• <pre id="kd7ee"><small id="kd7ee"><ins id="kd7ee"></ins></small></pre><nobr id="kd7ee"><sub id="kd7ee"><center id="kd7ee"></center></sub></nobr>
    • 參數資料
      型號: BU-61580V1-520Y
      廠商: DATA DEVICE CORP
      元件分類: 微控制器/微處理器
      英文描述: 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CDFP70
      封裝: 48.30 X 25.40 MM, 3.81 MM HEIGHT, FP-70
      文件頁數: 28/44頁
      文件大?。?/td> 563K
      代理商: BU-61580V1-520Y
      34
      Data Device Corporation
      www.ddc-web.com
      BU-65170/61580/61585
      H1 web-09/02-0
      TRANSFORMERS
      In selecting isolation transformers to be used with the X3, X6
      ACE, there is a limitation on the maximum amount of leakage
      inductance. If this limit is exceeded, the transmitter rise and fall
      times may increase, possibly causing the bus amplitude to fall
      below the minimum level required by MIL-STD-1553. In addition,
      an excessive leakage imbalance may result in a transformer
      dynamic offset that exceeds 1553 specifications.
      The maximum allowable leakage inductance is 6.0 H, and
      is measured as follows:
      The side of the transformer that connects to the ACE is defined
      as the “primary” winding. If one side of the primary is shorted to
      the primary center-tap, the inductance should be measured
      across the “secondary” (stub side) winding. This inductance
      must be less than 6.0 H. Similarly, if the other side of the pri-
      mary is shorted to the primary center-tap, the inductance mea-
      sured across the “secondary” (stub side) winding must also be
      less than 6.0 H.
      The difference between these two measurements is the
      “differential” leakage inductance. This value must be less than
      1.0 H.
      Beta Transformer Technology Corporation (BTTC), a subsidiary
      of DDC, manufactures transformers in a variety of mechanical
      configurations with the required turns ratios of 1:2.5 direct cou-
      pled, and 1:1.79 transformer coupled. TABLE 32 provides a list-
      ing of many of these transformers.For further information, con-
      tact BTTC at 631-244-7393 or at www.bttc-beta.com.
      DLP-7014
      SLP-8007
      SLP-8024
      NOT RECOMMENDED
      LPB-5015
      B-3310
      HLP-6015
      Dual epoxy transformer, side by side, surface mount, 0.930" X 0.630", 0.155" max height
      DLP-7115 (see note 2)
      Dual epoxy transformer, side by side, surface mount, 1.410" X 0.750", 0.130" max height
      Single metal transformer, hermetically sealed, surface mount, 0.630" X 0.630", 0.175" max height
      B-3261
      HLP-6014
      Dual epoxy transformer, side by side, flat pack, 0.930" X 0.630", 0.155" max height
      Single metal transformer, hermetically sealed, flat pack, 0.630" X 0.630", 0.175" max height
      B-3300
      Dual epoxy transformer, side by side, through-hole, 0.930" X 0.630", 0.155" max height
      TST-9027
      Dual epoxy transformer, twin stacked, flat pack, 0.625" X 0.625", 0.280" max height
      TST-9017
      Dual epoxy transformer, twin stacked, surface mount, 0.625" X 0.625", 0.280" max height
      TST-9007
      Dual epoxy transformer, twin stacked, 0.625" X 0.625", 0.280" max height
      B-3819
      LPB-5014
      Single epoxy transformer, surface mount, hi-temp solder, 0.625" X 0.625", 0.220" max height. May
      be used with BU-6XXXXX4 versions of the Enhanced Mini-ACE.B-3819
      Single epoxy transformer, flat pack, 0.625" X 0.625", 0.150" max height
      B-3227
      Single epoxy transformer, surface mount, 0.625" X 0.625", 0.275" max height
      B-3231
      Single epoxy transformer, flat pack, 0.625" X 0.625", 0.275" max height
      B-3818
      B-3067
      B-3226
      Single epoxy transformer, through-hole, 0.625" X 0.625", 0.220" max height.
      May be used with BU-6XXXXX4 versions of the Enhanced Mini-ACE.
      Single epoxy transformer, through-hole, 0.625" X 0.625", 0.250" max height
      BTTC PART NO.
      TRANSFORMER CONFIGURATION
      Single epoxy transformer, surface mount, 0.625" X 0.625", 0.150" max height
      B-3229
      Single epoxy transformer, through hole, transformer coupled only, 0.500" X 0.350", 0.250" max height
      TABLE 32. BTTC TRANSFORMERS FOR USE WITH X3, X6 ACE
      Notes:
      1. For the BU-6XXXXX3/6 versions of the ACE with -1553B transceivers, any of the transformers listed in the table may be used.
      2. DLP-7115 operates to +105°C max. All other transformers listed operate to +130°C max.
      相關PDF資料
      PDF描述
      BU-61580V2-100Q 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CDFP70
      BU-61580V2-410Q 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CDFP70
      BU-61580V2-460K 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CDFP70
      BU-61580V3-190Q 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CDFP70
      BU-61580V3-222Q 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CDFP70
      相關代理商/技術參數
      參數描述
      BU-61580V2-100 制造商:未知廠家 制造商全稱:未知廠家 功能描述:MIL-STD-1553/ARINC Bus Controller/RTU
      BU-61580V2-110 制造商:未知廠家 制造商全稱:未知廠家 功能描述:MIL-STD-1553/ARINC Bus Controller/RTU
      BU-61580V2-120 制造商:未知廠家 制造商全稱:未知廠家 功能描述:MIL-STD-1553/ARINC Bus Controller/RTU
      BU-61580V2-200 制造商:未知廠家 制造商全稱:未知廠家 功能描述:MIL-STD-1553/ARINC Bus Controller/RTU
      BU-61580V2-300 制造商:未知廠家 制造商全稱:未知廠家 功能描述:MIL-STD-1553/ARINC Bus Controller/RTU