<pre id="mm2xh"></pre>
  • <thead id="mm2xh"><fieldset id="mm2xh"></fieldset></thead>
  • <label id="mm2xh"></label>
    <wbr id="mm2xh"><tt id="mm2xh"></tt></wbr>
    參數資料
    型號: ATT3020-190H68I
    廠商: Electronic Theatre Controls, Inc.
    元件分類: FPGA
    英文描述: Field-Programmable Gate Arrays
    中文描述: 現場可編程門陣列
    文件頁數: 22/80頁
    文件大?。?/td> 528K
    代理商: ATT3020-190H68I
    Data Sheet
    February 1997
    ATT3000 Series Field-Programmable Gate Arrays
    22
    Lucent Technologies Inc.
    Configuration Modes
    Master Mode
    In master mode, the FPGA automatically loads configu-
    ration data from an external memory device. There are
    three master modes which use the internal timing
    source to supply the configuration clock (CCLK) to time
    the incoming data. Serial master mode uses serial con-
    figuration data supplied to data-in (DIN) from a syn-
    chronous serial source such as the serial configuration
    PROM shown in Figure 21. Parallel master low and
    master high modes automatically use parallel data sup-
    plied to the D[7:0] pins in response to the 16-bit
    address generated by the FPGA. Figure 22 shows an
    example of the parallel master mode connections
    required. The FPGA HEX starting address is 0000 and
    increments for master low mode, and it is FFFF and
    decrements for master high mode. These two modes
    provide address compatibility with microprocessors
    which begin execution from opposite ends of memory.
    For master high or low, data bytes are read in parallel
    by each read clock (
    RCLK
    ) and internally serialized by
    the configuration clock. As each data byte is read, the
    least significant bit of the next byte, D0, becomes the
    next bit in the internal serial configuration word. One
    master mode FPGA can be used to interface the
    configuration program-store, and pass additional
    concatenated configuration data to additional FPGAs in
    a serial daisy-chain fashion. CCLK is provided for the
    slaved devices, and their serialized data is supplied
    from DOUT to DIN, DOUT to DIN, etc.
    Note: The serial configuration PROM supports automatic loading of configuration programs up to 36/64/128 Kbits. Multiple devices can be
    cascaded to support additional FPGAs. An early DONE inhibits the data output one CCLK cycle before the FPGA I/O becomes active.
    Figure 21. Master Serial Mode
    5-3112(C)
    DURING CONFIGURATION
    THE 5 k
    M2 PULL-DOWN
    RESISTOR OVERCOMES THE
    INTERNAL PULL-UP,
    BUT IT ALLOWS M2 TO
    BE USER I/O.
    M0
    M1
    PWRDWN
    +5 V
    DOUT
    M2
    HDC
    LDC
    OTHER
    I/O PINS
    ATT3000
    SERIES
    FPGA
    GENERAL-
    PURPOSE
    USER I/O
    PINS
    *
    *
    RESET
    SYSTEM RESET
    D/P
    INIT
    CCLK
    DIN
    CE
    OE/RESET
    CLK
    DATA
    ATT1700A
    CEO
    (HIGH RESETS THE ADDRESS POINTER)
    CASCADED
    ATT1700A
    MEMORY
    OPTIONAL
    IDENTICAL SLAVE
    FPGAs CONFIGURED
    THE SAME
    CE
    OE/RESET
    CLK
    DATA
    相關PDF資料
    PDF描述
    ATT3020-190H84I Field-Programmable Gate Arrays
    ATT3020-190J132I Field-Programmable Gate Arrays
    ATT3020-190J44I Field-Programmable Gate Arrays
    ATT3020-190J68I Field-Programmable Gate Arrays
    ATT3020-190J84I Field-Programmable Gate Arrays
    相關代理商/技術參數
    參數描述
    ATT3020-190H84I 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Field-Programmable Gate Arrays
    ATT3020-190J132I 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Field-Programmable Gate Arrays
    ATT3020-190J44I 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Field-Programmable Gate Arrays
    ATT3020-190J68I 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Field-Programmable Gate Arrays
    ATT3020-190J84I 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Field-Programmable Gate Arrays