- 您現在的位置：買賣IC網 > PDF目錄376959 > DS17487-5 3V/5V Real-Time Clock PDF資料下載
參數資料
| 型號： | DS17487-5 |
| 英文描述： | 3V/5V Real-Time Clock |
| 中文描述： | 3V/5V實時時鐘 |
| 文件頁數： | 7/38頁 |
| 文件大?。?/td> | 427K |
| 代理商： | DS17487-5 |
第1頁第2頁第3頁第4頁第5頁第6頁當前第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁
DS17485/DS17487
7 of 38
RTC ADDRESS MAP
The address map for the RTC registers of the DS17485/DS17487 is shown in Figure 2. The address map
consists of the 14 clock/calendar registers. Ten registers contain the time, calendar, and alarm data, and
4 bytes are used for control and status. All registers can be directly written or read except for the
following:
1) Registers C and D are read-only.
2) Bit 7 of Register A is read-only.
3) The high order bit of the second byte is read-only.
Figure 2. DS17485 REAL-TIME CLOCK ADDRESS MAP
TIME, CALENDAR, AND ALARM LOCATIONS
The time and calendar information is obtained by reading the appropriate register bytes shown in Table 1.
The time, calendar, and alarm are set or initialized by writing the appropriate register bytes. The contents
of the time, calendar, and alarm registers can be either binary or binary-coded decimal (BCD) format.
Table 1 shows the binary and BCD formats of the 10 time, calendar, and alarm locations that reside in
both bank 0 and in bank 1, plus the two extended registers that reside in bank 1 only (bank 0 and
bank 1 switching is explained later in this text).
Before writing the internal time, calendar, and alarm registers, the SET bit in Register B should be written
to a logic 1 to prevent updates from occurring while access is being attempted. Also at this time, the data
format (binary or BCD) should be set by the data mode bit (DM) of Register B. All time, calendar, and
alarm registers must use the same data mode. The set bit in Register B should be cleared after the data
mode bit has been written to allow the real-time clock to update the time and calendar bytes.
Once initialized, the real time clock makes all updates in the selected mode. The data mode cannot be
changed without reinitializing the 10 data bytes. The 24/12 bit cannot be changed without reinitializing
the hour locations. When the 12-hour format is selected, the high order bit of the hours byte represents
PM when it is a logic 1. The time, calendar, and alarm bytes are always accessible because they are
double-buffered. Once per second the 10 bytes are advanced by 1 second and checked for an alarm
condition. If a read of the time and calendar data occurs during an update, a problem exists where
seconds, minutes, hours, etc., may not correlate. The probability of reading incorrect time and calendar
data is low. Several methods of avoiding any possible incorrect time and calendar reads are covered later
in this text.
相關PDF資料 |
PDF描述 |
|---|---|
| DS17487B-3 | 3V/5V Real-Time Clock |
| DS17487B-5 | 3V/5V Real-Time Clock |
| DS17487BN-3 | 3V/5V Real-Time Clock |
| DS17487BN-5 | 3V/5V Real-Time Clock |
| DS17487N-3 | 3V/5V Real-Time Clock |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS17487-5+ | 功能描述:實時時鐘 3V/5V RTC RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
| DS17487-5IND | 功能描述:實時時鐘 RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
| DS17487-5IND+ | 功能描述:實時時鐘 3V/5V RTC RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
| DS17487B-3 | 制造商:DALLAS 制造商全稱:Dallas Semiconductor 功能描述:3V/5V Real-Time Clock |
| DS17487B-5 | 制造商:DALLAS 制造商全稱:Dallas Semiconductor 功能描述:3V/5V Real-Time Clock |
發布緊急采購，3分鐘左右您將得到回復。