參數資料
型號： DS1693
廠商： DALLAS SEMICONDUCTOR
元件分類： Timer or RTC
英文描述： 1 TIMER(S), REAL TIME CLOCK, PDMA28
封裝： 0.740 INCH, MODULE, DIP-28
文件頁數： 11/32頁
文件大?。?/td> 381K
代理商： DS1693
DS1689/DS1693
19 of 32
addition, the other possible interrupt sources within the DS1689/DS1693 may cause IRQ to be driven
low. While system power is applied, the on chip logic will always attempt to drive the PWR pin active in
response to the enabled kickstart or wake-up condition. This is true even if PWR was previously inactive
as the result of power being applied by some means other than wake-up or kickstart.
The system may be powered down under software control by setting the PAB bit to a logic 1. This causes
the open-drain PWR pin to be placed in a high impedance state, as shown at the beginning of interval 4 in
the timing diagram. As VCC voltage decays, the IRQ output pin will be placed in a high impedance state
when VCC goes below VPF. If the system is to be again powered on in response to a wake-up or kickstart,
then the both the WF and KF flags should be cleared and WIE and/or KSE should be enabled prior to
setting the PAB bit.
During interval 5, the system is fully powered down.
Battery backup of the clock calendar and
nonvolatile RAM is in effect, PWR and IRQ are tri-stated, and monitoring of wake-up and kickstart takes
place.
RAM CLEAR
The DS1689/DS1693 provides a RAM clear function for the 114 bytes of user RAM. When enabled, this
function can be performed regardless of the condition of the VCC pin.
The RAM clear function is enabled or disabled via the RAM Clear Enable bit (RCE; bank 1, register
04BH). When this bit is set to a logic 1, the 114 bytes of user RAM will be cleared (all bits set to 1)
when an active low transition is sensed on the RCLR pin. This action will have no effect on either the
clock/calendar settings or upon the contents of the external extended RAM. The RAM clear Flag (RF,
bank 1, register 04BH) will be set when the RAM clear operation has been completed. If VCC is present at
the time of the RAM clear and RIE=1, the IRQ line will also be driven low upon completion. The
interrupt condition can be cleared by writing a 0 to the RF bit. The IRQ line will then return to its inactive
high level provided there are no other pending interrupts. Once the RCLR pin is activated, all read/write
accesses are locked out for a minimum recover time, specified as tREC in the Electrical Characteristics
section.
When RCE is cleared to 0, the RAM clear function is disabled. The state of the RCLR pin will have no
effect on the contents of the user RAM, and transitions on the RCLR pin have no effect on RF.
EXTENDED CONTROL REGISTERS
Two extended control registers are provided to supply controls and status information for the extended
features offered by the DS1689/DS1693. These are designated as extended control registers A and B and
are located in register bank 1, locations 04AH and 04BH, respectively. The functions of the bits within
these registers are described as follows.
EXTENDED CONTROL REGISTER 4A
MSB
LSB
BIT 7
BIT 6
BIT 5
BIT 4
BIT 3
BIT 2
BIT 1
BIT 0
VRT2
INCR
*
PAB
RF
WF
KF
相關PDF資料
PDF描述
DS1689 1 TIMER(S), REAL TIME CLOCK, PDIP28
DS1720S+T&R DIGITAL TEMP SENSOR-SERIAL, 9BIT(s), RECTANGULAR, SURFACE MOUNT
DS1720S+ DIGITAL TEMP SENSOR-SERIAL, 9BIT(s), RECTANGULAR, SURFACE MOUNT
DS1720S DIGITAL TEMP SENSOR-SERIAL, 9BIT(s), RECTANGULAR, SURFACE MOUNT
DS1721S+T&R DIGITAL TEMP SENSOR-SERIAL, 12BIT(s), 1Cel, RECTANGULAR, SURFACE MOUNT
相關代理商/技術參數
參數描述
DS1693+ 功能描述:實時時鐘 RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube
DS1697N WAF 制造商:Texas Instruments 功能描述:
DS1699-010 制造商:DALLAS 制造商全稱:Dallas Semiconductor 功能描述:ELECTRONIC DIGITAL RHEOSTAT
DS1699-10 制造商:DALLAS 制造商全稱:Dallas Semiconductor 功能描述:ELECTRONIC DIGITAL RHEOSTAT
DS1699-100 制造商:DALLAS 制造商全稱:Dallas Semiconductor 功能描述:ELECTRONIC DIGITAL RHEOSTAT
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*