- 您現在的位置：買賣IC網 > PDF目錄1908 > CM2006-02QR (ON Semiconductor)IC VGA PORT COMPANION MON 16QSOP PDF資料下載
參數資料
| 型號： | CM2006-02QR |
| 廠商： | ON Semiconductor |
| 文件頁數： | 5/6頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC VGA PORT COMPANION MON 16QSOP |
| 標準包裝： | 2,500 |
| 系列： | Praetorian® |
| 應用： | 監控器，電視 |
| 電源電壓： | 5V |
| 封裝/外殼： | 16-SSOP（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 16-QSOP |
| 包裝： | 帶卷 (TR) |
| 安裝類型： | 表面貼裝 |
| 其它名稱： | CM2006-02QR-ND CM2006-02QROSTR |
CM2006
http://onsemi.com
5
APPLICATION INFORMATION
Figure 1. Typical Application Connection Diagram
NOTES:
1. The CM2006 should be placed as close to the VGA or DVII connector as possible.
2. The ESD protection channels VIDEO_1, VIDEO_2, VIDEO_3 may be used interchangeably between the R, G, B
signals.
3. If differential video signal routing is used, the RED, BLUE, and GREEN signal lines should be terminated with
external 37.5
W resistors.
4. “VF” are external video filters for the RGB signals.
5. Supply bypass capacitors C1 and C2 must be placed immediately adjacent to the corresponding Vcc pins.
Connections to the Vcc pins and ground plane must be made with minimal length copper traces (preferably less than
5 mm) for best ESD protection.
6. The bypass capacitor for the BYP pin has been omitted in this diagram. This results in a reduction in the maximum
ESD withstand voltage at the DDC_OUT pins from
±8 kV to ±2 kV. If 8 kV ESD protection is required, a 0.22 mF
ceramic bypass capacitor should be connected between BYP and ground.
7. The SYNC buffers may be used interchangeably between HSYNC and VSYNC.
8. The EMI filters at the SYNC_OUT and DDC_OUT pins (C5 to C12, and Ferrite Beads FB1 to FB4) are for reference
only. The component values and filter configuration may be changed to suit the application.
9. The DDC level shifters DDC_IN, DDC_OUT, may be used interchangeably between DDCA_CLK and
DDCA_DATA.
10. R1, R2 are optional. They may be used, if required, to pull the DDC_CLK and DDC_DATA lines to VCC_5V when
no VGA card is connected to the VGA monitor. If used, it should be noted that “back current” may flow between the
DDC pins and VCC_5V via these resistors when VCC_5V is powered down.
相關PDF資料 |
PDF描述 |
|---|---|
| CM2020-00TR | IC HDMI TX PORT P/I 38-TSSOP |
| CM2020-01TR | IC HDMI XMITTER PORT P/I 38TSSOP |
| CM2021-02TR | IC HDMI TX PORT P/I3 8TSSOP |
| CM2030-A0TR | IC HDMI TX PORT P/I 38-TSSOP |
| CM2031-A0TR | IC HDMI RX PORT P/I 38-TSSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CM2006-02QS | 制造商:CALMIRCO 制造商全稱:California Micro Devices Corp 功能描述:VGA Port Companion Circuit For Monitors |
| CM2009 | 制造商:CALMIRCO 制造商全稱:California Micro Devices Corp 功能描述:VGA Port Companion Circuit |
| CM200900QR | 制造商:CMD 功能描述: |
| CM2009-00QR | 功能描述:視頻 IC VGA Port Circuit 55 Ohm RoHS:否 制造商:Fairchild Semiconductor 工作電源電壓:5 V 電源電流:80 mA 最大工作溫度:+ 85 C 封裝 / 箱體:TSSOP-28 封裝:Reel |
| CM2009-00QS | 制造商:CALMIRCO 制造商全稱:California Micro Devices Corp 功能描述:VGA Port Companion Circuit |
發布緊急采購，3分鐘左右您將得到回復。