AVR core combines a ri" />
鍙冩暩(sh霉)璩囨枡
鍨嬭櫉锛� ATMEGA32L-8AJ
寤犲晢锛� Atmel
鏂囦欢闋佹暩(sh霉)锛� 16/21闋�
鏂囦欢澶�?銆�?/td> 0K
鎻忚堪锛� IC MCU AVR 32K 5V 8MHZ 44-TQFP
鐢�(ch菐n)鍝佸煿瑷撴ā濉婏細 megaAVR Introduction
妯欐簴鍖呰锛� 160
绯诲垪锛� AVR® ATmega
鏍稿績铏曠悊鍣細 AVR
鑺珨灏哄锛� 8-浣�
閫熷害锛� 8MHz
閫i€氭€э細 I²C锛孲PI锛孶ART/USART
澶栧湇瑷倷锛� 娆犲妾㈡脯/寰╀綅锛孭OR锛孭WM锛學DT
杓稿叆/杓稿嚭鏁�(sh霉)锛� 32
绋嬪簭瀛樺劜鍣ㄥ閲忥細 32KB锛�16K x 16锛�
绋嬪簭瀛樺劜鍣ㄩ鍨嬶細 闁冨瓨
EEPROM 澶у皬锛� 1K x 8
RAM 瀹归噺锛� 2K x 8
闆诲 - 闆绘簮 (Vcc/Vdd)锛� 2.7 V ~ 5.5 V
鏁�(sh霉)鎿�(j霉)杞夋彌鍣細 A/D 8x10b
鎸暕鍣ㄥ瀷锛� 鍏�(n猫i)閮�
宸ヤ綔婧害锛� -40°C ~ 85°C
灏佽/澶栨锛� 44-TQFP
鍖呰锛� 鎵樼洡
4
2503QS鈥揂VR鈥�02/11
ATmega32(L)
The Atmel
AVR core combines a rich instruction set with 32 general purpose working regis-
ters. All the 32 registers are directly connected to the Arithmetic Logic Unit (ALU), allowing two
independent registers to be accessed in one single instruction executed in one clock cycle. The
resulting architecture is more code efficient while achieving throughputs up to ten times faster
than conventional CISC microcontrollers.
The ATmega32 provides the following features: 32Kbytes of In-System Programmable Flash
Program memory with Read-While-Write capabilities, 1024bytes EEPROM, 2Kbyte SRAM, 32
general purpose I/O lines, 32 general purpose working registers, a JTAG interface for Boundary-
scan, On-chip Debugging support and programming, three flexible Timer/Counters with com-
pare modes, Internal and External Interrupts, a serial programmable USART, a byte oriented
Two-wire Serial Interface, an 8-channel, 10-bit ADC with optional differential input stage with
programmable gain (TQFP package only), a programmable Watchdog Timer with Internal Oscil-
lator, an SPI serial port, and six software selectable power saving modes. The Idle mode stops
the CPU while allowing the USART, Two-wire interface, A/D Converter, SRAM, Timer/Counters,
SPI port, and interrupt system to continue functioning. The Power-down mode saves the register
contents but freezes the Oscillator, disabling all other chip functions until the next External Inter-
rupt or Hardware Reset. In Power-save mode, the Asynchronous Timer continues to run,
allowing the user to maintain a timer base while the rest of the device is sleeping. The ADC
Noise Reduction mode stops the CPU and all I/O modules except Asynchronous Timer and
ADC, to minimize switching noise during ADC conversions. In Standby mode, the crystal/reso-
nator Oscillator is running while the rest of the device is sleeping. This allows very fast start-up
combined with low-power consumption. In Extended Standby mode, both the main Oscillator
and the Asynchronous Timer continue to run.
The device is manufactured using Atmel鈥檚 high density nonvolatile memory technology. The On-
chip ISP Flash allows the program memory to be reprogrammed in-system through an SPI serial
interface, by a conventional nonvolatile memory programmer, or by an On-chip Boot program
running on the AVR core. The boot program can use any interface to download the application
program in the Application Flash memory. Software in the Boot Flash section will continue to run
while the Application Flash section is updated, providing true Read-While-Write operation. By
combining an 8-bit RISC CPU with In-System Self-Programmable Flash on a monolithic chip,
the Atmel ATmega32 is a powerful microcontroller that provides a highly-flexible and cost-effec-
tive solution to many embedded control applications.
