- 您現在的位置：買賣IC網 > PDF目錄379817 > CD43-100 (Linear Technology Corporation) Dual Micropower DC/DC Converter with Positive and Negative Outputs PDF資料下載
參數資料
| 型號： | CD43-100 |
| 廠商： | Linear Technology Corporation |
| 英文描述： | Dual Micropower DC/DC Converter with Positive and Negative Outputs |
| 中文描述： | 雙微功率DC / DC變換器的正，負輸出 |
| 文件頁數： | 4/8頁 |
| 文件大?。?/td> | 142K |
| 代理商： | CD43-100 |
4
LT1945
1945f
BLOCK DIAGRA
W
Figure 1. LT1945 Block Diagram
OPERATIOU
The LT1945 uses a constant off-time control scheme to
provide high efficiencies over a wide range of output
current. Operation can be best understood by referring to
the block diagram in Figure 1. Q1 and Q2 along with R3 and
R4 form a bandgap reference used to regulate the output
voltage. When the voltage at the NFB1 pin is slightly below
–1.23V, comparator A1 disables most of the internal
circuitry. Output current is then provided by capacitor C2,
which slowly discharges until the voltage at the NFB1 pin
goes above the hysteresis point of A1 (typical hysteresis
at the NFB1 pin is 8mV). A1 then enables the internal
circuitry, turns on power switch Q3, and the current in
inductors L1 and L2 begins ramping up. Once the switch
current reaches 350mA, comparator A2 resets the one-
shot, which turns off Q3 for 400ns. L2 continues to deliver
current to the output while Q3 is off. Q3 turns on again and
the inductor currents ramp back up to 350mA, then A2
again resets the one-shot. This switching action continues
until the output voltage is charged up (until the NFB1 pin
reaches –1.23V), then A1 turns off the internal circuitry
and the cycle repeats.
The second switching regulator is a step-up converter
(which generates a positive output) but the basic opera-
tion is the same.The LT1945 contains additional circuitry
to provide protection during start-up and under short-
circuit conditions. When the FB2 pin voltage is less than
approximately 600mV, the switch off-time is increased to
1.5
μ
s and the current limit is reduced to around 250mA
(70% of its normal value). This reduces the average
inductor current and helps minimize the power dissipation
in the power switch and in the external inductor and diode.
–
+
–
+
8
400ns
ONE-SHOT
DRIVER
RESET
RESET
ENABLE
42mV
0.12
A2
A1
Q3
9
3
R4
280k
R3
60k
R6
80k
R5
80k
Q2
X10
Q1
1
V
IN
NFB1
2
SHDN1
10
SW1
PGND
GND
1945 BD
L1
C3
C2
V
OUT1
V
IN
D1
R2
(EXTERNAL)
R1
(EXTERNAL)
V
OUT1
C1
–
+
–
+
400ns
ONE-SHOT
ENABLE
42mV
0.12
A2B
A1B
Q3B
7
R4B
140k
R3B
30k
R6B
40k
R5B
40k
Q2B
X10
Q1B
5
V
IN
FB2
4
SHDN2
6
SW2
PGND
L3
L2
C4
V
OUT2
V
IN
D2
R2B
(EXTERNAL)
R1B
(EXTERNAL)
V
OUT2
SWITCHER 1
SWITCHER 2
DRIVER
相關PDF資料 |
PDF描述 |
|---|---|
| CD43-4R7 | Dual Micropower DC/DC Converter with Positive and Negative Outputs |
| CDRH4D18-100 | Dual Micropower DC/DC Converter with Positive and Negative Outputs |
| CDRH4D18-4R7 | Dual Micropower DC/DC Converter with Positive and Negative Outputs |
| CD43-470 | 1.0MHz Inverting DC/DC Converter |
| CD43NP-4R7MB | CD43 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CD431040 | 制造商:n/a 功能描述:Power Module |
| CD431060 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:THYRISTOR MODULE|SCR DOUBLER|1KV V(RRM)|80A I(T) |
| CD431090 | 制造商:n/a 功能描述:Power Module |
| CD431090B | 功能描述:SCR MOD ISO DUAL 1000V 90A RoHS:是 類別:半導體模塊 >> SCR 系列:- 其它有關文件:SCR Module Selection Guide 標準包裝:10 系列:- 結構:串聯 - SCR/二極管 SCR 數目，二極管:1 SCR，1 個二極管 電壓 - 斷路:1600V 電流 - 柵極觸發電流 (Igt)（最大）:150mA 電流 - 導通狀態 (It (AV))（最大）:95A 電流 - 導通狀態 (It (RMS))（最大）:210A 電流 - 非重復電涌，50、60Hz (Itsm):1785A，1870A 電流 - 維持(Ih):250mA 安裝類型:底座安裝 封裝/外殼:ADD-A-PAK（3 + 2） 包裝:散裝 其它名稱:*IRKL92/16AIRKL92/16IRKL92/16-ND |
| CD431090C | 制造商:Powerex Power Semiconductors 功能描述:SCR MOD ISO DUAL 90A 1000V 制造商:Powerex Power Semiconductors 功能描述:SCR, MOD, 90A, 1KV, POW-R-BLOK; No. of Phases:Single; Repetitive Reverse Voltage Vrrm Max:1kV; Forward Current If(AV):90A; Forward Voltage VF Max:1.9V; Diode Module Configuration:Dual ;RoHS Compliant: Yes |
發布緊急采購，3分鐘左右您將得到回復。