- 您現在的位置：買賣IC網 > PDF目錄384151 > BP5234-33A (Rohm CO.,LTD.) DC / DC converter PDF資料下載
參數資料
| 型號： | BP5234-33A |
| 廠商： | Rohm CO.,LTD. |
| 英文描述： | DC / DC converter |
| 中文描述： | 直流/直流轉換器 |
| 文件頁數： | 6/8頁 |
| 文件大?。?/td> | 126K |
| 代理商： | BP5234-33A |
BP5232-25A / BP5232-33A / BP5233-33A / BP5234-33A
Power Module
!
Operation notes
(1) The output current should be reduced according to an increase in the input voltage or ambient temperature. Use the
module within the derating curve range.
(2) In case that the output is controlled by switching on and off utilizing pin 7 or in case that the input voltage is applied, a
large inrush electrical current may flow. Be minded to use within the allowable operating range. This allowable
operating range is specified by the safety operating range of the switching transistor in the module. The amount of the
inrush current varies depending on the output impedance of the input electrical power or the capacity value of the
capacitor to be connected to the output.
(3) Protection circuit for output current is incorporated. In case that the output is short-circuited, the output will be latched
by switching off. The protection circuit can be cancelled by making CTL terminal active state (CTL=HIGH), after once
making it standby state (CTL=LOW), or by resupplying the power. However, in case that the protection circuit is
cancelled by resupplying the power source, it may not be cancelled even by resupplying the power source in the state
that the electrical charge is remained in CIN (the state that voltage is remained in VIN) even after the power source is
switched off.
(4) The leading time of the input voltage should be made within 5ms. There may be a case that the protection circuit is
activated.
(5) I / O smoothing capacitors should be connected between I / O and GND terminals.
(6) Normally, use by short-circuiting pins 1, 2, 3, pins 4, 5, 6, and pins 9, 10, 11 (BP5232-25A) respectively.
(7) A large ripple current flows to the input smoothing capacitor due to the output load. Be minded to use within the
allowable ripple current of the capacitor.
(8) The capacitor with a particularly low impedance is used as the output smoothing capacitor C2 so as to suppress the
output ripple voltage. Select the capacitor according to the purpose of use in each case.
!
Electrical characteristic curves
BP5232-25A
0
50
1
2
3
4
5
O
O
AMBIENT TEMPERATURE : Ta (C)
100
Fig.6 Derating cureve
100
80
90
60
70
40
50
20
30
10
0
0.5
1.0
1.5
2.0
OUTPUT CURRENT : I
O
(A)
Fig.7 Conversion efficiency
C
η
(
V
IN
=4.0V
V
IN
=6.0V
V
IN
=5.0V
Fig.8 Safe operation range
0.1
0.5
1
O
VOLTTO OUTPUT PIN (V)
10
20
50
2
5
1
5
7
T
C
=25
C
Single Pulse
P
W
=10m
P
W
=1ms
P
W
=100m
相關PDF資料 |
PDF描述 |
|---|---|
| BP5232A33 | DIODE ZENER 200MW 13V 1005 |
| BP5326 | DC/DC converter step-up |
| BP5801 | High efficiency switching-type motor driver |
| BP5812 | 0 to 13V/300mA output type |
| BPNGA | Quad Differential Drivers(四差分驅動器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| BP5234A33 | 功能描述:DC/DC 開關控制器 HIC HI-CURR OUT DC CNVRT 3.3V 4A RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
| BP5250 | 功能描述:電壓監測器/監控器 DC/DC 12V RoHS:否 制造商:Texas Instruments 監測電壓數:2 監測電壓:Adjustable 輸出類型:Open Drain 欠電壓閾值: 過電壓閾值: 準確性:1 % 工作電源電壓:1.5 V to 6.5 V 工作電源電流:1.8 uA 最大工作溫度:+ 125 C 封裝 / 箱體:SON-6 安裝風格:SMD/SMT |
| BP5250-24 | 功能描述:電壓監測器/監控器 DC/DC 24V RoHS:否 制造商:Texas Instruments 監測電壓數:2 監測電壓:Adjustable 輸出類型:Open Drain 欠電壓閾值: 過電壓閾值: 準確性:1 % 工作電源電壓:1.5 V to 6.5 V 工作電源電流:1.8 uA 最大工作溫度:+ 125 C 封裝 / 箱體:SON-6 安裝風格:SMD/SMT |
| BP5255BR00SP | 制造商:POWGG 功能描述: |
| BP5275-18 | 功能描述:直流/直流開關轉換器 3Term Step Dwn DC/DC Cnvrtr Non-Iso 1.8V RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
發布緊急采購，3分鐘左右您將得到回復。