- 您現在的位置：買賣IC網 > PDF目錄1904 > ATA6620N-TAQY (Atmel)TXRX LIN BUS W/VREG SO-8 PDF資料下載
參數資料
| 型號： | ATA6620N-TAQY |
| 廠商： | Atmel |
| 文件頁數： | 17/22頁 |
| 文件大?。?/td> | 0K |
| 描述： | TXRX LIN BUS W/VREG SO-8 |
| 產品變化通告： | ATA6620N-TAxY Obsolescence 03/Feb/2012 |
| 標準包裝： | 4,000 |
| 類型： | 收發器 |
| 規程： | LIN |
| 電源電壓： | 5 V ~ 18 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 8-SO |
| 包裝： | 帶卷 (TR) |
4
4850I–AUTO–09/09
ATA6620N
3.7
Input/Output Pin (TXD)
This pin is the microcontroller interface to control the state of the LIN output. TXD must be pulled
to ground in order to drive the LIN bus low. If TXD is high or unconnected (internal pull-up resis-
tor), the LIN output transistor is turned off and the bus is in the recessive state.
3.8
Dominant Time-out Function (TXD)
The TXD input has an internal pull-up resistor. An internal timer prevents the bus line from being
driven permanently in the dominant state. If TXD is forced to low longer than t
DOM > 4 ms, the
LIN bus driver is switched to the recessive state. To reset this dominant time-out mode, TXD
must be switched to high (> 10 s) before normal data transmission can be started.
3.9
Output Pin (RXD)
This pin reports the state of the LIN bus to the microcontroller. LIN high (recessive state) is
reported by a high level at RXD; LIN low (dominant state) is reported by a low level at RXD. The
output has an internal pull-up structure with typically 5 k
Ω to V
CC. The AC characteristics are
measured with an external load capacitor of 20 pF.
The output is short-circuit protected. In unpowered mode (that is, V
S = 0V), RXD is switched off.
3.10
Enable Input Pin (EN)
This pin controls the operation mode of the interface. After power up of V
S (battery), the IC
switches to Pre-normal mode, even if EN is low or unconnected (internal pull-down resistor). If
EN is high, the interface is in Normal mode.
A falling edge at EN while TXD is still high forces the device to Silent mode. A falling edge at EN
while TXD is low forces the device to Sleep mode.
相關PDF資料 |
PDF描述 |
|---|---|
| ATA6661-TAQJ 19 | TXRX LIN 2.0 3.3V/5V 8SOIC |
| ATA6670-FFQW | IC TXRX LIN DUAL 14VDFN |
| ATAM893T-TKSYD | IC MCU FLASH 4K MTP 20SSOP |
| ATF1500ABV-15JI | IC CPLD 15NS LOW VOLT PLCC |
| ATF1500AL-20JI | IC CPLD 20NS LOW POW 44PLCC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ATA6620N-TAQY 19 | 功能描述:LIN 收發器 LIN SBC RoHS:否 制造商:NXP Semiconductors 工作電源電壓: 電源電流: 最大工作溫度: 封裝 / 箱體:SO-8 |
| ATA6620N-TAQY 19 | 功能描述:LIN 收發器 LIN SBC RoHS:否 制造商:NXP Semiconductors 工作電源電壓: 電源電流: 最大工作溫度: 封裝 / 箱體:SO-8 |
| ATA6620N-TASY | 功能描述:射頻無線雜項 LIN SBC RoHS:否 制造商:Texas Instruments 工作頻率:112 kHz to 205 kHz 電源電壓-最大:3.6 V 電源電壓-最小:3 V 電源電流:8 mA 最大功率耗散: 工作溫度范圍:- 40 C to + 110 C 封裝 / 箱體:VQFN-48 封裝:Reel |
| ATA6620-TAQY | 功能描述:IC TXRX LIN BUS 5V/50MA 8SOIC RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:1,140 系列:AU 類型:收發器 驅動器/接收器數:1/1 規程:CAN 電源電壓:5.3 V ~ 27 V 安裝類型:表面貼裝 封裝/外殼:14-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:14-SO 包裝:管件 其它名稱:935267940512AU5790D14AU5790D14-ND |
| ATA6620-TASY | 功能描述:IC TXRX LIN BUS 5V/50MA 8SOIC RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:1,140 系列:AU 類型:收發器 驅動器/接收器數:1/1 規程:CAN 電源電壓:5.3 V ~ 27 V 安裝類型:表面貼裝 封裝/外殼:14-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:14-SO 包裝:管件 其它名稱:935267940512AU5790D14AU5790D14-ND |
發布緊急采購，3分鐘左右您將得到回復。