- 您現在的位置：買賣IC網 > PDF目錄4069 > CS80C286-12 (Intersil)IC CPU 16BIT 5V 12.5MHZ 68-PLCC PDF資料下載
參數資料
| 型號： | CS80C286-12 |
| 廠商： | Intersil |
| 文件頁數： | 8/60頁 |
| 文件大小： | 0K |
| 描述： | IC CPU 16BIT 5V 12.5MHZ 68-PLCC |
| 標準包裝： | 126 |
| 處理器類型： | 80C286 16-位 |
| 速度： | 12.5MHz |
| 電壓： | 5V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 68-LCC（J 形引線） |
| 供應商設備封裝： | 68-PLCC（24.23x24.23） |
| 包裝： | 管件 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁
16
Reserved Memory Locations
The 80C286 reserves two fixed areas of memory in real
address mode (see Figure 7); system initialization area and
interrupt table area. Locations from addresses FFFF0(H)
through FFFFF(H) are reserved for system initialization. Initial
execution begins at location FFFF0(H). Locations 00000(H)
through 003FF(H) are reserved for interrupt vectors.
Interrupts
Table 9 shows the interrupt vectors reserved for exceptions
and interrupts which indicate an addressing error. The
exceptions leave the CPU in the state existing before
attempting to execute the failing instruction (except for
PUSH, POP, PUSHA, or POPA). Refer to the next section
on protected mode initialization for a discussion on excep-
tion 8.
Protected Mode Initialization
To prepare the 80C286 for protected mode, the LIDT
instruction is used to load the 24-bit interrupt table base and
16-bit limit for the protected mode interrupt table. This
instruction can also set a base and limit for the interrupt vec-
tor table in real address mode. After reset, the interrupt table
base is initialized to 000000(H) and its size set to 03FF(H).
These values are compatible with 80C86 and 80C88 soft-
ware. LIDT should only be executed in preparation for pro-
tected mode.
Shutdown
Shutdown occurs when a severe error is detected that prevents
further instruction processing by the CPU. Shutdown and halt
are externally signalled via a halt bus operation. They can be
distinguished by A1 HIGH for halt and A1 LOW for shutdown. In
real address mode, shutdown can occur under two conditions:
Exceptions 8 or 13 happen and the IDT limit does not
include the interrupt vector.
A CALL INT or PUSH instruction attempts to wrap around
the stack segment when SP is not even.
An NMI input can bring the CPU out of shutdown if the IDT
limit is at least 000F(H) and SP is greater than 0005(H), oth-
erwise shutdown can only be exited via the RESET input.
3H
RESET BOOTSTRAP
PROGRAM JUMP
INTERRUPT POINTER
FOR VECTOR 255
INTERRUPT POINTER
FOR VECTOR 1
INTERRUPT POINTER
FOR VECTOR 0
FFFFFH
FFFF0H
3FFH
3FCH
7H
4H
0H
INITIAL CS:IP VALUE IS F000:FFF0
FIGURE 7. 80C286 REAL ADDRESS MODE INITIALLY
RESERVED MEMORY LOCATIONS
80C286
相關PDF資料 |
PDF描述 |
|---|---|
| IP80C88 | IC CPU 8/16BIT 5V 5MHZ 40-DIP |
| SPC5200CBV400B | IC MPU 32BIT 500MHZ 272PBGA |
| ABB85DHBR | CONN EDGECARD 170PS R/A .050 SLD |
| XF2M-2215-1A | CONN FPC 22POS 0.5MM PITCH SMD |
| MPC859TCVR100A | IC MPU POWERQUICC 100MHZ 357PBGA |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CS80C286-1296 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| CS80C286-12X136 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| CS80C286-16 | 功能描述:微處理器 - MPU CPU 16BIT 5V CMOS 16 MHZ 68PLCC COM RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324 |
| CS80C286-1696 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| CS80C286-2 | 制造商:Harris Corporation 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。