參數資料
型號: ATS635LSETN-T
廠商: Allegro MicroSystems, Inc.
英文描述: Programmable Back Biased Hall-Effect Switch with TPOS Functionality
中文描述: 可編程回到偏霍爾效應的聚烯烴功能開關
文件頁數: 10/15頁
文件大?。?/td> 814K
代理商: ATS635LSETN-T
ATS635LSE and ATS636LSE
PROGRAMMABLE TRUE POWER-ON HALL-EFFECT GEAR-TOOTH SWITCHES
115 Northeast Cutoff, Box 15036
Worcester, Massachusetts 01615-0036 (508) 853-5000
Copyright 200
5
Allegro MicroSystems, Inc.
FUNCTIONAL DESCRIPTION (CONT.): TYPICAL APPLICATION CIRCUIT
Applications.
It is
strongly recommended
that an external ceramic bypass capacitor in the range of 0.01 μF to 0.1 μF be
connected between the supply and ground of the device to reduce both external noise and noise generated by the
chopper-stabilization technique. (The diagram below shows a 0.1 μF bypass capacitor.)
The series resistor R
S
in combination with the bypass capacitor creates a filter for EMC pulses. The series resistor will
have a drop of approximately 800 mV, this must be considered for the minimum V
CC
requirement of the ATS635LSE /
ATS636LSE. The small capacitor on the output of the device improves the EMC performance of the device.
The pull-up resistor should be chosen to limit the current through the output transistor; do not exceed the maximum
continuous output current of the device.
Note: This circuit cannot be used to program the device, as the series resistance is too large, and a minimum capacitance
of 0.1 μF must be connected from V
CC
to GND of the SIP to provide the current necessary to blow the fuse.
Typical Application:
1.2k Ohm
V
Supply
VCC
1
R
L
100 Ohm
2
4
GND
R
S
0.1 μF
5V
VOUT
ATS635/636
120 pF
Extensive applications information on magnets and Hall-effect sensors including Chopper-Stabilization is available in the
Allegro Electronic Data Book
CD, or at the website:
http://www.allegromicro.com
.
相關PDF資料
PDF描述
ATS636LSETN-T RESISTOR, FIXED, FILM, CHIP
ATS640JSB True Zero-Speed,Self-Calibrating ,Hall-Effect Gear-Tooth Sensor For Two-Wire Applications(真速度歸零,自校準,霍爾效應齒輪嚙合傳感器(用于2線))
ATS642LSH Two-Wire True Zero Speed Miniature Differential Peak-Detecting Gear Tooth Sensor with Continuous Calibration
ATS642LSHTN-I1-T Two-Wire True Zero Speed Miniature Differential Peak-Detecting Gear Tooth Sensor with Continuous Calibration
ATS642LSHTN-I2-T Two-Wire True Zero Speed Miniature Differential Peak-Detecting Gear Tooth Sensor with Continuous Calibration
相關代理商/技術參數
參數描述
ATS636LSB-FP 功能描述:IC SENSOR GEAR TOOTH 4-SIP RoHS:否 類別:傳感器,轉換器 >> 磁性 - 霍爾效應,數字式開關,線性,羅盤 (IC) 系列:- 標準包裝:1 系列:- 傳感范圍:20mT ~ 80mT 類型:旋轉 電源電壓:4.5 V ~ 5.5 V 電流 - 電源:15mA 電流 - 輸出(最大):- 輸出類型:數字式,PWM,8.5 位串行 特點:可編程 工作溫度:-40°C ~ 150°C 封裝/外殼:20-SSOP(0.209",5.30mm 寬) 供應商設備封裝:20-SSOP 包裝:Digi-Reel® 其它名稱:AS5132-HSST-500DKR
ATS636LSE 制造商:ALLEGRO 制造商全稱:Allegro MicroSystems 功能描述:Programmable Back Biased Hall-Effect Switch with TPOS Functionality
ATS636LSE_12 制造商:ALLEGRO 制造商全稱:Allegro MicroSystems 功能描述:The ATS636LSE programmable, true power-on state (TPOS), device is optimized Hall-effect IC and rare-earth pellet combinations that switch in response to magnetic signals...
ATS636LSETN 功能描述:IC SENSOR GEAR TOOTH 4-SIP RoHS:否 類別:傳感器,轉換器 >> 磁性 - 霍爾效應,數字式開關,線性,羅盤 (IC) 系列:- 標準包裝:1 系列:- 傳感范圍:20mT ~ 80mT 類型:旋轉 電源電壓:4.5 V ~ 5.5 V 電流 - 電源:15mA 電流 - 輸出(最大):- 輸出類型:數字式,PWM,8.5 位串行 特點:可編程 工作溫度:-40°C ~ 150°C 封裝/外殼:20-SSOP(0.209",5.30mm 寬) 供應商設備封裝:20-SSOP 包裝:Digi-Reel® 其它名稱:AS5132-HSST-500DKR
ATS636LSETN-T 功能描述:IC HALL EFFECT SWITCH TPOS 4-SIP RoHS:是 類別:傳感器,轉換器 >> 磁性 - 霍爾效應,數字式開關,線性,羅盤 (IC) 系列:- 標準包裝:1 系列:- 傳感范圍:20mT ~ 80mT 類型:旋轉 電源電壓:4.5 V ~ 5.5 V 電流 - 電源:15mA 電流 - 輸出(最大):- 輸出類型:數字式,PWM,8.5 位串行 特點:可編程 工作溫度:-40°C ~ 150°C 封裝/外殼:20-SSOP(0.209",5.30mm 寬) 供應商設備封裝:20-SSOP 包裝:Digi-Reel® 其它名稱:AS5132-HSST-500DKR