Mode 1, no lock protection B1 = 0, B2 = 1
參數資料
型號: AT89S51-24PI
廠商: Atmel
文件頁數: 13/31頁
文件大小: 0K
描述: IC 8051 MCU 4K FLASH 40-DIP
標準包裝: 10
系列: 89S
核心處理器: 8051
芯體尺寸: 8-位
速度: 24MHz
連通性: UART/USART
外圍設備: WDT
輸入/輸出數: 32
程序存儲器容量: 4KB(4K x 8)
程序存儲器類型: 閃存
RAM 容量: 128 x 8
電壓 - 電源 (Vcc/Vdd): 4 V ~ 5.5 V
振蕩器型: 內部
工作溫度: -40°C ~ 85°C
封裝/外殼: 40-DIP(0.600",15.24mm)
包裝: 管件
20
2487D–MICRO–6/08
AT89S51
Note:
1. B1 = 0, B2 = 0
Mode 1, no lock protection
B1 = 0, B2 = 1
Mode 2, lock bit 1 activated
B1 = 1, B2 = 0
Mode 3, lock bit 2 activated
B1 = 1, B2 = 1
Mode 4, lock bit 3 activated
After Reset signal is high, SCK should be low for at least 64 system clocks before it goes high to clock in the enable data
bytes. No pulsing of Reset signal is necessary. SCK should be no faster than 1/16 of the system clock at XTAL1.
For Page Read/Write, the data always starts from byte 0 to 255. After the command byte and upper address byte are
latched, each byte thereafter is treated as data until all 256 bytes are shifted in/out. Then the next instruction will be ready
to be decoded.
20. Serial Programming Instruction Set
Instruction
Instruction Format
Operation
Byte 1Byte 2Byte 3Byte 4
Programming Enable
1010 1100
0101 0011
xxxx xxxx
0110 1001
(Output on
MISO)
Enable Serial Programming
while RST is high
Chip Erase
1010 1100
100x xxxx
xxxx xxxx
Chip Erase Flash memory
array
Read Program Memory
(Byte Mode)
0010 0000
xxxx
Read data from Program
memory in the byte mode
Write Program Memory
(Byte Mode)
0100 0000
xxxx
Write data to Program
memory in the byte mode
Write Lock Bits(1)
1010 1100
1110 00
xxxx xxxx
Write Lock bits. See Note (1).
Read Lock Bits
0010 0100
xxxx xxxx
xxx
xx
Read back current status of
the lock bits (a programmed
lock bit reads back as a “1”)
Read Signature Bytes
0010 1000
xxxx
xxx xxx0
Signature Byte
Read Signature Byte
Read Program Memory
(Page Mode)
0011 0000
xxxx
Byte 0
Byte 1...
Byte 255
Read data from Program
memory in the Page Mode
(256 bytes)
Write Program Memory
(Page Mode)
0101 0000
xxxx
Byte 0
Byte 1...
Byte 255
Write data to Program
memory in the Page Mode
(256 bytes)
} Eachofthelockbitmodesneedtobeactivatedsequentiallybe-
fore Mode 4 can be executed.
D7 D6 D5 D4
D3 D2 D1 D0
A7 A6 A5 A4
A3 A2 A1 A0
A11 A10
A9 A8
B2
B1
A11 A10
A9 A8
A7 A6 A5 A4
A3 A2 A1 A0
D7 D6 D5 D4
D3 D2 D1 D0
LB3
LB2 LB1
A11 A10
A9 A8
A11 A10
A9 A8
A7
A1
1
A10
A9 A8
相關PDF資料
PDF描述
AT89S51-24PC IC 8051 MCU 4K FLASH 40-DIP
AT89LV55-12PC IC 8051 MCU FLASH 20K 40DIP
AT89LV55-12JI IC 8051 MCU FLASH 20K 44PLCC
AT89LV55-12JC IC 8051 MCU FLASH 20K 44PLCC
AT89LV55-12AI IC 8051 MCU FLASH 20K 44TQFP
相關代理商/技術參數
參數描述
AT89S51-24PU 功能描述:8位微控制器 -MCU 4kB Flash 128B RAM 33MHz 4.0V-5.5V RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
AT89S51-24PU SL383 制造商:Atmel Corporation 功能描述:8051 4K ISP FLASH 4.0 TO 5.5V
AT89S51-W 功能描述:8位微控制器 -MCU Microcontroller RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
AT89S52-16JC 制造商:Atmel Corporation 功能描述:
AT89S52-24AC 功能描述:8位微控制器 -MCU 8K ISP FLASH 2.7 TO 5.5V - 24MHz RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT