- 您現在的位置：買賣IC網 > PDF目錄9319 > DS14285SN (Maxim Integrated Products)IC RTC W/NV RAM CNTRL IND 24SOIC PDF資料下載
參數資料
| 型號： | DS14285SN |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 6/26頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC RTC W/NV RAM CNTRL IND 24SOIC |
| 標準包裝： | 31 |
| 類型： | 時鐘/日歷 |
| 特點： | 警報器，夏令時，閏年，NVSRAM，方波輸出 |
| 存儲容量： | 114B |
| 時間格式： | HH:MM:SS（12/24 小時） |
| 數據格式： | YY-MM-DD-dd |
| 接口： | 并聯 |
| 電源電壓： | 4.5 V ~ 5.5 V |
| 電壓 - 電源，電池： | 2.5 V ~ 3.6 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 24-SOIC（0.295"，7.50mm 寬） |
| 供應商設備封裝： | 24-SOIC W |
| 包裝： | 管件 |
第1頁第2頁第3頁第4頁第5頁當前第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁
DS14285/DS14287
14 of 26
flag bits as they are cleared each time Register C is read. Double latching is included with Register C so
that bits which are set remain stable throughout the read cycle. All bits which are set (high) are cleared
when read and new interrupts which are pending during the read cycle are held until after the cycle is
completed. One, 2, or 3 bits can be set when reading Register C. Each utilized flag bit should be
examined when read to ensure that no interrupts are lost.
The second flag bit usage method is with fully enabled interrupts. When an interrupt flag bit is set and the
corresponding interrupt enable bit is also set, the IRQ pin is asserted low. IRQ is asserted as long as at
least one of the three interrupt sources has its flag and enable bits both set. The IRQF bit in Register C is
a one whenever the IRQ pin is being driven low. Determination that the RTC initiated an interrupt is
accomplished by reading Register C. A logic one in bit 7 (IRQF bit) indicates that one or more interrupts
have been initiated by the DS14285/DS14287. The act of reading Register C clears all active flag bits and
the IRQF bit.
PERIODIC INTERRUPT SELECTION
The periodic interrupt will cause the IRQ pin to go to an active state from once every 500 ms to once
every 122
s. This function is separate from the alarm interrupt which can be output from once per
second to once per day. The periodic interrupt rate is selected using the same Register A bits which select
the square wave frequency (see Table 2). Changing the Register A bits affects both the square wave
frequency and the periodic interrupt output. However, each function has a separate enable bit in Register
B. The SQWE bit controls the square wave output. Similarly, the periodic interrupt is enabled by the PIE
bit in Register B. The periodic interrupt can be used with software counters to measure inputs, create
output intervals, or await the next needed software function.
OSCILLATOR CONTROL BITS
When the DS14287 is shipped from the factory, the internal oscillator is turned off. This feature prevents
the lithium energy cell from being used until it is installed in a system. A pattern of 010 in bits 4 through
6 of Register A will turn the oscillator on and enable the countdown chain. A pattern of 11X will turn the
oscillator on, but holds the countdown chain of the oscillator in reset. All other combinations of bits 4
through 6 keep the oscillator off.
SQUARE-WAVE OUTPUT SELECTION
Thirteen of the 15 divider taps are made available to a 1-of-15 selector, as shown in the block diagram of
Figure 1. The first purpose of selecting a divider tap is to generate a square wave output signal on the
SQW pin. The RS0-RS3 bits in Register A establish the square wave output frequency. These frequencies
are listed in Table 2. The SQW frequency selection shares its 1-of-15 selector with the periodic interrupt
generator. Once the frequency is selected, the output of the SQW pin can be turned on and off under
program control with the square wave enable bit (SQWE).
相關PDF資料 |
PDF描述 |
|---|---|
| MCP4242-104E/UN | IC DGTL POT DL 100K 2CH 10-MSOP |
| DS1501YS | IC RTC WDOG Y2KC 5V 28-SOIC |
| VI-21B-MW | CONVERTER MOD DC/DC 95V 100W |
| VI-214-MX-B1 | CONVERTER MOD DC/DC 48V 75W |
| DS1501YN | IC RTC WDOG Y2KC 5V IND 28-PDIP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS14285SN/T&R | 制造商:Maxim Integrated Products 功能描述:IC RTC W/NV RAM CNTRL IND 24SOIC |
| DS14285SN/T&R | 功能描述:IC RTC W/NV RAM CNTRL IND 24SOIC RoHS:否 類別:集成電路 (IC) >> 時鐘/計時 - 實時時鐘 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:- 類型:時鐘/日歷 特點:警報器，閏年，SRAM 存儲容量:- 時間格式:HH:MM:SS（12/24 小時） 數據格式:YY-MM-DD-dd 接口:SPI 電源電壓:2 V ~ 5.5 V 電壓 - 電源，電池:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-WDFN 裸露焊盤 供應商設備封裝:8-TDFN EP 包裝:管件 |
| DS14285SN/TR | 制造商:DALLAS 制造商全稱:Dallas Semiconductor 功能描述:Real-Time Clock with NV RAM |
| DS14285SN+ | 功能描述:實時時鐘 RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
| DS14285SN+T&R | 制造商:Maxim Integrated Products 功能描述:IC RTC W/NV RAM CNTRL 24-SOIC 制造商:DSC 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。