參數資料
型號: CM2009-00QR
廠商: California Micro Devices Corporation
英文描述: VGA Port Companion Circuit
中文描述: VGA端口伴侶電路
文件頁數: 5/6頁
文件大?。?/td> 116K
代理商: CM2009-00QR
2004 California Micro Devices Corp. All rights reserved.
08/12/04
430 N. McCarthy Blvd., Milpitas, CA 95035-5112
Tel: 408.263.3214
Fax: 408.263.7846
www.calmicro.com
5
CM2009
Application Information
Figure 1. Typical Application Connection Diagram
NOTES
1
2
3
The CM2009 should be placed as close to the VGA or DVI-I connector as possible.
The ESD protection channels VIDEO_1, VIDEO_2, VIDEO_3 may be used interchangeably between the R, G, B signals.
If differential video signal routing is used, the RED, BLUE, and GREEN signal lines should be terminated with external 37.5
resistors.
"VF" are external video filters for the RGB signals.
Supply bypass capacitors C1 and C2 must be placed immediately adjacent to the corresponding Vcc pins. Connections to
the Vcc pins and ground plane must be made with minimal length copper traces (preferably less than 5mm) for best ESD
protection.
The bypass capacitor for the BYP pin has been omitted in this diagram. This results in a reduction in the maximum ESD
withstand voltage at the DDC_OUT pins from
±
8kV to
±
4kV. If 8kV ESD protection is required, a 0.2
μ
F ceramic bypass
capacitor should be connected between BYP and ground.
The SYNC buffers may be used interchangeably between HSYNC and VSYNC.
The EMI filters at the SYNC_OUT and DDC_OUT pins (C5 to C12, and Ferrite Beads FB1 to FB4) are for reference only.
The component values and filter configuration may be changed to suit the application.
The DDC level shifters DDC_IN, DDC_OUT, may be used interchangeably between DDCA_CLK and DDCA_DATA.
10 R1, R2 are optional. They may be used, if required, to pull the DDC_CLK and DDC_DATA lines to VCC_5V when no moni-
tor is connected to the VGA connector. If used, it should be noted that "back current" may flow between the DDC pins and
VCC_5V via these resistors when VCC_5V is powered down.
11 For optimal ESD performance with the CM2009-02, an additional clamp device (such as the CMD PACDN042) should be
placed on HSYNC/VSYNC lines between the external matching resistor and the VGA connector.
4
5
6
7
8
9
DDC_OUT1
DDC_IN1
DDC_IN2
RED
Video Port
Connector
DDC_DATA
DDC_CLK
BLUE
GREEN
VCC_5V
VCCA_DAC
DDCA_CLK
DDCA_DATA
RED_VIDEO
GREEN_VIDEO
BLUE_VIDEO
CM2009
V
CC_SYNC
VIDEO_1
VIDEO_2
VIDEO_3
V
V
V
FB4
** VIDEO Filters.
See Note 4
V
CC_VIDEO
0.2uF
0.2uF
C1
100k
R1
100k
R2
C11
C12
FB3
C9
C10
FB2
C7
C8
FB1
C5
C6
Optional EMI Filters
75
75
75
SYNC_OUT2
SYNC_IN2
SYNC_OUT1
SYNC_IN1
DDC_OUT2
HSYNC
VSYNC
VSYNC_OUT
HSYNC_OUT
DIG_GND
SYNC_GND
RED_GND
GREEN_GND
BLUE_GND
V
CC_DDC
VCCGPIO
相關PDF資料
PDF描述
CM2009-00QS VGA Port Companion Circuit
CM2009-01QR VGA Port Companion Circuit
CM2009-01QS VGA Port Companion Circuit
CM2009-02QR VGA Port Companion Circuit
CM2009-02QS VGA Port Companion Circuit
相關代理商/技術參數
參數描述
CM2009-00QS 制造商:CALMIRCO 制造商全稱:California Micro Devices Corp 功能描述:VGA Port Companion Circuit
CM2009-01QR 制造商:CALMIRCO 制造商全稱:California Micro Devices Corp 功能描述:VGA Port Companion Circuit
CM2009-01QS 制造商:CALMIRCO 制造商全稱:California Micro Devices Corp 功能描述:VGA Port Companion Circuit
CM2009-02QR 功能描述:視頻 IC VGA Port Circuit 15 Ohm RoHS:否 制造商:Fairchild Semiconductor 工作電源電壓:5 V 電源電流:80 mA 最大工作溫度:+ 85 C 封裝 / 箱體:TSSOP-28 封裝:Reel
CM2009-02QS 制造商:CALMICRO 功能描述: