- 您現在的位置：買賣IC網 > PDF目錄97863 > DS1685Q-5 (DALLAS SEMICONDUCTOR) 1 TIMER(S), REAL TIME CLOCK, PQCC28 PDF資料下載
參數資料
| 型號： | DS1685Q-5 |
| 廠商： | DALLAS SEMICONDUCTOR |
| 元件分類： | Timer or RTC |
| 英文描述： | 1 TIMER(S), REAL TIME CLOCK, PQCC28 |
| 封裝： | PLASTIC, LCC-28 |
| 文件頁數： | 5/39頁 |
| 文件大?。?/td> | 290K |
| 代理商： | DS1685Q-5 |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁
DS1685/DS1687
13 of 39
When using the flag bits with fully enabled interrupts, the IRQ line will be driven low when an interrupt
flag bit is set and its corresponding enable bit is also set. IRQ will be held low as long as at least one of
the six possible interrupt sources has it s flag and enable bits both set. The IRQF bit in Register C is a 1
whenever the IRQ pin is being driven low as a result of one of the six possible active sources. Therefore,
determination that the DS1685/DS1687 initiated an interrupt is accomplished by reading Register C and
finding IRQF=1. IRQF will remain set until all enabled interrupt flag bits are cleared to 0.
SQUARE WAVE OUTPUT SELECTION
The SQW pin can be programmed to output a variety of frequencies divided down from the 32.768 kHz
crystal tied to X1 and X2. The square wave output is enabled and disabled via the SQWE bit in Register
B or the E32K bit in extended register 4Bh. If the square wave is enabled (SQWE=1 or E32K=1), then
the output frequency will be determined by the settings of the E32K bit in Extended Register 4Bh and by
the RS3-0 bits in Register A. If E32K=1, then a 32.768 kHz square wave will be output on the SQW pin
regardless of the settings of RS3-0 and SQWE.
If E32K = 0, then the square wave output frequency is determined by the RS3-0 bits. These bits control a
1-of-15 decoder which selects one of 13 taps that divide the 32.768 kHz frequency. The RS3-0 bits
establish the SQW output frequency as shown in Table 2. In addition, RS3-0 bits control the periodic
interrupt selection as described below.
If E32K=1, and the Auxiliary Battery Enable bit (ABE, bank 1; register 04BH) is enabled, and voltage is
applied to VBAUX then the 32 kHz square wave output signal will be output on the SQW pin in the
absence of VCC. This facility is provided to clock external power management circuitry. If any of the
above requirements are not met, no square wave output signal will be generated on the SQW pin in the
absence of VCC.
A pattern of 01X in the DV2, DV1, and DV0, bits respectively, will turn the oscillator on and enable the
countdown chain. Note that this is different than the DS1287, which required a pattern of 010 in these
bits. DV0 is now a “don’t care” because it is used for selection between register banks 0 and 1.
A pattern of 11X will turn the oscillator on, but the oscillator’s countdown chain will be held in reset, as
it was in the DS1287. Any other bit combination for DV2 and DV1 will keep the oscillator off.
PERIODIC INTERRUPT SELECTION
The periodic interrupt will cause the IRQ pin to go to an active state from once every 500 ms to once
every 122
s. This function is separate from the alarm interrupt which can be output from once per
second to once per day. The periodic interrupt rate is selected using the same RS3-0 bits in Register A
which select the square wave frequency (see Table 2). Changing the bits affects both the square wave
frequency and the periodic interrupt output. However, each function has a separate enable bit in Register
B. The SQWE and E32K bits control the square wave output. Similarly, the periodic interrupt is enabled
by the PIE bit in Register B. The periodic interrupt can be used with software counters to measure inputs,
create output intervals, or await the next needed software function.
相關PDF資料 |
PDF描述 |
|---|---|
| DS1689SN | 1 TIMER(S), REAL TIME CLOCK, PDSO28 |
| DS1689S | 1 TIMER(S), REAL TIME CLOCK, PDSO28 |
| DS1693 | 1 TIMER(S), REAL TIME CLOCK, PDMA28 |
| DS1689 | 1 TIMER(S), REAL TIME CLOCK, PDIP28 |
| DS1720S+T&R | DIGITAL TEMP SENSOR-SERIAL, 9BIT(s), RECTANGULAR, SURFACE MOUNT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS1685Q-5/T&R | 制造商:Maxim Integrated Products 功能描述:IC RTC 5V 64-BIT Y2KC 28-PLCC |
| DS1685Q-5/T&R | 功能描述:實時時鐘 3V/5V RTC RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
| DS1685Q-5/TR | 制造商:DALLAS 制造商全稱:Dallas Semiconductor 功能描述:3V/5V Real-Time Clocks |
| DS1685Q-5_12 | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:3V/5V Real-Time Clocks |
| DS1685Q-5+ | 功能描述:實時時鐘 3V/5V RTC RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。