- 您現在的位置：買賣IC網 > PDF目錄9182 > DS1809Z-W10+ (Maxim Integrated Products)IC DALLASTAT SGL 64POS 8SOIC PDF資料下載
參數資料
| 型號： | DS1809Z-W10+ |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 7/9頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC DALLASTAT SGL 64POS 8SOIC |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 100 |
| 系列： | Dallastat™ |
| 接片： | 64 |
| 電阻（歐姆）： | 10k |
| 電路數： | 1 |
| 溫度系數： | 標準值 750 ppm/°C |
| 存儲器類型： | 非易失 |
| 接口： | 上/下 |
| 電源電壓： | 4.5 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 8-SOIC |
| 包裝： | 管件 |
| 其它名稱： | 90-1809Z+W10 |
DS1809
7 of 9
AC ELECTRICAL CONDITIONS
PARAMETER
SYMBOL
MIN
TYP
MAX
UNITS
NOTES
Single Input Pulse Width
tPW
1
DC
ms
4,5,7,9
Repetitive Pulse High Time
tHPW
1
DC
ms
4,5,7,8,9
Continuous Pulse
tCCP
1
DC
ms
4,5,7,8,9
Storage Control Pulse
tSTR
1
μs
10,12
Capacitance
CIN
5
10
pF
10
ANALOG RESISTOR CHARACTERISTICS ELECTRICAL CONDITIONS
PARAMETER
SYMBOL
MIN
TYP
MAX
UNITS
NOTES
End-to-End Resistor
Tolerance
-20
+20
%
14
Absolute Linearity
-0.6
+0.6
LSB
15
Relative Linearity
-0.25
+0.25
LSB
16
-3 dB Cutoff Frequency
fCUTOFF
MHz
17
Temperature Coefficient
750
PPM/
C
14
NOTES:
1. All voltages are referenced with respect to ground.
2. Voltages across the potentiometer terminals (RL, RW, RH) cannot exceed VCC or go below ground by
0.5V.
3. Inputs UC and DC are internally pulled-up with resistance of 100 k
.
4. UC and DC inputs are internally pulled-up to VCC via a 100 kresistor.
5. Active current is specified when the inputs UC or DC are active.
6. Standby current is the current consumed when the UC, DC, and STR inputs are inactive.
7.
Input pulse width is the minimum time required for an input to cause an increment or decrement.
8. Repetitive pulse inputs on UC or DC will be recognized as long as they are within 500 milliseconds
of each other. Pulses occurring faster than 1 ms apart may not be recognized as individual and
separate pulses.
9. Input pulse timing has tolerances to ±10%.
10. Capacitance values apply at 25°C.
11. For VCC = 5V±10%, maximum VIL =+0.8V. Input logic levels are referenced to ground.
12. If not used STR should be connected to ground.
13. The DS1809 is offered in three values: 10 k
, 50 k, and 100 k.
相關PDF資料 |
PDF描述 |
|---|---|
| DS1809Z-010+C | IC DALLASTAT 10K 5.5V 8-SOIC |
| SI5326C-C-GM | IC ANY-RATE MULTI/ATTEN 36-QFN |
| M83723/82G1203N | CONN RCPT 3POS WALL MT W/SCKT |
| CS3106A-28-AYS | CONN PLUG 9POS STRAIGHT W/SCKT |
| MS3451W28-2P | CONN RCPT 14POS CBL MNT W/PINS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS1809Z-W10+ | 功能描述:數字電位計 IC Dallastat RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| DS180RT | 制造商:C&K Components 功能描述:DS180RT / Alt#: HADS0009 / Series: COMAX |
| DS1810 | 制造商:DALLAS 制造商全稱:Dallas Semiconductor 功能描述:5V EconoReset with Push-Pull Output |
| DS1810-10 | 功能描述:監控電路 5V EconoReset w/Push Pull Output RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| DS1810-10/T&R | 制造商:Maxim Integrated Products 功能描述:ECONORESET 5V 10% CMOS OUT/T092 T&R - Tape and Reel 制造商:Maxim Integrated Products 功能描述:IC ECONORESET 5V P-P 10% TO92-3 |
發布緊急采購，3分鐘左右您將得到回復。