- 您現在的位置：買賣IC網 > PDF目錄9328 > DS1693 (Maxim Integrated Products)IC RTC W/NV RAM 3V/5V 28-EDIP PDF資料下載
參數資料
| 型號： | DS1693 |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 3/36頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC RTC W/NV RAM 3V/5V 28-EDIP |
| 標準包裝： | 12 |
| 類型： | 時鐘/日歷 |
| 特點： | NVSRAM |
| 存儲容量： | 114B |
| 時間格式： | HH:MM:SS（12/24 小時） |
| 數據格式： | YY-MM-DD-dd |
| 接口： | 并聯 |
| 電源電壓： | 2.7 V ~ 3.3 V，4.5 V ~ 5.5 V |
| 電壓 - 電源，電池： | 2.5 V ~ 3.7 V |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 通孔 |
| 封裝/外殼： | 28-DIP 模塊（0.600"，15.24mm） |
| 供應商設備封裝： | 28-EDIP |
| 包裝： | 管件 |
第1頁第2頁當前第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁
DS1689/DS1693
11 of 36
A pattern of 01X in the DV2, DV1, and DV0, bits respectively, turns the oscillator on and enables the
countdown chain. Note that this is different than the DS1287, which required a pattern of 010 in these
bits. DV0 is now a “don’t care” because it is used for selection between register banks 0 and 1. A pattern
of 11X turns the oscillator on, but the oscillator’s countdown chain is held in reset, as it was in the
DS1287. Any other bit combination for DV2 and DV1 keeps the oscillator off.
PERIODIC INTERRUPT SELECTION
The periodic interrupt causes the
IRQ pin to go to an active state from once every 500ms to once every
122
s. This function is separate from the alarm interrupt, which can be output from once per second to
once per day. The periodic interrupt rate is selected using the same RS3–RS0 bits in Register A, which
select the square-wave frequency (Table 2). Changing the bits affects both the square-wave frequency and
the periodic interrupt output. However, each function has a separate enable bit in Register B. The SQWE
bit controls the square-wave output. Similarly, the periodic interrupt is enabled by the PIE bit in Register
B. The periodic interrupt can be used with software counters to measure inputs, create output intervals, or
await the next needed software function.
UPDATE CYCLE
The serialized RTC executes an update cycle once per second regardless of the SET bit in Register B.
When the SET bit in Register B is set to 1, the user copy of the double-buffered time, calendar, alarm and
elapsed time byte is frozen and does not update as the time increments. However, the time countdown
chain continues to update the internal copy of the buffer. This feature allows the time to maintain
accuracy independent of reading or writing the time, calendar, and alarm buffers and also guarantees that
time and calendar information is consistent. The update cycle also compares each alarm byte with the
corresponding time byte and issues an alarm if a match or if a “don’t care” code is present in all three
positions.
There are three methods that can handle access of the real-time clock that avoid any possibility of
accessing inconsistent time and calendar data. The first method uses the update-ended interrupt. If
enabled, an interrupt occurs after every up date cycle that indicates that over 999ms are available to read
valid time and date information. If this interrupt is used, the IRQF bit in Register C should be cleared
before leaving the interrupt routine.
A second method uses the update-in-progress bit (UIP) in Register A to determine if the update cycle is in
progress. The UIP bit will pulse once per second. After the UIP bit goes high, the update transfer occurs
244
s later. If a low is read on the UIP bit, the user has at least 244s before the time/calendar data will
be changed. Therefore, the user should avoid interrupt service routines that would cause the time needed
to read valid time/calendar data to exceed 244
s.
相關PDF資料 |
PDF描述 |
|---|---|
| MS3450W18-13PX | CONN RCPT 4POS WALL MNT W/PINS |
| MCP4262T-104E/MF | IC POT DGTL DUAL 100K RHEO 10DFN |
| MS3450W18-13PW | CONN RCPT 4POS WALL MNT W/PINS |
| MCP4262T-503E/MF | IC POT DGTL DUAL 50K RHEO 10DFN |
| DS1746WP-120 | IC RTC RAM Y2K 3.3V 120NS 34-PCM |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS1693+ | 功能描述:實時時鐘 RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
| DS1697N WAF | 制造商:Texas Instruments 功能描述: |
| DS1699-010 | 制造商:DALLAS 制造商全稱:Dallas Semiconductor 功能描述:ELECTRONIC DIGITAL RHEOSTAT |
| DS1699-10 | 制造商:DALLAS 制造商全稱:Dallas Semiconductor 功能描述:ELECTRONIC DIGITAL RHEOSTAT |
| DS1699-100 | 制造商:DALLAS 制造商全稱:Dallas Semiconductor 功能描述:ELECTRONIC DIGITAL RHEOSTAT |
發布緊急采購，3分鐘左右您將得到回復。