- 您現在的位置：買賣IC網 > PDF目錄16232 > CDB8130 (Cirrus Logic Inc)BOARD EVAL FOR CS8130 PDF資料下載
參數資料
| 型號： | CDB8130 |
| 廠商： | Cirrus Logic Inc |
| 文件頁數： | 2/28頁 |
| 文件大?。?/td> | 0K |
| 描述： | BOARD EVAL FOR CS8130 |
| 標準包裝： | 1 |
| 主要目的： | 接口，紅外線收發器 |
| 已用 IC / 零件： | CS8130 |
| 已供物品： | 板，CD |
| 相關產品： | 598-1204-5-ND - IC IR TRANSCEIVER 2-5V 20-SSOP 598-1203-5-ND - IC IR TRANSCEIVER 2-5V 20-SSOP |
| 其它名稱： | 598-1161 |
第1頁當前第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
Mode 3 (TV remote) Receive Choices
The modulation frequency must be set into the
modulator divider registers. The tolerance on the
expected frequency must be programmed into
the Receive ASK Timing Sensitivity (RATS) reg-
ister. The RATS register sets the time window
that the demodulator will accept for the period of
valid data. Since the RATS register specifies
time windows which are negative (e.g. 1000b (8)
= +0.27
s to -4.61 s), then the modulation
frequency must be set to lower than the desired
nominal setting. For example, with RATS set to
1000 (8), and the desired nominal frequency be-
ing 38 kHz, then set the modulation divider
registers to 35.10 kHz. With these settings, the
demodulator will accept any frequency from
34.78 kHz to 41.88 kHz as valid. Smaller RATS
register settings will result in tighter tolerance on
the accepted receive modulation frequency.
Changes in the RATS register settings must be
accompanied by changes in the modulation fre-
quency register to keep the nominal desired
frequency in the center of the valid frequency
band.
There are two TV remote receive data modes:
"oversampled" mode and "programmed T pe-
riod" mode. For "oversampled" mode, first
choose the UART to CS8130 baud rate, typically
115.2 kbps. Then set the TV remote receive tim-
ing register to a rate which is less than 80% of
the UART baud rate. The CS8130 will now start
sampling the demodulated infrared data at the
TV remote receive sample rate. The stream of
samples will be assembled into characters, with a
start bit and a stop bit, and will be transmitted to
the UART via RXD at the UART baud rate. The
system software can then concatenate successive
characters and reconstruct the incoming bit
stream.
"Programmed T period" mode requires that the
bit period of the bursts of modulated carrier be
known. This period is programmed into the TV
remote receive timing registers. The UART to
CS8130 baud rate must be set to at least 20%
greater than 1/T. The CS8130 will now use the
edges of the demodulated incoming infrared data
to indicate each bit state. For continuous periods
of low or high, the CS8130 will sample the level
in the center of each incoming bit period (using
T as the bit period). Any transition will reset the
timer that is used for the sampling process,
thereby eliminating errors caused by the sample
timing being different to the incoming bit period.
Characters are assembled and sent to the UART
every 8 bits (see Figure 6).
If the T period is not known, it is possible to
measure T by using "oversampled" mode, and
1
0
1
00
1
110
0
11
0
01
1
0
1
01
1
00
1
1/2400
LIGHT
INPUT
RXD*
LIGHT
NO LIGHT
Stop
Bit
8 data bits
Start
Bit
*RXD Baud rate can be set
from 4800 to 115200 bps
Figure 6. Mode 3 (TV remote) Receive Data Format
CS8130
10
DS134PP2
CS8130
10
DS134F1
相關PDF資料 |
PDF描述 |
|---|---|
| EBM25DCSI | CONN EDGECARD 50POS DIP .156 SLD |
| ECO-S2DB222EA | CAP ALUM 2200UF 200V 20% SNAP |
| SLPX822M035E3P3 | CAP ALUM 8200UF 35V 20% SNAP |
| 4590R-824K | INDUCTOR HIGH CURRENT 820.0UH |
| UPT2D391MHD | CAP ALUM 390UF 200V 20% RADIAL |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CDB8415A | 功能描述:音頻 IC 開發工具 Eval Bd 96 kHz Dig. Audio Receiver RoHS:否 制造商:Texas Instruments 產品:Evaluation Kits 類型:Audio Amplifiers 工具用于評估:TAS5614L 工作電源電壓:12 V to 38 V |
| CDB8416 | 功能描述:音頻 IC 開發工具 Eval Bd 192 kHz Dig. Audio Receiver RoHS:否 制造商:Texas Instruments 產品:Evaluation Kits 類型:Audio Amplifiers 工具用于評估:TAS5614L 工作電源電壓:12 V to 38 V |
| CDB8420 | 功能描述:音頻 IC 開發工具 Eval Bd Digital Audio SRC RoHS:否 制造商:Texas Instruments 產品:Evaluation Kits 類型:Audio Amplifiers 工具用于評估:TAS5614L 工作電源電壓:12 V to 38 V |
| CDB8421 | 功能描述:音頻 IC 開發工具 2-Ch 32-Bit 192kHz sample rate converte RoHS:否 制造商:Texas Instruments 產品:Evaluation Kits 類型:Audio Amplifiers 工具用于評估:TAS5614L 工作電源電壓:12 V to 38 V |
| CDB8422 | 功能描述:界面開發工具 Eval Bd 192kHz SRC S/PDIF Receiver RoHS:否 制造商:Bourns 產品:Evaluation Boards 類型:RS-485 工具用于評估:ADM3485E 接口類型:RS-485 工作電源電壓:3.3 V |
發布緊急采購，3分鐘左右您將得到回復。