- 您現在的位置：買賣IC網 > PDF目錄357718 > CPCI500D-3 (MURATA POWER SOLUTIONS INC) 4-OUTPUT 500 W DC-DC REG PWR SUPPLY MODULE PDF資料下載
參數資料
| 型號： | CPCI500D-3 |
| 廠商： | MURATA POWER SOLUTIONS INC |
| 元件分類： | 電源模塊 |
| 英文描述： | 4-OUTPUT 500 W DC-DC REG PWR SUPPLY MODULE |
| 封裝： | ROHS COMPLIANT |
| 文件頁數： | 2/4頁 |
| 文件大小： | 201K |
| 代理商： | CPCI500D-3 |
TDC_cPCI500 Series.B01
Page 2 of 4
Technical enquiries
email: sales@murata-ps.com, tel:
+1 508 339 3000
www.murata-ps.com
cPCI500 Series
500W 6Ux4HP DC/DC CompactPCI Power Supply
PROTECTION
Parameter
Conditions/Response
Inception
Min
Typ
Max
Units
Thermal Shutdown
Automatic recovery upon restoration to operational temperatures
90
oC
Output Power Limit
Automatic recovery
530
W
Input Protection
25
A
Over-voltage Protection
Output V1, latching
6.0
6.5
7.0
Vdc
Output V2, latching
3.9
4.3
4.7
Vdc
Parameter
Conditions/Response
Output Overload Protection
Outputs are individually protected against overloads and indefinite short circuit with automatic recovery upon removal of the fault condition.
Hot-Swap Capability
Design Verification Testing (DVT) confirms that voltage excursions on the output buses resulting from insertion/extraction events do not exceed the
specified maximum of 5%. However, routing of power and signal lines in the mating backplane is critical to minimization of such excursions. In
addition, performance can be critically affected by load characteristics including resistance, negative resistance, and reactive components. While
the control loop responses have been designed for optimum hot-swap performance over a wide range of characteristics, there may be instances
where the voltage excursions exceed published specifications. In such cases, the control loop responses can be modified to perform optimally.
Output Fault Isolation
Output isolation devices are present in all outputs to isolate faults within a failed power supply.
STATUS & CONTROL SIGNALS & INDICATORS
Name
Description
Hot-Swap Enable
Short pin on connector will enable the outputs when the mating pin is tied to DC GRD. Supply will not power up until this pin is engaged to its
mate in the backplane. Unit output will be inhibited as pin is disengaged from the mating connector.
Output Inhibit
Secondary referenced; active low, TTL compatible. Logic “0” or short circuit to Logic RTN (pin 40 or 43) inhibits all outputs.
DC Good
Secondary referenced. Open collector signal with an internal 2.2k pull-up resistor is connected to the +5V output. TTL signal will transition high
when all outputs are between 90% and 110% of their nominal voltage.
Remote Sense
Connection of the sense leads across the load at the desired point of regulation will compensate for voltage distribution drops up to 700mV
between the output terminals of the power supply and the point of connection. The unit reverts to local sensing if the sense lines are opened for
any reason. The output is protected against shorted or open leads. Applies to all outputs.
Fan Alarm
Secondary referenced; TTL compatible; active low. Signal transitions to a Logic 0 denotes a thermal warning.
Power Present Indicator LED
A green LED will be illuminated when the input voltage is present and above the minimum requirement.
DC Good Indicator LED
A green LED will be illuminated when the output voltages are within 90-110% of specification, coincident with assertion of the DC Good signal.
This LED will be extinguished if any of the output voltages is outside of this range.
Fan Good Indicator LED
A green LED will be illuminated when the fan is operational, coincident with de-assertion of the Fan Alarm signal. This LED will be extinguished in
the event of a fan failure.
Sync Start
A power supply generated signal used to simultaneously start power supplies connected in parallel when the load on any output exceeds a single
power supply’s capacity for that output. These pins must be bused together at the backplane in parallel/redundant applications (N+n) when N>1.
In simple redundant (1+1) or non-parallel applications (1+0), the pin can be ignored.
Power Supply Present
This pin presents a DC ground signal to the mating pin in the backplane. It is intended to be used by the system to detect the presence of a
power supply when the supply is mated into an available position.
