• <table id="rau06"><input id="rau06"></input></table>
  • 參數資料
    型號: DS17485S-3
    廠商: Maxim Integrated Products
    文件頁數: 3/31頁
    文件大?。?/td> 0K
    描述: IC RTC 3V 4K NV RAM 24-SOIC
    產品培訓模塊: Lead (SnPb) Finish for COTS
    Obsolescence Mitigation Program
    標準包裝: 31
    類型: 時鐘/日歷
    特點: 警報器,夏令時,閏年,NVSRAM,方波輸出
    存儲容量: 4KB
    時間格式: HH:MM:SS(12/24 小時)
    數據格式: YY-MM-DD-dd
    接口: 并聯
    電源電壓: 2.7 V ~ 3.7 V
    電壓 - 電源,電池: 2.5 V ~ 3.7 V
    工作溫度: 0°C ~ 70°C
    安裝類型: 表面貼裝
    封裝/外殼: 24-SOIC(0.295",7.50mm 寬)
    供應商設備封裝: 24-SOIC W
    包裝: 管件
    Detailed Description
    The DS17x85 is a successor to the DS1285 real-time
    clock (RTC). The device provides 18 bytes of real-time
    clock/calendar, alarm, and control/status registers and
    114 bytes of nonvolatile battery-backed RAM. The
    device also provides additional extended RAM in either
    2k/4k/8kbytes (DS17285/DS17485/DS17885). A time-
    of-day alarm, six maskable interrupts with a common
    interrupt output, and a programmable square-wave
    output are available. It also operates in either 24-hour
    or 12-hour format with an AM/PM indicator. A precision
    temperature-compensated circuit monitors the status of
    VCC. If a primary power-supply failure is detected, the
    device automatically switches to a backup supply. The
    backup supply input supports a primary battery, such
    as a lithium coin cell. The device is accessed by a mul-
    tiplexed address/data bus.
    Oscillator Circuit
    The DS17x85 uses an external 32.768kHz crystal. The
    oscillator circuit does not require any external resistors
    or capacitors to operate. Table 1 specifies several
    crystal parameters for the external crystal, and Figure 2
    shows a functional schematic of the oscillator circuit.
    The oscillator is controlled by an enable bit in the con-
    trol register. Oscillator startup times are highly depen-
    dent upon crystal characteristics, PC board leakage,
    and layout. High ESR and excessive capacitive loads
    are the major contributors to long startup times. A cir-
    cuit using a crystal with the recommended characteris-
    tics and proper layout usually starts within one second.
    An external 32.768kHz oscillator can also drive the
    DS17x85. In this configuration, the X1 pin is connected
    to the external oscillator signal and the X2 pin is left
    unconnected.
    Clock Accuracy
    The accuracy of the clock is dependent upon the accu-
    racy of the crystal and the accuracy of the match
    between the capacitive load of the oscillator circuit and
    the capacitive load for which the crystal was trimmed.
    Additional error will be added by crystal frequency drift
    caused by temperature shifts. External circuit noise
    coupled into the oscillator circuit may result in the clock
    running fast. Figure 3 shows a typical PC board layout
    for isolation of the crystal and oscillator from noise.
    Refer to
    Application Note 58: Crystal Considerations
    with Dallas Real-Time Clocks for detailed information.
    Clock Accuracy (DS17287,
    DS17487, and DS17887)
    The encapsulated DIP (EDIP) modules are trimmed at
    the factory to ±1 minute per month accuracy at 25°C.
    DS17285/DS17287/DS17485/DS17487/DS17885/DS17887
    Real-Time Clocks
    ____________________________________________________________________
    11
    PARAMETER
    SYMBOL
    MIN
    TYP
    MAX
    UNITS
    Nominal
    fO
    32.768
    kHz
    Series
    Resistance
    ESR
    50
    k
    Ω
    Load
    Capacitance
    CL
    6 or
    12.5
    pF
    Table 1. Crystal Specifications* (DS17x85
    Only)
    *
    The crystal, traces, and crystal input pins should be isolated
    from RF generating signals. Refer to Application Note 58:
    Crystal Considerations for Dallas Real-Time Clocks for addi-
    tional specifications.
    COUNTDOWN
    CHAIN
    X1
    X2
    CRYSTAL
    CL1CL2
    RTC REGISTERS
    DS17285/87
    DS17485/87
    DS17885/87
    Figure 2. Oscillator Circuit Showing Internal Bias Network
    LOCAL GROUND PLANE (TOP LAYER)
    CRYSTAL
    GND
    X2
    X1
    NOTE: AVOID ROUTING SIGNAL LINES
    IN THE CROSSHATCHED AREA
    (UPPER LEFT QUADRANT) OF
    THE PACKAGE UNLESS THERE IS
    A GROUND PLANE BETWEEN THE
    SIGNAL LINE AND THE DEVICE PACKAGE.
    Figure 3. Layout Example
    相關PDF資料
    PDF描述
    MCP4661T-503E/ST IC POT DGTL 50K DUAL 14-TSSOP
    MCP4662T-103E/UN IC POT DGTL 10K DUAL 10-MSOP
    DS17485-5 IC RTC 5V 4K NV RAM 24-DIP
    MCP4262-103E/UN IC RHEOSTAT 10K 2CH 10MSOP
    VE-BNN-IU-F2 CONVERTER MOD DC/DC 18.5V 200W
    相關代理商/技術參數
    參數描述
    DS17485S-3/T&R 功能描述:實時時鐘 RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube
    DS17485S-3+ 功能描述:實時時鐘 3V/5V RTC RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube
    DS17485S-3+T&R 制造商:Maxim Integrated Products 功能描述:REAL TIME CLOCK MULTIPLEXED 4KBYTE 24SOIC - Tape and Reel 制造商:Maxim Integrated Products 功能描述:IC RTC 3V 4K NV RAM 24-SOIC 制造商:Maxim Integrated Products 功能描述:Real Time Clock 3V/5V RTC
    DS17485S-3+T&R 功能描述:實時時鐘 3V/5V RTC RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube
    DS17485S5 制造商:DALLAS 功能描述:*