- 您現在的位置：買賣IC網 > PDF目錄376526 > D306A (Electronic Theatre Controls, Inc.) Electroluminescent Lamp Driver IC PDF資料下載
參數資料
| 型號： | D306A |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | Electroluminescent Lamp Driver IC |
| 中文描述： | 電致發光燈驅動IC |
| 文件頁數： | 4/13頁 |
| 文件大?。?/td> | 410K |
| 代理商： | D306A |
4
Theory of Operation
Electroluminescent (EL) lamps are essentially capacitors with one transparent electrode and a special phosphor
material in the dielectric. When a strong AC voltage is applied across the EL lamp electrodes, the phosphor
glows. The required AC voltage is typically not present in most systems and must be generated from a low
voltage DC source.
The D306A IC inverter drives the EL lamp by using a switching transistor to repeatedly charge an external
inductor and discharge it to the high voltage capacitor Cs. The discharging causes the voltage at Cs to
continually increase. The internal circuitry uses the H-bridge technology, using both electrodes to drive the
EL lamp. One of the outputs, Va or Vb, is used to discharge Cs into the EL lamp during the first half of the
low frequency (LF) cycle. By alternating the state of the H-bridge, the other output is used to charge the EL
lamp during the second half of the LF cycle. The alternating states make it possible to achieve 400V peak-
to-peak across the EL lamp.
The EL driving system is divided into several parts: on-chip logic control, on-chip high voltage output
circuitry, on-chip discharge logic circuitry, and off-chip components. The on-chip logic controls the lamp
operating frequency (LF) and the inductor switching frequency (HF). These signals are used to drive the
high voltage output circuitry (H-bridge) by delivering the power from the inductor to the lamp. The integrated
discharge logic circuitry uses a patented wave shaping technique for reducing audible noise from an EL
lamp. Changing the Rd value changes the slope of the linear discharge as well as the shape of the waveform.
The off-chip component selection provides a degree of flexibility to accommodate various lamp sizes, system
voltages, and brightness levels.
Typical D306A EL driving configurations for driving EL lamps in various applications are shown on the
following page. The expected system outputs for the various circuit configurations are also shown with each
respective figure. These examples are only guides for configuring the driver. Durel provides a D306A
Designer's Kit, which includes a printed circuit evaluation board intended to aid you in developing an EL
lamp driver configuration using the D306A that meets your requirements. A section on designing with the
D306A is included in this datasheet to serve as a guide to help you select the appropriate external components
to complete your D306A EL driver system.
Block Diagram of the Driver Circuitry
相關PDF資料 |
PDF描述 |
|---|---|
| D30E60 | Fast Switching EmCon Diode |
| D30L60 | CAP 100PF 200V 10% X7R RAD.20 .20X.20 TR-16 M-MIL-PRF-39014 STANDOFF |
| D30SC4 | Schottky Rectifiers (SBD) (40V 30A) |
| D30SC4M | Schottky Rectifiers (SBD) (40V 30A) |
| D30VT60 | SEMICONDUCTOR |
相關代理商/技術參數 |
參數描述 |
|---|---|
| D306EWA | 功能描述:LED 顯示器和配件 Orange Dual 7 Segment RoHS:否 制造商:Avago Technologies 顯示器類型:7 Segment 數位數量:2 字符大小:7.8 mm x 14.22 mm 照明顏色:Red 波長:628 nm 共用管腳:Common Anode 工作電壓:2.05 V 工作電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 35 C 封裝:Tube |
| D306RW | 制造商:MPD 制造商全稱:MicroPower Direct, LLC 功能描述:Single & Dual Output 3W SIP, Wide Input DC/DC Converters |
| D306SURWA/S530-A3 | 功能描述:LED 顯示器和配件 Hyper Red Dual 7 Segment RoHS:否 制造商:Avago Technologies 顯示器類型:7 Segment 數位數量:2 字符大小:7.8 mm x 14.22 mm 照明顏色:Red 波長:628 nm 共用管腳:Common Anode 工作電壓:2.05 V 工作電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 35 C 封裝:Tube |
| D3070 | 制造商:Dagnall Electronics 功能描述:TRANSFORMER 100VA 2 X 9V |
| D3070 | 制造商:Dagnall Electronics 功能描述:TRANSFORMER 100VA 2X 9V |
發布緊急采購，3分鐘左右您將得到回復。