- 您現在的位置：買賣IC網 > PDF目錄379898 > CLC5801IM5X (NATIONAL SEMICONDUCTOR CORP) High Speed Low Noise Voltage Feedback Amplifier PDF資料下載
參數資料
| 型號： | CLC5801IM5X |
| 廠商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分類： | 運動控制電子 |
| 英文描述： | High Speed Low Noise Voltage Feedback Amplifier |
| 中文描述： | OP-AMP, 1000 uV OFFSET-MAX, 1800 MHz BAND WIDTH, PDSO5 |
| 封裝： | SOT-23, 5 PIN |
| 文件頁數： | 10/14頁 |
| 文件大?。?/td> | 462K |
| 代理商： | CLC5801IM5X |
Application Information
(Continued)
(2)
As seen in Figure 5 e
is dominated by the intrinsic voltage
noise (e
) of the amplifier for equivalent source resistance
below 121
. Between 121
and 5.11k
, e
is dominated by
the thermal noise (
Above 5.11k
, e
ni
is dominated by the amplifier’s current
noise (
R
). The point at which the CLC5801’s volt-
age noise and current noise contribute equally occurs for
R
seq
= 786
(
). As an example, configured with a
gain of +20V/V giving a 3dB of 90MHz and driven from an
R
seq
= 25
, the CLC5801 produces a total equivalent input
noise voltage (
) of the external resistors.
) of 26μV
rms
.
If bias current cancellation is not a requirement, then R
|| R
g
does not need to equal R
. In this case, according to Equa-
tion (1) R
|| R
should be as low as possible in order to mini-
mize noise. Results similar to Equation (1) are obtained for
the inverting configuration of Figure 2 if R
is replaced by
R
and R
is replaced by R
+ R
. With these substitutions,
Equation (1) will yield e
referred to the non-inverting input.
Referring e
ni
to the inverting input is easily accomplished by
multiplying e
ni
by the ratio of non-inverting to inverting gains.
Inverting Gains Less Than 10V/V
The lag compensation of Figure 6 will achieve stability for
lower gains. Placing the network between the two input ter-
minals does not affect the closed-loop nor noise gain, but is
best used for the inverting configuration because of its affect
on the non-inverting input impedance.
Single-Supply Operation
The CLC5801 can be operated with single power supply as
shown in Figure 7 Both the input and output are capacitively
coupled to set the DC operating point.
Low Noise Transimpedance Amplifier
Figure 8 shows a transimpedance amplifier used to amplify
the small signal from a Photodiode. Using a low noise ampli-
fier such as the CLC5801 and proper design, ensures that
the amplifier noise contribution is minimal. Here R
can be
used to compensate for the input bias current of the
CLC5801. Generally, R
is selected to be equal to R
to can-
cel the effect of I
b
flowing in each of the Op Amp input
terminals.
Figure 9 shows the equivalent noise analysis schematic for
this circuit. The complete expression for the amplifier stage
output rms noise is shown in Equation (3)
(3)
DS101307-32
FIGURE 4. Noise Model with R
f
|| R
g
= R
seq
DS101307-34
FIGURE 5. Voltage Noise Density vs. Source
Resistance
DS101307-35
FIGURE 6. External Lag Compensation
DS101307-36
FIGURE 7. Single Supply Operation
DS101307-37
FIGURE 8. Transimpedance Amplifier Configuration
C
www.national.com
10
相關PDF資料 |
PDF描述 |
|---|---|
| CLC5801IMX | High Speed Low Noise Voltage Feedback Amplifier |
| CLC5801 | High Speed Low Noise Voltage Feedback Amplifier |
| CLC5801IM | High Speed Low Noise Voltage Feedback Amplifier |
| CLC5801IM5 | High Speed Low Noise Voltage Feedback Amplifier |
| CLC5802 | Dual Low-Noise, Voltage Feedback Op Amp |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CLC5801IMX | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| CLC5802 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Dual Low-Noise, Voltage Feedback Op Amp |
| CLC5802/CLC428M WAF | 制造商:Texas Instruments 功能描述: |
| CLC5802IM | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| CLC5802IMX | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Dual Low-Noise, Voltage Feedback Op Amp |
發布緊急采購，3分鐘左右您將得到回復。