
CY3600i
Document #: 38-03041 Rev. **
Page 2 of 3
Cypress Semiconductor Corporation, 2001. The information contained herein is subject to change without notice. Cypress Semiconductor Corporation assumes no responsibility for the use
of any circuitry other than circuitry embodied in a Cypress Semiconductor product. Nor does it convey or imply any license under patent or other rights. Cypress Semiconductor does not authorize
its products for use as critical components in life-support systems where a malfunction or failure may reasonably be expected to result in significant injury to the user. The inclusion of Cypress
Semiconductor products in life-support systems application implies that the manufacturer assumes all risk of such use and in doing so indemnifies Cypress Semiconductor against all charges.
Table 1
describes the function of each of these pins on the ISR programming cable. An OUTPUT is provided by the PC and an
INPUT is provided by the target system. The dimensions of the male connector required in the system are given below:
Male Connector:
2 x 5 = 2 rows, 5 pins per row
Measuring from center of the pins, each pin is 0.1
”
from the others.
Pin Length is 0.23
”
Pin cross-section is 0.025
”
x 0.025
”
Part Number:
Digi-Key
S2012-05-ND
(straight-pin connector)
Digi-Key S2112-05-ND
(right-angle connector)
PC System Requirements
One free parallel port
486 / 66MHz PC or better
Windows 95/98/NT
16 MB of RAM
1MB or more disk space
Ordering Information
ISR, Ultra37000, and F
LASH
370i are trademarks of Cypress Semiconductor Corporation.
Windows 95, Windows 98, and Windows NT are trademarks of Microsoft Corporation.
Digi-Key is a registered trademark of Digi-Key Corporation.
Table 1. F
LASH
370i Pin Description.
Pin
ISRVPP
OUTPUT
ISR*
OUTPUT
VCC
INPUT
SDO
INPUT
Type
Description
In System Reprogramming high-voltage programming pin.
In System Reprogramming enable indicator (active LOW).
+5V supply voltage provided from the target system to the cable.
Serial Data Output Receiver. The SDO output pin of the last device in the ISR chain of
the system is connected to this input pin.
Serial Mode Control. This is the mode select control input for the TAP controller state
machine contained in the ISR interface.
Serial Clock. ISR interface clock input.
Serial Data Input Driver. This output pin is connected to the SDI input of the first device
in the ISR chain.
No Connect.
Zero volt common ground for PC and target system.
SMODE
OUTPUT
SCLK
SDI
OUTPUT
OUTPUT
NC
GND
NC
—
Product Code
Description
CY3600i
ISR Programming Kit