- 您現在的位置：買賣IC網 > PDF目錄384222 > CM2851 150mA Single CMOS LDO Regulator with ENABLE and POWER GOOD|LDO Regulator PDF資料下載
參數資料
| 型號： | CM2851 |
| 英文描述： | 150mA Single CMOS LDO Regulator with ENABLE and POWER GOOD|LDO Regulator |
| 中文描述： | 150mA的LDO穩(wěn)壓器的CMOS單用ENABLE和電源良好| LDO穩(wěn)壓器 |
| 文件頁數： | 5/11頁 |
| 文件大?。?/td> | 183K |
| 代理商： | CM2851 |
CM2851
150mA CMOS LDO W
ITH
EN & PG
DETAILED DESCRIPTION
The CM2851 family of CMOS regulators contain a PMOS pass transistor, voltage reference, error amplifier, over-current
protection, output short circuit protection, thermal shutdown, and power good function.
The P-channel pass transistor receives data from the error amplifier, over-current shutdown, short output protection, and thermal
protection circuits. During normal operation, the error amplifier compares the output voltage to a precision reference. Over-current
and Thermal shutdown circuits become active when the junction temperature exceeds 150
℃
, or the current exceeds 150mA.
During thermal shutdown, the output voltage remains low. Normal operation is restored when the junction temperature drops
below 120
℃
.
The CM2851 switches from voltage mode to current mode when the load exceeds the rated output current. This prevents
over-stress. The CM2851 also incorporates current fold-back to reduce power dissipation when the output is short-circuited. This
feature becomes active when the output drops below 0.95V, and reduces the current flow by 65%. Full current is restored when
the voltage exceeds 0.95V.
EXTERNAL CAPACITOR
The CM2851 is stable with an output capacitor to ground of 2.2μF or greater. It can keep stable even with higher or poor ESR
capacitors. A second capacitor is recommended between the input and ground to stabilize VIN. The input capacitor should be
larger than 0.1μF to have a beneficial effect. All capacitors should be placed in close proximity to the pins. A “quiet” ground
termination is desirable.
ENABLE
The Enable pin normally floats high. When actively, pulled low, the PMOS pass transistor shut off, and all internal circuits are
powered down. In this state, the quiescent current is less than 1μA. This pin behaves much like an electronic switch.
POWER GOOD
The CM2851 includes the Power Good feature. Normally, Pin 4 is “Low”, however, when the output is less than 15% of the
specified voltage, it pulls low. This can occur under the following conditions:
1) Input Voltage too low
2) During Over-Temperature
3) During Over-Current
2002/05/13
Preliminary
Champion Microelectronic Corporation
Page 5
相關PDF資料 |
PDF描述 |
|---|---|
| CM2852 | 300mA Single CMOS LDO Regulator with ENABLE and POWER GOOD|LDO Regulator |
| CM2854 | 150mA Single Adjustable CMOS LDO Regulator with ENABLE and POWER GOOD |LDO Regulator |
| CM3016 | Micropower. 4.75V/500mA Low Noise LDO |
| CM3404 | Micropower Voltage Supply Supervisor (SVS) |
| CM3718C | Low Noise PWM Step-Down Regulator |Battery Management ICs |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CM2852 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:300mA CMOS LDO WITH EN & PG |
| CM2852ACIM25 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:300mA CMOS LDO WITH EN & PG |
| CM2852SIM25 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:300mA CMOS LDO WITH EN & PG |
| CM2854 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:150mA Single Adjustable CMOS LDO Regulator with ENABLE and POWER GOOD |LDO Regulator |
| CM2855 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:300MA CMOS LDO WITH EN & PG |
發(fā)布緊急采購，3分鐘左右您將得到回復。