- 您現在的位置：買賣IC網 > PDF目錄97864 > DS17287-5 (MAXIM INTEGRATED PRODUCTS INC) 1 TIMER(S), REAL TIME CLOCK, PDIP24 PDF資料下載
參數資料
| 型號： | DS17287-5 |
| 廠商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分類： | Timer or RTC |
| 英文描述： | 1 TIMER(S), REAL TIME CLOCK, PDIP24 |
| 封裝： | 0.720 INCH, ENCAPSULATED, DIP-24 |
| 文件頁數： | 16/35頁 |
| 文件大小： | 662K |
| 代理商： | DS17287-5 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁
The timing associated with both the wake-up and kick-
starting sequences is illustrated in the Wake-
Up/Kickstart Timing Diagram (Figure 6). The timing
associated with these functions is divided into five inter-
vals, labeled 1 to 5 on the diagram.
The occurrence of either a kickstart or wake-up condition
causes the PWR pin to be driven low, as described
above. During interval 1, if the supply voltage on the
DS17x85/DS17x87 VCC pin rises above the greater of
VBAT or VPF before the power-on timeout period (tPOTO)
expires, then PWR remains at the active-low level. If VCC
does not rise above the greater of VBAT or VPF in this
time, then the PWR output pin is turned off and returns to
its high-impedance level. In this event, the IRQ pin also
remains tri-stated. The interrupt flag bit (either WF or KF)
associated with the attempted power-on sequence
remains set until cleared by software during a subse-
quent system power-on.
If VCC is applied within the timeout period, then the sys-
tem power-on sequence continue as shown in intervals
2 to 5 in the timing diagram. During interval 2, PWR
remains active and IRQ is driven to its active-low level,
indicating that either WF or KF was set in initiating the
power-on. In the diagram KS is assumed to be pulled
up to the VBAUX supply. Also at this time, the PAB bit is
automatically cleared to 0 in response to a successful
power-on. The PWR line remains active as long as the
PAB remains cleared to 0.
DS17285/DS17287/DS17485/DS17487/DS17885/DS17887
Real-Time Clocks
____________________________________________________________________
23
Figure 6. Wake-Up/Kickstart Timing Diagram
Note: Wake-up/kickstart timeout is generated only when the oscillator is enabled and the countdown chain is not reset.
VBAT
VIH
tKSPW
tPOTP
VIH
1
2
3
45
VIL
HIGH-IMPEDANCE
VIL
VPF
0V
*CONDITION
VPF < VBAT
*THIS CONDITION CAN OCCUR WITH THE 3V DEVICE.
NOTE: THE TIME INTERVALS SHOWN ABOVE ARE REFERENCED IN THE WAKE-UP/KICKSTART SECTION.
*CONDITION
VBAT > VPF
WF/KF
(INTERNAL)
KS
PWR
IRQ
Table 6. Wake-Up/Kickstart Timing
(TA =+25°C)
PARAMETER
SYMBOL
CONDITIONS
MIN
TYP
MAX
UNITS
Kickstart-Input Pulse Width
tKSPW
2s
Wake-Up/Kickstart Power-On
Timeout
tPOTO
2s
相關PDF資料 |
PDF描述 |
|---|---|
| DS17285-5 | 1 TIMER(S), REAL TIME CLOCK, PDIP24 |
| DS17285SN-3 | 1 TIMER(S), REAL TIME CLOCK, PDSO24 |
| DS17885S-3 | 1 TIMER(S), REAL TIME CLOCK, PDSO24 |
| DS17885E-3 | 1 TIMER(S), REAL TIME CLOCK, PDSO28 |
| DS17285-3 | 1 TIMER(S), REAL TIME CLOCK, PDIP24 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS17287-5+ | 功能描述:實時時鐘 3V/5V RTC K Multiplexed Kick-S RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
| DS17287N-3 | 制造商:DALLAS 制造商全稱:Dallas Semiconductor 功能描述:3V/5V Real-Time Clock |
| DS17287N-5 | 制造商:DALLAS 制造商全稱:Dallas Semiconductor 功能描述:3V/5V Real-Time Clock |
| DS1730Y-150 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:NVRAM (Battery Based) |
| DS1730Y-150-IND | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:NVRAM (Battery Based) |
發(fā)布緊急采購，3分鐘左右您將得到回復。