- 您現在的位置：買賣IC網 > PDF目錄17061 > DC873A (Linear Technology)BOARD SAR ADC LTC1867L PDF資料下載
參數資料
| 型號： | DC873A |
| 廠商： | Linear Technology |
| 文件頁數： | 2/16頁 |
| 文件大小： | 0K |
| 描述： | BOARD SAR ADC LTC1867L |
| 軟件下載： | QuikEval System |
| 設計資源： | DC873A Schematic DC873A Design Files |
| 標準包裝： | 1 |
| 系列： | QuikEval™ |
| ADC 的數量： | 1 |
| 位數： | 16 |
| 采樣率（每秒）： | 175k |
| 數據接口： | MICROWIRE?，串行，SPI? |
| 工作溫度： | 0°C ~ 70°C |
| 已用 IC / 零件： | LTC1867L |
| 已供物品： | 板 |
| 相關產品： | LTC1867ACGN#PBF-ND - IC ADC 16BIT 8CH 200KSPS 16SSOP LTC1867LIGN#PBF-ND - IC ADC 16BIT 8CH 175KSPS 16SSOP LTC1867IGN#PBF-ND - IC ADC 16BIT 8CH 200KSPS 16SSOP LTC1867LACGN#PBF-ND - IC ADC 16BIT 8CH 175KSPS 16SSOP LTC1867CGN#PBF-ND - IC ADC 16BIT 8CH 200KSPS 16SSOP LTC1867IGN#TRPBF-ND - IC ADC 16BIT 8CH 200KSPS 16SSOP LTC1867AIGN#PBF-ND - IC ADC 16BIT 8CH 200KSPS 16SSOP LTC1867LAIGN#PBF-ND - IC ADC 16BIT 8CH 175KSPS 16SSOP LTC1867LCGN#PBF-ND - IC ADC 16BIT 8CH 175KSPS 16SSOP LTC1867LACGN#TRPBF-ND - IC ADC 16BIT 8CH 175KSPS 16SSOP 更多... |
LTC1863/LTC1867
10
18637fa
Driving the Analog Inputs
The analog inputs of the LTC1863/LTC1867 are easy to
drive. Each of the analog inputs can be used as a single-
ended input relative to the GND pin (CH0-GND, CH1-GND,
etc) or in pairs (CH0 and CH1, CH2 and CH3, CH4 and CH5,
CH6 and CH7) for differential inputs. In addition, CH7 can
act as a COM pin for both single-ended and differential
modes if the COM bit in the input word is high. Regard-
less of the MUX conguration, the “+” and “–” inputs are
sampled at the same instant. Any unwanted signal that is
common mode to both inputs will be reduced by the com-
mon mode rejection of the sample-and-hold circuit. The
inputs draw only one small current spike while charging
the sample-and-hold capacitors during the acquire mode.
In conversion mode, the analog inputs draw only a small
leakage current. If the source impedance of the driving
circuit is low then the LTC1863/LTC1867 inputs can be
driven directly. More acquisition time should be allowed
for a higher impedance source.
The following list is a summary of the op amps that are
suitable for driving the LTC1863/LTC1867. More detailed
information is available in the Linear Technology data
books or Linear Technology website.
LT1007 - Low noise precision amplier. 2.7mA supply
current ± 5V to ±15V supplies. Gain bandwidth product
8MHz. DC applications.
LT1097 - Low cost, low power precision amplier. 300μA
supply current. ±5V to ± 15V supplies. Gain bandwidth
product 0.7MHz. DC applications.
LT1227 - 140MHz video current feedback amplier. 10mA
supply current. ±5V to ±15V supplies. Low noise and low
distortion.
LT1360 - 37MHz voltage feedback amplier. 3.8mA supply
current. ±5V to ±15V supplies. Good AC/DC specs.
LT1363 - 50MHz voltage feedback amplier. 6.3mA supply
current. Good AC/DC specs.
LT1364/LT1365 - Dual and quad 50MHz voltage feedback
ampliers. 6.3mA supply current per amplier. Good
AC/DC specs.
LT1468 - 90MHz, 22V/μs 16-bit accurate amplier
LT1469 - Dual LT1468
Input Filtering
The noise and the distortion of the input amplier and
other circuitry must be considered since they will add to
the LTC1863/LTC1867 noise and distortion. Noisy input
circuitry should be ltered prior to the analog inputs to
minimize noise. A simple 1-pole RC lter is sufcient for
many applications. For instance, Figure 1 shows a 50Ω
source resistor and a 2000pF capacitor to ground on the
input will limit the input bandwidth to 1.6MHz. The source
impedance has to be kept low to avoid gain error and
degradation in the AC performance. The capacitor also
acts as a charge reservoir for the input sample-and-hold
and isolates the ADC input from sampling glitch sensitive
circuitry. High quality capacitors and resistors should be
used since these components can add distortion. NPO
and silver mica type dielectric capacitors have excellent
linearity. Carbon surface mount resistors can also generate
distortion from self heating and from damage that may
occur during soldering. Metal lm surface mount resistors
are much less susceptible to both problems.
APPLICATIONS INFORMATION
相關PDF資料 |
PDF描述 |
|---|---|
| DEMO9S08SH32 | DEMO BOARD FOR MC9S08SH32 |
| ASC07DRTS | CONN EDGECARD 14POS .100 DIP SLD |
| ASC07DRES | CONN EDGECARD 14POS .100 EYELET |
| VI-BWR-EY | CONVERTER MOD DC/DC 7.5V 50W |
| RCM15DCAD-S189 | CONN EDGECARD 30POS R/A .156 SLD |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DC874A | 制造商:Linear Technology 功能描述:DEMO BOARD FOR LTC4215 |
| DC878A | 制造商:Linear Technology 功能描述:EVAL BOARD, LTC3458LEDE STEP UP CONV, Silicon Manufacturer:Linear Technology, Si |
| DC88-12DC-210 | 制造商:Curtis Instruments 功能描述: |
| DC-88-2 | 制造商:FLORIDA MISC. 功能描述: 制造商:Florida Misc. 功能描述: |
| DC887A | 功能描述:BOARD SAR ADC LTC1408 RoHS:是 類別:編程器，開發系統 >> 評估板 - 模數轉換器 (ADC) 系列:QuikEval-II™ 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:- ADC 的數量:1 位數:12 采樣率（每秒）:94.4k 數據接口:USB 輸入范圍:±VREF/2 在以下條件下的電源（標準）:- 工作溫度:-40°C ~ 85°C 已用 IC / 零件:MAX11645 已供物品:板，軟件 |
發布緊急采購，3分鐘左右您將得到回復。