參數資料
        型號: BU-61745G3-680
        廠商: DATA DEVICE CORP
        元件分類: 微控制器/微處理器
        英文描述: 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CQFP72
        封裝: 25.40 X 25.40 MM, 3.94 MM HEIGHT, CERAMIC, FP-72
        文件頁數: 32/60頁
        文件大?。?/td> 700K
        代理商: BU-61745G3-680
        38
        Data Device Corporation
        www.ddc-web.com
        BU-6174X/6184X/6186X
        Rev. C
        CLOCK IN
        t1
        t6
        t7
        t2
        t3
        t18
        t16
        VALID
        t8
        t9
        t14
        t15
        t17
        VALID
        t12
        t10
        t4
        t11
        t5
        VALID
        t13
        SELECT
        (Note 2,7)
        (Note 2)
        (Note 3,4,7)
        (Note 4,5)
        STRBD
        MEM/REG
        RD/WR
        IOEN
        (Note 2,6)
        (Note 6)
        (Note 9,10)
        (Note 7,8,9,10)
        READYD
        A15-A0
        D15-D0
        FIGURE 14. CPU WRITING RAM / REGISTER (16-BIT BUFFERED, NONZERO WAIT)
        NOTES:
        1.
        For the 16-bit buffered nonzero wait configuration TRANSPARENT/BUFFERED must be connected to logic "0", ZERO_WAIT and DTREG / 16/8
        must be connected to logic "1". The inputs TRIGGER_SEL and MSB/LSB may be connected to either +5V or ground.
        2.
        SELECT and STRBD may be tied together. IOEN goes low on the first rising CLK edge when SELECT STRBD is sampled low (satisfying t1)
        and the Enhanced Mini-ACE's protocol/memory management logic is not accessing the internal RAM. When this occurs, IOEN goes low, start-
        ing the transfer cycle. After IOEN goes low, SELECT may be released high.
        3.
        MEM/REG must be presented high for memory access, low for register access.
        4.
        MEM/REG and RD/WR are buffered transparently until the first falling edge of CLK after IOEN goes low. After this CLK edge, MEM/REG and
        RD/WR become latched internally.
        5.
        The logic sense for RD/WR in the diagram assumes that POLARITY_SEL is connected to logic "1." If POLARITY_SEL is connected to logic "0,"
        RD/WR must be asserted high to write.
        6.
        The timing for the IOEN and READYD outputs assumes a 50 pf load. For loading above 50 pf, the validity of IOEN and READYD is delayed by
        an additional 0.14 ns/pf typ, 0.28 ns/pf max.
        7.
        The timing for A15-A0, MEM/REG, and SELECT assumes that ADDR-LAT is connected to logic "1." Refer to Address Latch timing for additional
        details.
        9.
        The address bus A15-A0 and data bus D15-D0 are internally buffered transparently until the first rising edge of CLK after IOEN goes low. After
        this CLK edge, A15-A0 and D15-D0 become latched internally.
        10
        Setup time given for use in worst case timing calculations. None of the Enhanced Mini-ACE input signals are required to be synchronized to the
        system clock. When SELECT and STRBD do not meet the setup time of t1, but occur during the setup time of an internal flip-flop, an additional
        clock cycle may be inserted between the falling clock edge that latches MEM/REG and RD/WR and the rising clock edge that latches the address
        (A15-A0) and data (D15-D0). When this occurs, the delay from IOEN falling to READYD falling (t14) increases by one clock cycle and the address
        and data hold time (t12 and t13) must be increased by one clock.
        相關PDF資料
        PDF描述
        BU-61745G3-860L 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CQFP72
        BU-61745G3-872K 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CQFP72
        BU-61745G3-882W 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CQFP72
        BU-61745G4-650Y 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CQFP72
        BU-61843F3-280W 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CQFP72
        相關代理商/技術參數
        參數描述
        BU-61745G4-100 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Telecommunication IC
        BU-61745G4-110 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Telecommunication IC
        BU61800GWL-E2 制造商:ROHM Semiconductor 功能描述:
        BU-61840B3NEW 制造商:未知廠家 制造商全稱:未知廠家 功能描述:MIL-STD-1553 Components |μ-ACE (Micro-ACE?)
        BU-61843 制造商:未知廠家 制造商全稱:未知廠家 功能描述:MIL-STD-1553 Components |Enhanced Mini-ACE?