- 您現在的位置：買賣IC網 > PDF目錄379912 > CM3107-00SH (California Micro Devices Corporation) 2 Amp Source/ Sink Bus Termination Regulator for DDR Memory and Front Side Bus Applications PDF資料下載
參數資料
| 型號： | CM3107-00SH |
| 廠商： | California Micro Devices Corporation |
| 英文描述： | 2 Amp Source/ Sink Bus Termination Regulator for DDR Memory and Front Side Bus Applications |
| 中文描述： | 2安培源/ DDR內存和前端總線接收器總線終端穩壓器的應用 |
| 文件頁數： | 11/13頁 |
| 文件大?。?/td> | 1214K |
| 代理商： | CM3107-00SH |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁
2004 California Micro Devices Corp. All rights reserved.
02/02/04
430 N. McCarthy Blvd., Milpitas, CA 95035-5112
L
Tel: 408.263.3214
L
Fax: 408.263.7846
L
www.calmicro.com
11
CM3107
Application Information (cont’d)
Figure 20. Front Side Bus Timing diagram
Note 1:Assumes V
DDQ
and V
DDQSEL
are tied
together in DDR application.
Table 1: V
TT
Output Selection Truth Table.
PCB Layout Considerations
The CM3107-00SB has a heat spreader attached to
the underneath of the PSOP-8 package in order for
heat to be transferred much easier from the package to
the PCB. The heat spreader is a copper pad of dimen-
sions just smaller than the package itself. By position-
ing the matching pad on the PCB top layer to connect
to the spreader during manufacturing, the heat will be
transferred between the two pads. The drawing below
shows the recommended PCB layout. Note that there
are six vias on either side to allow the heat to dissipate
into the ground and power planes on the inner layers of
the PCB. Vias can be placed underneath the chip, but
this can cause blockage of the solder. The ground and
power planes should be at least 2 sq in. of copper by
the vias. It also helps dissipation to spread if the chip is
positioned away from the edge of the PCB, and not
near other heat dissipating devices. A good thermal
link from the PCB pad to the rest of the PCB will ensure
a thermal link from the CM3107 package to ambient,
θ
JA
, of around 40°C/W.
Table 2: Recommended Heat Sink PCB Layout
VCC (CPU Core)
GMCH_EN
GMCHVCCP
V
DDQSEL
"1"
FSBSEL
V
TT
NOTE
Don’t Care
V
DDQSEL
/2
(Note1)
1.225V
1.45V
For DDR
Open or "0"
Open or "0"
"0"
"1"
For FSB
For FSB
相關PDF資料 |
PDF描述 |
|---|---|
| CM3107-00SM | 2 Amp Source/ Sink Bus Termination Regulator for DDR Memory and Front Side Bus Applications |
| CM3107-00SN | 2 Amp Source/ Sink Bus Termination Regulator for DDR Memory and Front Side Bus Applications |
| CM3107-12SH | 2 Amp Source/ Sink Bus Termination Regulator for DDR Memory and Front Side Bus Applications |
| CM310701S | 2 Amp Source/ Sink Bus Termination Regulator for DDR Memory and Front Side Bus Applications |
| CM3112 | 150mA/1.2V CMOS LDO Regulator |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CM3107-00SM | 制造商:CALMIRCO 制造商全稱:California Micro Devices Corp 功能描述:2 Amp Source/ Sink Bus Termination Regulator for DDR Memory and Front Side Bus Applications |
| CM3107-00SN | 制造商:CALMIRCO 制造商全稱:California Micro Devices Corp 功能描述:2 Amp Source/ Sink Bus Termination Regulator for DDR Memory and Front Side Bus Applications |
| CM310701S | 制造商:CALMIRCO 制造商全稱:California Micro Devices Corp 功能描述:2 Amp Source/ Sink Bus Termination Regulator for DDR Memory and Front Side Bus Applications |
| CM3107-12SH | 制造商:CALMIRCO 制造商全稱:California Micro Devices Corp 功能描述:2 Amp Source/ Sink Bus Termination Regulator for DDR Memory and Front Side Bus Applications |
| CM3108-000 | 制造商:TE Connectivity 功能描述:Heat Shrink Molded Boot 制造商:TE Connectivity 功能描述:222D232-25-02/225-0-CS8910 - Bulk |
發布緊急采購，3分鐘左右您將得到回復。