參數資料
型號: AT87F51-24PI
廠商: Atmel
文件頁數: 10/16頁
文件大?。?/td> 0K
描述: IC MICRO CTRL 24MHZ 40DIP
標準包裝: 10
系列: 87F
核心處理器: 8051
芯體尺寸: 8-位
速度: 24MHz
連通性: UART/USART
輸入/輸出數: 32
程序存儲器容量: 4KB(4K x 8)
程序存儲器類型: OTP 快速閃存
RAM 容量: 128 x 8
電壓 - 電源 (Vcc/Vdd): 4 V ~ 6 V
振蕩器型: 內部
工作溫度: -40°C ~ 85°C
封裝/外殼: 40-DIP(0.600",15.24mm)
包裝: 管件
Not
3
The AT87F51 provides the following standard features: 4K
bytes of QuickFlash, 128 bytes of RAM, 32 I/O lines, two
16-bit timer/counters, a five vector two-level interrupt archi-
tecture, a full duplex serial port, on-chip oscillator and clock
circuitry. In addition, the AT87F51 is designed with static
logic for operation down to zero frequency and supports
two software selectable power saving modes. The Idle
Mo de st ops th e CPU wh ile allo win g th e RAM,
timer/counters, serial port and interrupt system to continue
functioning. The Power Down Mode saves the RAM con-
tents but freezes the oscillator disabling all other chip func-
tions until the next hardware reset.
Pin Description
VCC
Supply voltage.
GND
Ground.
Port 0
Port 0 is an 8-bit open drain bidirectional I/O port. As an
output port each pin can sink eight TTL inputs. When 1s
are written to port 0 pins, the pins can be used as high-
impedance inputs.
Port 0 may also be configured to be the multiplexed low-
order address/data bus during accesses to external pro-
gram and data memory. In this mode P0 has internal pul-
lups.
Port 0 also receives the code bytes during QuickFlash pro-
gramming, and outputs the code bytes during program ver-
ification. External pullups are required during program veri-
fication.
Port 1
Port 1 is an 8-bit bidirectional I/O port with internal pullups.
The Port 1 output buffers can sink/source four TTL inputs.
When 1s are written to Port 1 pins they are pulled high by
the internal pullups and can be used as inputs. As inputs,
Port 1 pins that are externally being pulled low will source
current (IIL) because of the internal pullups.
Port 1 also receives the low-order address bytes during
QuickFlash programming and verification.
Port 2
Port 2 is an 8-bit bidirectional I/O port with internal pullups.
The Port 2 output buffers can sink/source four TTL inputs.
When 1s are written to Port 2 pins they are pulled high by
the internal pullups and can be used as inputs. As inputs,
Port 2 pins that are externally being pulled low will source
current (IIL) because of the internal pullups.
Port 2 emits the high-order address byte during fetches
from external program memory and during accesses to
external data memory that use 16-bit addresses (MOVX @
DPTR). In this application it uses strong internal pullups
when emitting 1s. During accesses to external data mem-
ory that use 8-bit addresses (MOVX @ RI), Port 2 emits the
contents of the P2 Special Function Register.
Port 2 also receives the high-order address bits and some
control signals during QuickFlash programming and verifi-
cation.
Port 3
Port 3 is an 8-bit bidirectional I/O port with internal pullups.
The Port 3 output buffers can sink/source four TTL inputs.
When 1s are written to Port 3 pins they are pulled high by
the internal pullups and can be used as inputs. As inputs,
Port 3 pins that are externally being pulled low will source
current (IIL) because of the pullups.
Port 3 also serves the functions of various special features
of the AT87F51 as listed below:
Port 3 also receives some control signals for QuickFlash
programming and verification.
RST
Reset input. A high on this pin for two machine cycles while
the oscillator is running resets the device.
ALE/PROG
Address Latch Enable output pulse for latching the low byte
of the address during accesses to external memory. This
pin is also the program pulse input (PROG) during Quick-
Flash programming.