The Atmel AVR ATmega32 is supported with a full suite of program and system development
tools including: C compilers, macro assemblers, program debugger/simulators, in-circuit emula-
tors, and evaluation kits.
Pin Descriptions
VCC
Digital supply voltage.
GND
Ground.
Port A (PA7..PA0)
Port A serves as the analog inputs to the A/D Converter.
Port A also serves as an 8-bit bi-directional I/O port, if the A/D Converter is not used. Port pins
can provide internal pull-up resistors (selected for each bit). The Port A output buffers have sym-
metrical drive characteristics with both high sink and source capability. When pins PA0 to PA7
are used as inputs and are externally pulled low, they will source current if the internal pull-up
resistors are activated. The Port A pins are tri-stated when a reset condition becomes active,
even if the clock is not running.
鐩搁棞PDF璩囨枡
PDF鎻忚堪
ATMEGA32-16PJ IC MCU AVR 32K 5V 16MHZ 40-DIP
ATMEGA32-16MJ IC MCU AVR 32K 5V 16MHZ 44-QFN
ATMEGA32-16AJ IC MCU AVR 32K 5V 16MHZ 44-TQFP
52892-1690 CONN FFC 16POS .50MM R/A ZIF SMD
52892-1590 CONN FFC 15POS .50MM R/A ZIF SMD
鐩搁棞浠g悊鍟�/鎶€琛撳弮鏁�(sh霉)
鍙冩暩(sh霉)鎻忚堪
ATmega32L-8AU 鍔熻兘鎻忚堪:8浣嶅井鎺у埗鍣� -MCU 32kB Flash 1kB EEPROM 32 I/O Pins RoHS:鍚� 鍒堕€犲晢:Silicon Labs 鏍稿績:8051 铏曠悊鍣ㄧ郴鍒�:C8051F39x 鏁�(sh霉)鎿�(j霉)绺界窔瀵害:8 bit 鏈€澶ф檪閻橀牷鐜�:50 MHz 绋嬪簭瀛樺劜鍣ㄥぇ灏�:16 KB 鏁�(sh霉)鎿�(j霉) RAM 澶у皬:1 KB 鐗囦笂 ADC:Yes 宸ヤ綔闆绘簮闆诲:1.8 V to 3.6 V 宸ヤ綔婧害鑼冨湇:- 40 C to + 105 C 灏佽 / 绠遍珨:QFN-20 瀹夎棰ㄦ牸:SMD/SMT
ATMEGA32L8AU SL383 鍒堕€犲晢:Atmel Corporation 鍔熻兘鎻忚堪:MCU 8-bit ATmega AVR RISC 32KB Flash 3.3V/5V 44-Pin TQFP
ATMEGA32L-8AU SL383 鍒堕€犲晢:Atmel Corporation 鍔熻兘鎻忚堪:MCU 8BIT ATMEGA RISC 32KB FLASH 3.3V/5V 44TQFP - Tape and Reel
ATMEGA32L-8AU SL609 鍒堕€犲晢:Atmel Corporation 鍔熻兘鎻忚堪:
ATMEGA32L-8AUR 鍔熻兘鎻忚堪:8浣嶅井鎺у埗鍣� -MCU AVR 32K FLSH 2K SRAM 1KB EE-8MHz IND RoHS:鍚� 鍒堕€犲晢:Silicon Labs 鏍稿績:8051 铏曠悊鍣ㄧ郴鍒�:C8051F39x 鏁�(sh霉)鎿�(j霉)绺界窔瀵害:8 bit 鏈€澶ф檪閻橀牷鐜�:50 MHz 绋嬪簭瀛樺劜鍣ㄥぇ灏�:16 KB 鏁�(sh霉)鎿�(j霉) RAM 澶у皬:1 KB 鐗囦笂 ADC:Yes 宸ヤ綔闆绘簮闆诲:1.8 V to 3.6 V 宸ヤ綔婧害鑼冨湇:- 40 C to + 105 C 灏佽 / 绠遍珨:QFN-20 瀹夎棰ㄦ牸:SMD/SMT