參數資料
型號： AT89LP428-20MH
廠商： Atmel
文件頁數： 148/149頁
文件大小： 0K
描述： MCU 8051 4K FLASH SPI 32VQFN
產品培訓模塊： MCU Product Line Introduction
標準包裝： 490
系列： 89LP
核心處理器： 8051
芯體尺寸： 8-位
速度： 20MHz
連通性： SPI，UART/USART
外圍設備： 欠壓檢測/復位，POR，PWM，WDT
輸入/輸出數： 30
程序存儲器容量： 4KB（4K x 8）
程序存儲器類型： 閃存
EEPROM 大?。?/td> 512 x 8
RAM 容量： 768 x 8
電壓 - 電源 (Vcc/Vdd)： 2.4 V ~ 5.5 V
振蕩器型： 內部
工作溫度： -40°C ~ 85°C
封裝/外殼： 32-VFQFN 裸露焊盤
包裝： 托盤
98
3654A–MICRO–8/09
AT89LP428/828
18. Dual Analog Comparators
The AT89LP428/828 provides two analog comparators. The analog comparators have the fol-
lowing features:
Internal 3-level Voltage Reference
Multiple Shared Analog Input Channels
Selectable Interrupt Conditions
– High- or Low-level
–Rising- or Falling-edge
–Output Toggle
Hardware Debouncing Modes
A block diagram of the dual analog comparators with relevant connections is shown in Figure
18-1. Input options allow the comparators to function in a number of different configurations as
shown in Figure 18-3. Comparator operation is such that the output is a logic “1” when the posi-
tive input is greater than the negative input. Otherwise, the output is a zero. Setting the CENA
(ACSRA.3) and CENB (ACSRB.3) bits enable Comparator A and B, respectively. The user must
also set the CONA (ACSRA.5) or CONB (ACSRB.5) bits to connect the comparator inputs
before using a comparator. When a comparator is first enabled, the comparator output and
Table 17-4.
SPSR – SPI Status Register
SPSR Address = E8H
Reset Value = 0000 X000B
Not Bit Addressable
SPIF
WCOL
MODF
TXE
–
SSIG
DISSOENH
Bit
76543
210
Symbol
Function
SPIF
SPI Transfer Complete Interrupt Flag. When a serial transfer is complete, the SPIF bit is set by hardware and an interrupt
is generated if ESP = 1. The SPIF bit may be cleared by software or by reading the SPI status register followed by
reading/writing the SPI data register.
WCOL
Write Collision Flag. The WCOL bit is set by hardware if SPDR is written while the transmit buffer is full. The ongoing
transfer is not affected. WCOL may be cleared by software or by reading the SPI status register followed by
reading/writing the SPI data register.
MODF
Mode Fault Flag. MODF is set by hardware when a master mode collision is detected (MSTR = 1, SSIG = 0 and SS = 0)
and an interrupt is generated if ESP= 1. MODF must be cleared by software.
TXE
Transmit Buffer Empty Flag. Set by hardware when the transmit buffer is loaded into the shift register, allowing a new byte
to be loaded. TXE must be cleared by software. When ENH = 1 and ESP = 1, TXE will generate an interrupt.
SSIG
Slave Select Ignore. If SSIG = 0, the SPI will only operate in slave mode if SS (P1.4) is pulled low. When SSIG = 1, the
SPI ignores SS in slave mode and is active whenever SPE (SPCR.6) is set. When MSTR = 1 and SSIG = 0, SS is
monitored for master mode collisions. Setting SSIG = 1 will ignore collisions on SS. P1.4 may be used as a regular I/O
pin when SSIG = 1.
DISSO
Disable slave output bit. When set, this bit causes the MISO pin to be tristated so that more than one slave device can
share the same interface without multiple SS lines. Normally, the first byte in a transmission could be the slave address
and only the selected slave should clear its DISSO bit.
ENH
TX Buffer Interrupt Enable. When ENH = 1, TXE will generate an SPI interrupt if ESP = 1. When ENH = 0, TXE does not
generate an interrupt.
相關PDF資料
PDF描述
516-020-000-202 CONN RCPT 20POS RACK & PANEL
516-020-000-402 CONN RACK & PANEL RCPT 20POS
AT91SAM7XC256B-CU-999 IC MCU ARM7 256KB FLASH 100TFBGA
AT91SAM7XC256B-AU-999 IC MCU ARM7 256KB FLASH 100LQFP
AT91SAM7XC128B-CU-999 IC MCU ARM7 128KB FLASH 100TFBGA
相關代理商/技術參數
參數描述
AT89LP428-20PU 功能描述:8位微控制器 -MCU SingleCycle 8051 4K ISP Flash 2.4V RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
AT89LP51-20AU 功能描述:8位微控制器 -MCU Single Cycle 8051 4K ISP FL RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
AT89LP51-20JU 功能描述:8位微控制器 -MCU Single Cycle 8051 4K ISP FL RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
AT89LP51-20MU 功能描述:8位微控制器 -MCU Single Cycle 8051 4K ISP FL RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
AT89LP51-20PU 功能描述:8位微控制器 -MCU Single Cycle 8051 4K ISP FL RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*