- 您現在的位置：買賣IC網 > PDF目錄379718 > C3704 (Hamamatsu Photonics) UV TRON DRIVING CIRCUIT PDF資料下載
參數資料
| 型號： | C3704 |
| 廠商： | Hamamatsu Photonics |
| 英文描述： | UV TRON DRIVING CIRCUIT |
| 中文描述： | 紫外線TRON的驅動電路 |
| 文件頁數： | 2/2頁 |
| 文件大?。?/td> | 34K |
| 代理商： | C3704 |
UV TRON
DRIVING CIRCUIT C3704 SERIES
Figure 2: Schematic Diagram
HAMAMATSU PHOTONICS K.K., Electron Tube Center
314-5, Shimokanzo, Toyooka-village, Iwata-gun, Shizuoka-ken, 438-0193, Japan, Telephone: (81)539/62-5248, Fax: (81)539/62-2205, Telex: 4225-186HAMAHQ
U.S.A.: Hamamatsu Corporation: 360 Foothill Road, Bridgewater, N.J. 08807-0910, U.S.A., Telephone: (1)908-231-0960, Fax: (1)908-231-1218
Germany: Hamamatsu Photonics Deutschland GmbH: Arzbergerstr. 10, D-82211 Herrsching am Ammersee, Germany, Telephone: (49)8152-375-0, Fax: (49)8152-2658
France: Hamamatsu Photonics France S.A.R.L.: 8, Rue du Saule Trapu, Parc du Moulin de Massy, 91882 Massy Cedex, France, Telephone: (33)1 69 53 71 00, Fax: (33)1 69 53 71 10
United Kingdom: Hamamatsu Photonics UK Limited: Lough Point, 2 Gladbeck Way, Windmill Hill, Enfield, Middlesex EN2 7JA, United Kingdom, Telephone: (44)181-367-3560, Fax: (44)181-367-6384
North Europe: Hamamatsu Photonics Norden AB: Frgatan 7, S-164-40 Kista, Sweden, Telephone: (46)8-703-29-50, Fax: (46)8-750-58-95
Italy: Hamamatsu Photonics Italia S.R.L.: Via Della Moia, 1/E 20020 Arese, (Milano), Italy, Telephone: (39)2-935 81 733, Fax: (39)2-935 81 741
(Note 3)
POWER SUPPLY INPUT AND SIGNAL OUTPUT POINT
–
: GND
+
: POWER SUPPLY INPUT
1 : SIGNAL OUTPUT Q
2 : SIGNAL OUTPUT Q
3 : OPEN COLLECTOR OUTPUT
PRECAUTIONS FOR USE
G
Since the operation impedance is extremely high, the UV TRON should be connected as close as possible to the circuit
board within 5 cm.
G
Take care to avoid external noise since a C-MOS IC is used in the circuit. It is recommended that the whole PC board be put
in the shield box when it is used.
G
To reduce current consumption, oscillating frequency is very low (approx. 20 Hz) in this DC-DC converter. Thus, the output
impedance of the high voltage power supply is extremely high. If the surrounding humidity is high, electrical leakage on the
PC board surface may lead to a drop in the supply voltage to the UV TRON. This voltage drop may result in lowered detec-
tion performance, so a moistureproof material (silicone compound, etc.) should be applied at the connecting point of the
UV TRON, etc., if using the unit in a humid environment.
G
A model equipped with a flame sensor (R2868) is also available.
Figure 3: Method of Connection
TPT C0004EA
Note 3: No load can be driven by an output from points “1” and “2” because these signals are
output from the only C-MOS IC directly. When a load such as a buzzer and a relay is
connected to this circuit, it should be connected to the point open collector output. The
transistor ratings of the open collector is 50V, 100mA. Be careful not to exceed the ratings.
Note 4: The output pulse width is set to 10ms at shipping. If the pulse width needs to be
extended, add a capacitor to this point. (When using an electrolytic condenser, make
sure the polarity is correct.)
e.g. CX = 1
μ
F: Pulse Width 1s, CX=10
μ
F : Pulse Width 10s
L
L
Cx : POINT FOR ADDING A CAPACITOR TO
EXTEND OUTPUT PULSE WIDTH
(Note 4)
CONNECTING POINT OF UV TRON
A : Connecting Anode of UV TRON
K : Connecting Cathode of UV TRON
L
JUMPER LEAD FOR SETTING
BACKGROUND CANCEL LEVEL
L
This background cancel circuit outputs signal pulses
of 10ms width only when 3 to 9 pulses enter the
circuit with a time interval of 2 seconds or less from
the UV TRON. Cancel level can be set in 4 steps
(number of pulses: 3, 5, 7, 9) by this jumper lead.
Connect to “3” for general use. When using where
much natural excitation light is present, set the
cancel level at a higher step (5, 7, 9).
TPT1007E01
JUL.1997 CR
Created in Japan
UV TRON
(SOLD SEPARATELY)
ANODE
K
A
CATHODE
POWER SUPPLY
+
–
GND
CONSTANT *
VOLTAGE
CIRCUIT
HIGH VOLTAGE
DC-DC
CONVERTER
JUMPER LEAD FOR SETTING
BACKGROUND CANCEL LEVEL
* Not included in C3704-02.
OPEN COLLECTOR
OUTPUT (3)
Q (1)
Q (2)
10 ms
(Note 4)
GND
GND
5V
5V
Q
Q
OUTPUT SIGNAL
WAVEFORM
7
SIGNAL
PROCESSING
CIRCUIT
3
5
9
+350Vdc
Tr : 50
100mA
+5Vdc
相關PDF資料 |
PDF描述 |
|---|---|
| C3757-02 | Low noise amplifier for InGaAs, PbS, PbSe and MCT detector |
| C3830 | RTD Series - Econoline Unregulated DC-DC Converters; Input Voltage (Vdc): 15V; Output Voltage (Vdc): 05V; Power: 2W; Assembly; High Power Density; Optional Continuous Short Circuit Protected; Efficiency to 85% |
| C3866 | COMPACT BENCH-TOP TYPE |
| C397 | Single General Purpose Voltage Comparator |
| C3ENPA1-DD | C-3e NETWORK PROCESSOR SILICON REVISION A1 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| C3709/10 100 | 制造商:3M Electronic Products Division 功能描述:FLAT CBL 10CONDS 28AWG 30.48M/91.44M SOLID TINNED CPR GRAY 3 - Cable Rools/Shrink Tubing |
| C3709/14 100 | 制造商:3M Electronic Products Division 功能描述:FLAT CBL 14CONDS 28AWG 30.48M/91.44M SOLID TINNED CPR GRAY 3 - Cable Rools/Shrink Tubing |
| C3709/15 100 | 制造商:3M Electronic Products Division 功能描述:FLAT CBL 15CONDS 28AWG 30.48M/91.44M SOLID TINNED CPR GRAY 3 - Cable Rools/Shrink Tubing |
| C3709/16 100 | 制造商:3M Electronic Products Division 功能描述:FLAT CBL 16CONDS 28AWG 30.48M/91.44M SOLID TINNED CPR GRAY 3 - Cable Rools/Shrink Tubing |
| C3709/16 300 | 功能描述:CABLE 16 COND .050" FLAT GRAY RoHS:是 類別:線纜，導線 >> 扁平帶 系列:3709 標準包裝:1 系列:Nevalo 纜線類型:扁平纜線 導線數:4 間距:0.098"（2.50mm） 長度:100' (30.5m) 線規:24 AWG 線束:- 屏蔽:無屏蔽 顏色:藍 套管類型:聚氯乙烯（PVC） 額定電壓:- 工作溫度:- 其它名稱:A101466-100 |
發布緊急采購，3分鐘左右您將得到回復。