- 您現在的位置：買賣IC網 > PDF目錄385107 > BA00Sxx (Rohm CO.,LTD.) Regulator, low drop-out type with ON/OFF switch PDF資料下載
參數資料
| 型號： | BA00Sxx |
| 廠商： | Rohm CO.,LTD. |
| 英文描述： | Regulator, low drop-out type with ON/OFF switch |
| 中文描述： | 穩壓器，低壓降與在類型/ OFF開關 |
| 文件頁數： | 8/10頁 |
| 文件大?。?/td> | 119K |
| 代理商： | BA00SXX |
BA
ΟΟ
ST / BA
ΟΟ
SFP series
Regulator ICs
!
Operation notes
(1) Operating power supply voltage
When operating within the normal voltage range and within the ambient operating temperature range, most circuit
functions are guaranteed. The rated values cannot be guaranteed for the electrical characteristics, but there are no
sudden changes of the characteristics within these ranges.
(2) Power dissipation
Heat attenuation characteristics are noted on a separate page and can be used as a guide in judging power dissipation.
If these ICs are used in such a way that the allowable power dissipation level is exceeded, an increase in the chip
temperature could cause a reduction in the current capability or could otherwise adversely affect the performance of the
IC. Make sure a sufficient margin is allowed so that the allowable power dissipation value is not exceeded.
(3) Output oscillation prevention and bypass capacitor
Be sure to connect a capacitor between the output pin and GND to prevent oscillation. Since fluctuations in the valve of
the capacitor due to temperature changes may cause oscillations, a tantalum electrolytic capacitor with a small internal
series resistance (ESR) is recommended.
A 22m F capacitor is recommended; however, be aware that if an extremely large capacitance is used (1000
μ
F or
greater), then oscillations may occur at low frequencies. Therefore, be sure to perform the appropriate verifications before
selecting the capacitor.
Also, we recommend connecting a 0.33m F bypass capacitor as close as possible between the input pin and GND.
(4) Current overload protection circuit
A current overload protection circuit is built into the outputs, to prevent IC destruction if the load is shorted.
This protection circuit limits the current in the shape of a ‘7’. It is designed with a high margin, so that even if a large current
suddenly flows through the large capacitor in the IC, the current is restricted and latching is prevented.
However, these protection circuits are only good for pre-venting damage from sudden accidents. The design should take
this into consideration, so that the protection circuit is not made to operate continuously (for instance, clamping at an
output of 1V
F
or greater; below 1V
F
, the short mode circuit operates). Note that the capacitor has negative temperature
characteristics, and the design should take this into consideration.
(5) Thermal overload circuit
A built-in thermal overload circuit prevents damage from overheating. When the thermal circuit is activated, the various
outputs are in the OFF state. When the temperature drops back to a constant level, the circuit is restored.
(6) Internal circuits could be damaged if there are modes in which the electric potential of the application’s input (V
CC
) and
GND are the opposite of the electric potential of the various outputs. Use of a diode or other such bypass path is
recommended.
(7) Although the manufacture of this product includes rigorous quality assurance procedures, the product may be
damaged if absolute maximum ratings for voltage or operating temperature are exceeded. If damage has occurred,
special modes (such as short circuit mode or open circuit mode) cannot be specified. If it is possible that such special
modes may be needed, please consider using a fuse or some other mechanical safety measure.
(8) When used within a strong magnetic field, be aware that there is a slight possibility of malfunction.
相關PDF資料 |
PDF描述 |
|---|---|
| BA028LBSG | Super-mini package regulator IC |
| BA10324 | Quad ground sense operational |
| BA10324A | Quad ground sense operational |
| BA10324AF | Quad ground sense operational |
| BA10324AFV | Quad ground sense operational |
相關代理商/技術參數 |
參數描述 |
|---|---|
| BA-0110 | 功能描述:CONN F W/CRIMP RING RG-59 RoHS:是 類別:連接器，互連式 >> 同軸，RF 系列:F型 標準包裝:1 系列:OS-50 連接器類型:2.4mm（APC-2.4，OS-50） 連接器類型:插孔，母插口 觸點終端:壓接及焊料 阻抗:- 安裝類型:自由懸掛 緊固型:有螺紋 纜線組:IW 1501 頻率 - 最大:- 特點:- 顏色:- 包裝:散裝 其它名稱:744-1391 |
| BA-01132-00306 | 制造商: 功能描述: 制造商:undefined 功能描述: |
| BA01202 | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:GaAs HBT HYBRID IC(N-CDMA hand set) |
| BA01203 | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:GaAs HBT HYBRID IC(CDMA/AMPS handheld-phone) |
| BA01207 | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:GaAs HBT HYBRID IC |
發布緊急采購，3分鐘左右您將得到回復。