In normal operation ALE is emitted at a constant rate of 1/6
the oscillator frequency, and may be used for external tim-
ing or clocking purposes. Note, however, that one ALE
pulse is skipped during each access to external Data Mem-
ory.
If desired, ALE operation can be disabled by setting bit 0 of
SFR location 8EH. With the bit set, ALE is active only dur-
ing a MOVX or MOVC instruction. Otherwise, the pin is
weakly pulled high. Setting the ALE-disable bit has no
effect if the microcontroller is in external execution mode.
PSEN
Program Store Enable is the read strobe to external pro-
gram memory.
Port Pin
Alternate Functions
P3.0
RXD (serial input port)
P3.1
TXD (serial output port)
P3.2
INT0 (external interrupt 0)
P3.3
INT1 (external interrupt 1)
P3.4
T0 (timer 0 external input)
P3.5
T1 (timer 1 external input)
P3.6
WR (external data memory write strobe)
P3.7
RD (external data memory read strobe)
相關PDF資料
PDF描述
AT87F52-24PC IC MICRO CTRL 24MHZ 40DIP
AT88SA102S-TH-T IC PRODUCT AUTHENTICATION 8TSSOP
AT88SC018-SU-CN-T IC CRYPTOCOMPANION RF/MEM 8SOIC
AT89C2051-24SU IC MCU 2K FLASH 24MHZ 20-SOIC
AT89C4051-24SJ IC MCU 4K FLASH 24MHZ 20-SOIC
相關代理商/技術參數
參數描述
AT87F51RC 制造商:未知廠家 制造商全稱:未知廠家 功能描述:AT87F51RC [Updated 2/00. 25 Pages]
AT87F51RC-24AC 功能描述:IC MCU 8BIT 32KB FLASH 44TQFP 制造商:microchip technology 系列:87F 包裝:托盤 零件狀態(tài):停產 核心處理器:8051 核心尺寸:8-位 速度:24MHz 連接性:UART/USART 外設:WDT I/O 數:32 程序存儲容量:32KB(32K x 8) 程序存儲器類型:OTP 快速閃存 EEPROM 容量:- RAM 容量:512 x 8 電壓 - 電源(Vcc/Vdd):4 V ~ 6 V 數據轉換器:- 振蕩器類型:內部 工作溫度:0°C ~ 70°C 封裝/外殼:44-TQFP 供應商器件封裝:44-TQFP(10x10) 基本零件編號:AT87F51RC 標準包裝:160
AT87F51RC-24AI 功能描述:IC MCU 8BIT 32KB FLASH 44TQFP 制造商:microchip technology 系列:87F 包裝:托盤 零件狀態(tài):停產 核心處理器:8051 核心尺寸:8-位 速度:24MHz 連接性:UART/USART 外設:WDT I/O 數:32 程序存儲容量:32KB(32K x 8) 程序存儲器類型:OTP 快速閃存 EEPROM 容量:- RAM 容量:512 x 8 電壓 - 電源(Vcc/Vdd):4 V ~ 6 V 數據轉換器:- 振蕩器類型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:44-TQFP 供應商器件封裝:44-TQFP(10x10) 基本零件編號:AT87F51RC 標準包裝:160
AT87F51RC-24JC 功能描述:8位微控制器 -MCU 80C31 w/4k RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
AT87F51RC-24JI 功能描述:IC MCU 8BIT 32KB FLASH 44PLCC 制造商:microchip technology 系列:87F 包裝:管件 零件狀態(tài):停產 核心處理器:8051 核心尺寸:8-位 速度:24MHz 連接性:UART/USART 外設:WDT I/O 數:32 程序存儲容量:32KB(32K x 8) 程序存儲器類型:OTP 快速閃存 EEPROM 容量:- RAM 容量:512 x 8 電壓 - 電源(Vcc/Vdd):4 V ~ 6 V 數據轉換器:- 振蕩器類型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:44-LCC(J 形引線) 供應商器件封裝:44-PLCC(16.59x16.59) 基本零件編號:AT87F51RC 標準包裝:135