- 您現在的位置：買賣IC網 > PDF目錄358701 > DS1554WP-150 256K NV Y2KC Timekeeping RAM PDF資料下載
參數資料
| 型號： | DS1554WP-150 |
| 英文描述： | 256K NV Y2KC Timekeeping RAM |
| 中文描述： | 256K內存時鐘非易失Y2KC |
| 文件頁數： | 9/21頁 |
| 文件大小： | 284K |
| 代理商： | DS1554WP-150 |
DS1554
9 of 21
The
IRQ
/FT pin can also be activated in the battery backed mode. The
IRQ
/FT will go low if an alarm
occurs and both ABE and AE are set. The ABE and AE bits are cleared during the power-up transition,
however an alarm generated during power-up will set AF. Therefore the AF bit can be read after system
power-up to determine if an alarm was generated during the power-up sequence. Figure 4 illustrates alarm
timing during the battery back-up mode and power-up states.
BACK-UP MODE ALARM WAVEFORMS Figure 4
USING THE WATCHDOG TIMER
The watchdog timer can be used to detect an out-of-control processor. The user programs the watchdog
timer by setting the desired amount of time-out into the 8-bit Watchdog Register (Address 7FF7h). The
five Watchdog Register bits BMB4-BMB0 store a binary multiplier and the two lower order bits RB1-
RB0 select the resolution, where 00=1/16 second, 01=1/4 second, 10=1 second, and 11=4 seconds. The
watchdog time-out value is then determined by the multiplication of the 5-bit multiplier value with the 2-
bit resolution value. (For example: writing 00001110 in the Watchdog Register = 3 X 1 second or 3
seconds.) If the processor does not reset the timer within the specified period, the Watchdog Flag (WF) is
set and a processor interrupt is generated and stays active until either the Watchdog Flag (WF) is read or
the Watchdog Register (7FF7) is read or written.
The most significant bit of the Watchdog Register is the Watchdog Steering Bit (WDS). When set to a 0,
the watchdog will activate the
IRQ
/FT output when the watchdog times out.
When WDS is set to a 1, the watchdog will output a negative pulse on the
RST
output for a duration of
40 ms to 200 ms. The Watchdog Register (7FF7) and the FT bit will reset to a 0 at the end of a watchdog
time-out when the WDS bit is set to a 1.
The watchdog timer resets when the processor performs a read or write of the Watchdog Register. The
time-out period then starts over. The watchdog timer is disabled by writing a value of 00h to the
Watchdog Register. The watchdog function is automatically disabled upon power-up and the Watchdog
Register is cleared. If the watchdog function is set to output to the
IRQ
/FT output and the frequency test
function is activated, the watchdog function prevails and the frequency test function is denied.
相關PDF資料 |
PDF描述 |
|---|---|
| DS1554WP-120 | 256K NV Y2KC Timekeeping RAM |
| DS1554W-150 | 256K NV Y2KC Timekeeping RAM |
| DS1669-010 | Dallastat Electronic Digital Rheostat |
| DS1669-050 | Dallastat Electronic Digital Rheostat |
| DS1669-10 | Dallastat Electronic Digital Rheostat |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS1556 | 制造商:DALLAS 制造商全稱:Dallas Semiconductor 功能描述:1M, Nonvolatile, Y2K-Compliant Timekeeping RAM |
| DS1556_10 | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:1M, Nonvolatile, Y2K-Compliant Timekeeping RAM |
| DS1556-70 | 功能描述:實時時鐘 1M NV RAM Timekeeper RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
| DS1556-70+ | 功能描述:實時時鐘 1M NV RAM Timekeeper RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
| DS1556-70IND | 功能描述:實時時鐘 RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。