ENVIRONMENTAL CHARACTERISTICS
Parameter
Conditions
Min
Typ
Max
Units
AmbientOperatingTemperature
De-rate output power linearly above 40oC to 250W at 60oC.
0
60
oC
Ambient Storage Temperature
-25
+125
oC
Humidity
Operating; non-condensing
10
95
%
Storage; non-condensing
5
95
%
Altitude
Operating. De-rate ambient temperature by 2Co per 1000ft above 5000ft.
-200
10000
ft
Storage
-200
40000
ft
Cooling
Self-cooled by internal fan
GENERAL CHARACTERISTICS
Parameter
Conditions
Min
Typ
Max
Units
Efficiency
48Vdc input, 500W load (dependent upon load profile)
65
%
Switching Frequency
72
kHz
MTBF
Calculated per MIL-HDBK-217F, 25oC, ground benign
84
khrs
Weight
Unpackaged
3.6
kg
相關PDF資料 |
PDF描述 |
|---|---|
| CPI-200 | SLOTTED OPTICAL SWITCH TRANSISTOR OUTPUT |
| CPR6V-010 | 6 A, 100 V, SILICON, RECTIFIER DIODE |
| CPT-182S-X | PHOTO TRANSISTOR DETECTOR |
| CQD2610V35-070-EF | INTERCONNECTION DEVICE |
| CR-58S35C-R | 0 MHz - 26500 MHz RF/MICROWAVE SGL POLE FIVE THROW SWITCH |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CPCI500D-3C | 功能描述:線性和開關式電源 DC/DC 3.3V 60A 500W 6Ux4HP CS IPMI RoHS:否 制造商:TDK-Lambda 產品:Switching Supplies 開放式框架/封閉式:Enclosed 輸出功率額定值:800 W 輸入電壓:85 VAC to 265 VAC 輸出端數量:1 輸出電壓（通道 1）:20 V 輸出電流（通道 1）:40 A 商用/醫用: 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:Rack 長度: 寬度: 高度: |
| CPCI500D-4C | 功能描述:線性和開關式電源 DC/DC 5.0V 55A 500W 6Ux4HP CS IPMI RoHS:否 制造商:TDK-Lambda 產品:Switching Supplies 開放式框架/封閉式:Enclosed 輸出功率額定值:800 W 輸入電壓:85 VAC to 265 VAC 輸出端數量:1 輸出電壓（通道 1）:20 V 輸出電流（通道 1）:40 A 商用/醫用: 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:Rack 長度: 寬度: 高度: |
| CPCI500D-5C | 功能描述:線性和開關式電源 DC/DC 5.0V 55A 500W 6Ux4HP CS RoHS:否 制造商:TDK-Lambda 產品:Switching Supplies 開放式框架/封閉式:Enclosed 輸出功率額定值:800 W 輸入電壓:85 VAC to 265 VAC 輸出端數量:1 輸出電壓（通道 1）:20 V 輸出電流（通道 1）:40 A 商用/醫用: 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:Rack 長度: 寬度: 高度: |
| CPCI500D-6C | 功能描述:線性和開關式電源 DC/DC 3.3V 60A 500W 6Ux4HP CS RoHS:否 制造商:TDK-Lambda 產品:Switching Supplies 開放式框架/封閉式:Enclosed 輸出功率額定值:800 W 輸入電壓:85 VAC to 265 VAC 輸出端數量:1 輸出電壓（通道 1）:20 V 輸出電流（通道 1）:40 A 商用/醫用: 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:Rack 長度: 寬度: 高度: |
| CPCI500DC | 功能描述:線性和開關式電源 500W HOT-SWAP 4 OUT RoHS:否 制造商:TDK-Lambda 產品:Switching Supplies 開放式框架/封閉式:Enclosed 輸出功率額定值:800 W 輸入電壓:85 VAC to 265 VAC 輸出端數量:1 輸出電壓（通道 1）:20 V 輸出電流（通道 1）:40 A 商用/醫用: 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:Rack 長度: 寬度: 高度: |
發布緊急采購，3分鐘左右您將得到回復。