- 您現在的位置：買賣IC網 > PDF目錄382861 > AX88796 (Electronic Theatre Controls, Inc.) 3-in-1 Local Bus Fast Ethernet Controller PDF資料下載
參數資料
| 型號： | AX88796 |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | 3-in-1 Local Bus Fast Ethernet Controller |
| 中文描述： | 3合1本地總線快速以太網控制器 |
| 文件頁數： | 41/71頁 |
| 文件大?。?/td> | 931K |
| 代理商： | AX88796 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁當前第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁
ASIX ELECTRONICS CORPORATION
41
AX88796 L 3-in-1 Local Bus Fast Ethernet Controller
5.2.1 MR0 -- Control Register Bit Descriptions
FIELD
TYPE
0.15 (SW_RESET)
R/W
DESCRIPTION
Reset.
Setting this bit to a 1 will reset the PHY. All registers will be set to
their default state. This bit is self-clearing. The default is 0.
Loopback.
When this bit is set to 1, no data transmission will take place on
the media. Any receive data will be ignored. The loopback signal path will
contain all circuitry up to, but not including, the PMD. The default value is
a 0.
Speed Selection.
The value of this bit reflects the current speed of operation
(1 = 100Mbits/s; 0 = 10Mbits/s). This bit will only affect operating speed
when the autonegotiation enable bit (register 0, bit 12) is disabled (0). This
bit is ignored when autonegotiation is enabled (register 0, bit 12). This bit is
ANDed with the SPEED_PIN signal.
Autonegotiation Enable.
The autonegotiation process will be enabled by
set-ting this bit to a 1. The default state is a 1.
Powerdown.
The PHY may be placed in a low-power state by setting this bit
to a 1, both the 10Mbits/s transceiver and the 100Mbits/s transceiver will be
powered down. While in the power down state, the PHY will respond to
management transactions. The default state is a 0.
Isolate.
When this bit is set to a 1, the MII outputs will be brought to the
high-impedance state. The default state is a 0.
Restart Autonegotiation.
Normally, the autonegotiation process is started
at powerup. The process may be restarted by setting this bit to a 1. The
default state is a 0. The NWAYDONE bit (register 1, bit 5) is reset when this
bit goes to a 1. This bit is self-cleared when autonegotiation restarts.
Duplex Mode.
This bit reflects the mode of operation (1 = full duplex; 0 =
half duplex). This bit is ignored when the autonegotiation enable bit
(register 0, bit 12) is enabled. The default state is a 0. This bit is ORed with
the F_DUP pin.
Collision Test.
When this bit is set to a 1, the PHY will assert the MCOL
signal in response to MTX_EN.
Reserved.
All bits will read 0.
0.14 (LOOPBACK)
R/W
0.13(SPEED100)
R/W
0.12 (NWAY_ENA)
R/W
0.11 (PWRDN)
R/W
0.10 (ISOLATE)
R/W
0.9 (REDONWAY)
R/W
0.8 (FULL_DUP)
R/W
0.7 (COLTST)
R/W
0.6:0 (RESERVED)
NA
相關PDF資料 |
PDF描述 |
|---|---|
| AX88796L | 3-in-1 Local Bus Fast Ethernet Controller |
| AY3-8910 | PROGRAMMABLE SOUND GENERATOR |
| AY-3-8910 | PROGRAMMABLE SOUND GENERATOR |
| AY-3-8912 | PROGRAMMABLE SOUND GENERATOR |
| AY-3-8913 | PROGRAMMABLE SOUND GENERATOR |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AX88796ALF | 制造商:ASIX 功能描述:10/100 MAC,COMMERCIAL 128PIN |
| AX88796BLF | 制造商:Asix Electronics 功能描述:IEEE802.3 / IEEE802.3u LAN standard Ethernet 3.3V 64LQFP Tray 制造商:ASIX 功能描述:10/100 MAC,COMMERCIAL 64PIN |
| AX88796BLI | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:High-Performance Non-PCI Single-Chip 8/16 bit 10/100M Fast Ethernet Controller |
| AX88796C | 制造商:ASIX 制造商全稱:ASIX 功能描述:Low-Power SPI or Non-PCI Ethernet Controller |
| AX88796CLF | 制造商:ASIX Electronics Corporation 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。