- 您現在的位置：買賣IC網 > PDF目錄9315 > DS1689SN/T&R (Maxim Integrated Products)IC RTC SER NV RAM CTRL IN 28SOIC PDF資料下載
參數資料
| 型號： | DS1689SN/T&R |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 23/36頁 |
| 文件大小： | 0K |
| 描述： | IC RTC SER NV RAM CTRL IN 28SOIC |
| 標準包裝： | 1,000 |
| 類型： | 時鐘/日歷 |
| 特點： | NVSRAM |
| 存儲容量： | 114B |
| 時間格式： | HH:MM:SS（12/24 小時） |
| 數據格式： | YY-MM-DD-dd |
| 接口： | 并聯 |
| 電源電壓： | 2.7 V ~ 3.3 V，4.5 V ~ 5.5 V |
| 電壓 - 電源，電池： | 2.5 V ~ 3.7 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 28-SOIC（0.295"，7.50mm 寬） |
| 供應商設備封裝： | 28-SOIC |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁當前第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁
DS1689/DS1693
3 of 36
PIN
SO
EDIP
NAME
FUNCTION
13
PWR
Active-Low Power-On Interrupt Output. The
PWR pin is intended
for use as an on/off control for the system power. With VCC voltage
removed from the DS1689/DS1693,
PWR may be automatically
activated from a kickstart input via the
KS pin or from a wake-up
interrupt. Once the system is powered on, the state of
PWR can be
controlled via bits in the Dallas registers.
14, 19
14
GND
Ground. DC power is provided to the device on this pin.
15
KS
Active-Low Kickstart Input. When VCC is removed from the
DS1689/DS1693, the system can be powered on in response to an
active low transition on the
KS pin, as might be generated from a
key closure. VBAUX must be present and auxiliary battery enable bit
(ABE) must be set to 1 if the kickstart function is used, and the
KS
pin must be pulled up to the VBAUX supply. While VCC is applied, the
KS pin can be used as an interrupt input.
16
CS
Active-Low Chip Select Input. This signal must be asserted low
during a bus cycle for the RTC portion of the DS1689/DS1693 to be
accessed.
CS must be kept in the active state during RD and WR
timing. Bus cycles, which take place with ALE asserted but without
asserting,
CS will latch addresses. However, no data transfer will
occur.
17
ALE
Address Strobe Input (Active High). A pulse on the address strobe
pin serves to demultiplex the bus. The falling edge of ALE causes
the RTC address to be latched within the DS1689/DS1693.
18
WR
Active-Low Write Data Strobe. The
WR signal is an active low
signal. The
WR signal defines the time period during which data is
written to the addressed register.
20
RD
Active-Low Read Data Strobe.
RD identifies the time period when
the DS1689/DS1693 drives the bus with RTC read data. The
RD
signal is an enable signal for the output buffers of the clock.
21
PSEL
+3V or +5V Power Select. When PSEL is logic 1, 5V operation is
selected. When PSEL is logic 0 or is floated, the device is in
autosense mode and determines the correct mode of operation based
on the voltage on VCCI.
22
IRQ
Active-Low Interrupt Request Output (Open Drain). The
IRQ pin is
an active-low output of the DS1689/DS1693 that can be tied to the
interrupt input of a processor. The
IRQ output remains low as long
as the status bit causing the interrupt is present and the
corresponding interrupt-enable bit is set. To clear the
IRQ pin, the
application software must clear all enabled flag bits contributing to
IRQ’s active state. When no interrupt conditions are present, the IRQ
level is in the high impedance state. Multiple interrupting devices
can be connected to an
IRQ bus. The IRQ pin is an open-drain
output and requires an external pullup resistor.
23
—
VBAT
Battery Input for Any Standard 3V Lithium Cell or Other Energy
Source. Battery voltage must be held between 2.5V and 3.7V for
proper operation.
相關PDF資料 |
PDF描述 |
|---|---|
| DS1501WE/T&R | IC RTC WDOG Y2KC 3.3V 28-TSOP |
| MCP42010-E/SL | IC POT DGTL 10K 2CH SPI 14SOIC |
| VI-B1F-MV | CONVERTER MOD DC/DC 72V 150W |
| VE-BW0-MV | CONVERTER MOD DC/DC 5V 150W |
| MCP41010-E/P | IC POT DGTL 10K 1CH SPI 8DIP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS1689S-TRL | 功能描述:IC RTC SER W/NV RAM CTRL 28-SOIC RoHS:否 類別:集成電路 (IC) >> 時鐘/計時 - 實時時鐘 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:- 類型:時鐘/日歷 特點:警報器，閏年，SRAM 存儲容量:- 時間格式:HH:MM:SS（12/24 小時） 數據格式:YY-MM-DD-dd 接口:SPI 電源電壓:2 V ~ 5.5 V 電壓 - 電源，電池:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-WDFN 裸露焊盤 供應商設備封裝:8-TDFN EP 包裝:管件 |
| DS1691 | 功能描述:實時時鐘 RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
| DS1691 WAF | 制造商:Texas Instruments 功能描述: |
| DS1691/1692 WAF | 制造商:Texas Instruments 功能描述: |
| DS1691A | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:(RS-422/RS-423) Line Drivers with TRI-STATE Outputs |
發布緊急采購，3分鐘左右您將得到回復。