- 您現在的位置：買賣IC網 > PDF目錄92920 > AMMP-6522-TR1G 7000 MHz - 20000 MHz RF/MICROWAVE WIDE BAND LOW POWER AMPLIFIER PDF資料下載
參數資料
| 型號： | AMMP-6522-TR1G |
| 元件分類： | 放大器 |
| 英文描述： | 7000 MHz - 20000 MHz RF/MICROWAVE WIDE BAND LOW POWER AMPLIFIER |
| 封裝： | 5 X 5 MM, LEAD FREE, SMT, 8 PIN |
| 文件頁數： | 5/9頁 |
| 文件大?。?/td> | 346K |
| 代理商： | AMMP-6522-TR1G |
5
AMMP-6522 Application and Usage
Biasing and Operation
The AMMP-6522 is normally biased with a positive
drain supply connected to the VDD pin and a negative
gate voltage connected to the Vg pin through bypass
capacitors as shown in Figure 17. The recommended
drain supply voltage is 4 V and gate bias voltage is -1 V.
The corresponding currents are 75 mA and 0.1 mA re-
spectively. The typical required LO level is +15 dBm and
it should come from a low noise driver to ensure that
overall Front End NF is low.
The image rejection performance is dependent on the
selection of the IF quadrature hybrid. The performance
of the IF hybrid as well as the phase balance and VSWR
of the interface to the AMMP-6522 will affect the overall
front end performance.
There is minimal performance degradation if Vdd is
lowered to 3 V or raised to 5 V. If lower current is required,
then Vdd = 3 V will provide considerably similar RF
performance.
Figure 17. Application of receiver with IF Balun
RF
IF1
LSB
NC
IF2
Vdd
USB
LO
IF
RF
1000 pF
NC
Vg
LO
+15 dBm
IF
1-3.5 GHz
USB
TOP VIEW
PACKAGE BASE: GND
IF
Vg
1000 pF
LSB
The recommended Vg is -1 V. However, depending on
the operating frequency, Vg can be changed to achieve
better performance for that particular frequency.
Please refer to Figures 9 and 10 for how to best select the
appropriate Vg for the intended frequency of operation.
Theoretically IF frequencies can be as low as DC. How-
ever, when direct conversion is used (IF = DC), a so-called
phenomenon DC-offset could occur at the two IF out-
puts. In most practical applications, IF should be more
than a few hundreds kHz to avoid DC-offset correction.
Refer the Absolute Maximum Ratings table for allowed
DC and thermal condition.
相關PDF資料 |
PDF描述 |
|---|---|
| AMMP-6522-TR2G | 7000 MHz - 20000 MHz RF/MICROWAVE WIDE BAND LOW POWER AMPLIFIER |
| AMMP-6545-BLKG | 18000 MHz - 40000 MHz RF/MICROWAVE DOUBLE BALANCED MIXER, 12 dB CONVERSION LOSS-MAX |
| AMMP-6545-TR1G | 18000 MHz - 40000 MHz RF/MICROWAVE DOUBLE BALANCED MIXER, 12 dB CONVERSION LOSS-MAX |
| AMMP-6545-TR2G | 18000 MHz - 40000 MHz RF/MICROWAVE DOUBLE BALANCED MIXER, 12 dB CONVERSION LOSS-MAX |
| AMP-11-2 | 5 MHz - 1000 MHz RF/MICROWAVE WIDE BAND LOW POWER AMPLIFIER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AMMP-6522-TR2G | 功能描述:射頻放大器 LNA IR Mixer 6-22GHz RoHS:否 制造商:Skyworks Solutions, Inc. 類型:Low Noise Amplifier 工作頻率:2.3 GHz to 2.8 GHz P1dB:18.5 dBm 輸出截獲點:37.5 dBm 功率增益類型:32 dB 噪聲系數:0.85 dB 工作電源電壓:5 V 電源電流:125 mA 測試頻率:2.6 GHz 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 封裝:Reel |
| AMMP-6530 | 制造商:AGILENT 制造商全稱:AGILENT 功能描述:5-30 GHz Image Reject Mixer |
| AMMP-6530-BLK | 功能描述:射頻混合器 Mixer MMIC 5-30GHz RoHS:否 制造商:NXP Semiconductors 頻率范圍: 轉換損失——最大: 工作電源電壓:6 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
| AMMP-6530-TR1 | 功能描述:射頻混合器 Mixer MMIC 5-30GHz RoHS:否 制造商:NXP Semiconductors 頻率范圍: 轉換損失——最大: 工作電源電壓:6 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
| AMMP-6530-TR2 | 功能描述:射頻混合器 Mixer MMIC 5-30GHz RoHS:否 制造商:NXP Semiconductors 頻率范圍: 轉換損失——最大: 工作電源電壓:6 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。