參數資料
型號: AN8725FH
廠商: PANASONIC CORP
元件分類: 其它接口
英文描述: Semiconductor laser power control IC
中文描述: SPECIALTY INTERFACE CIRCUIT, PQFP80
封裝: 12 X 12 MM, PLASTIC, QFP-80
文件頁數: 4/36頁
文件大小: 197K
代理商: AN8725FH
AN8725FH
ICs for Optical Disk Drive
4
I
Pin Descriptions (continued)
Pin No.
Symbol
Category
Description
20
SGND
PS
D
Pin connected to the chip substrate.
21
SGND
PS
D
Must be used in the same potential as other GND pins.
22
DT 4
I/O
D
Data I/O 8-bit bus pin.
23
DT 5
I/O
D
The bus to set the data to be written on a register and to read out the data
24
DT 6
I/O
D
of a register.
25
DT 7
I/O
D
26
XLDEN
INU
D
LD enable input pin.
In a high-level or open mode, LD becomes off and open. This state is suited
to check the LD characteristics in keeping a connection to the IC. At the
time power off, both ends of LD are short-circuited by the IC for protection.
In the low-level, it returns to a normal operation.
27
XCLR
IND
D
Clear signal input pin.
Sets an LDDENB register to "0" in the low-level and presets the status of
each DAC and each switch to an initial state as defined separately.
But six registers for an abnormal detection are not cleared. In this state,
each output of a current amplification 1, 2, 3 are in the off state and a
shunt circuit becomes on to continue to protect LD.
Setting this pin to the high-level and the LDDENB register to "1", it returns
to a normal operation.
28
DGND
PS
D
GND pin exclusive for a logic circuit.
Must be used in the same potential as other GND pins.
29
XLDERR
OUT
D
Laser abnormality detection output pin.
When a supply voltage or a laser light emission exceeds a fixed range, it
goes to low-level. A supply voltage abnormality is detected for the volt-
age drop (3.9 V or less) or voltage rise (6.1 V or more). And an abnormal
light emission is detected for an excessive or weaker light emission set up
by 4-bit DAC5 and DAC6. This abnormality detection is latched so as to
prevent it from being reset until ERRCLR register is set to "1".
Further, each DAC output of a playback current, a peak current and a bias
current can be set to off, a shunt circuit be set to on and LD between anode
and GND be short-circuited by 100
so that LD can be protected. This
protection function is latched to keep it from being reset until ERRCLR is
set to "1". Selection of either operation or non-operation for this opera-
tion can be made by an STPMSK register.
30
PWMSK
MSC
D
The pin to set up the mask time for a transitional response output that
comes out at switching a detection level of excessive or insufficient light
emission by RPHOLD. Set a mask time by an external capacitor between
PWMSK and DGND and the resistor (10 k
) inside the IC. This pin is for
a schmitt-trigger input.
相關PDF資料
PDF描述
AN8730SB 4-channel driver IC for optical disk
AN8735NSB 2-channel linear driver IC for CD/CD-ROM player
AN8780SB 4Ch. Linear Driver IC for CD/CD-ROM
AN8787 WIRE, 18AWG, PVC, 105C,600V, UL1015, 16STD #30, BLK
AN8787NSB 4-channel linear driver IC for CD/CD-ROM drive
相關代理商/技術參數
參數描述
AN8730SB 制造商:PANASONIC 制造商全稱:Panasonic Semiconductor 功能描述:4-channel driver IC for optical disk
AN8735NSB 制造商:PANASONIC 制造商全稱:Panasonic Semiconductor 功能描述:2-channel linear driver IC for CD/CD-ROM player
AN8737SB 制造商:PANASONIC 制造商全稱:Panasonic Semiconductor 功能描述:3-channel driver IC for optical disk drive
AN8739SBTE2 制造商:Panasonic Industrial Company 功能描述:SUB ONLY IC
AN874 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:HIGH FREQUENCIES DAMPER DIODES