
| 電源電壓： | 3.14 V ~ 3.47 V |
| 電流 - 電源： | 75mA |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 100-LQFP |
| 供應商設備封裝： | 100-LQFP（14x14） |
| 包裝： | 托盤 |
| 包括： | DSX-1 和 CSU 線路補償發生器，HDLC 控制器，帶內回路代碼發生器和檢測器 |
| 產品目錄頁面： | 1429 (CN2011-ZH PDF) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁當前第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁
DS21352/DS21552
68 of 137
Table 15-2 HDLC/BOC CONTROLLER REGISTERS
NAME
FUNCTION
HDLC Control Register (HCR)
general control over the HDLC and BOC controllers
HDLC Status Register (HSR)
key status information for both transmit and receive directions
HDLC Interrupt Mask Register (HIMR)
allows/stops status bits to/from causing an interrupt
Receive HDLC Register (RHIR)
status information on receive HDLC controller
Receive BOC Register (RBOC)
status information on receive BOC controller
Receive HDLC FIFO Register (RHFR)
access to 64–byte HDLC FIFO in receive direction
Receive HDLC DS0 Control Register 1 (RDC1)
controls the HDLC function when used on DS0 channels
Receive HDLC DS0 Control Register 2 (RDC2)
controls the HDLC function when used on DS0 channels
Transmit HDLC Register (THIR)
status information on transmit HDLC controller
Transmit BOC Register (TBOC)
enables/disables transmission of BOC codes
Transmit HDLC FIFO Register (THFR)
access to 64–byte HDLC FIFO in transmit direction
Transmit HDLC DS0 Control Register 1 (TDC1)
controls the HDLC function when used on DS0 channels
Transmit HDLC DS0 Control Register 2 (TDC2)
controls the HDLC function when used on DS0 channels
15.3.2 STATUS REGISTER FOR THE HDLC
Four of the HDLC/BOC controller registers (HSR, RHIR, RBOC, and THIR) provide status information.
When a particular event has occurred (or is occurring), the appropriate bit in one of these four registers
will be set to a one. Some of the bits in these four HDLC status registers are latched and some are real
time bits that are not latched. Section 15.3.2 contains register descriptions that list which bits are latched
and which are not. With the latched bits, when an event occurs and a bit is set to a one, it will remain set
until the user reads that bit. The bit will be cleared when it is read and it will not be set again until the
event has occurred again. The real time bits report the current instantaneous conditions that are occurring
and the history of these bits is not latched.
Like the other status registers, the user will always proceed a read of any of the four registers with a
write. The byte written to the register will inform the device which of the latched bits the user wishes to
read and have cleared (the real time bits are not affected by writing to the status register). The user will
write a byte to one of these registers, with a one in the bit positions he or she wishes to read and a zero in
the bit positions he or she does not wish to obtain the latest information on. When a one is written to a bit
location, the read register will be updated with current value and it will be cleared. When a zero is written
to a bit position, the read register will not be updated and the previous value will be held. A write to the
status and information registers will be immediately followed by a read of the same register. The read
result should be logically AND’ed with the mask byte that was just written and this value should be
written back into the same register to insure that bit does indeed clear. This second write step is necessary
because the alarms and events in the status registers occur asynchronously in respect to their access via
the parallel port. This write–read–write (for polled driven access) or write–read (for interrupt driven
access) scheme allows an external microcontroller or microprocessor to individually poll certain bits
without disturbing the other bits in the register. This operation is key in controlling the device with
higher–order software languages.
相關PDF資料 |
PDF描述 |
|---|---|
| DS2156L+ | IC TXRX T1/E1/J1 1-CHIP 100-LQFP |
| DS2155LC2+ | IC TXRX T1/E1/J1 SGL 100-LQFP |
| DS26504L+ | IC T1/E1/J1 64KCC ELEMENT 64LQFP |
| MC908QT2AMFQE | IC MCU 8BIT 1.5K FLASH 8-DFN |
| MC9S08LG16CLH | IC MCU 8BIT LG16 FLASH 64-LQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS21352LN+ | 功能描述:網絡控制器與處理器 IC T1 Single Chip Transceivers RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
| DS21354 | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:3.3V/5V E1 Single-Chip Transceivers |
| DS21354DK | 功能描述:網絡開發工具 DS21354 Dev Kit RoHS:否 制造商:Rabbit Semiconductor 產品:Development Kits 類型:Ethernet to Wi-Fi Bridges 工具用于評估:RCM6600W 數據速率:20 Mbps, 40 Mbps 接口類型:802.11 b/g, Ethernet 工作電源電壓:3.3 V |
| DS21354G | 功能描述:網絡控制器與處理器 IC RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
| DS21354GN | 功能描述:網絡控制器與處理器 IC RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。