- 您現在的位置：買賣IC網 > PDF目錄9867 > AMIS-49250-XTP (ON Semiconductor)IC TXRX FIELDBUS MAU 44NQFP PDF資料下載
參數資料
| 型號： | AMIS-49250-XTP |
| 廠商： | ON Semiconductor |
| 文件頁數： | 6/22頁 |
| 文件大小： | 0K |
| 描述： | IC TXRX FIELDBUS MAU 44NQFP |
| 標準包裝： | 2,500 |
| 類型： | 收發器 |
| 驅動器/接收器數： | 1/1 |
| 規程： | MDS-MAU |
| 電源電壓： | 4.75 V ~ 6.2 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 44-VFQFN 裸露焊盤 |
| 供應商設備封裝： | 44-NQFP（7x7） |
| 包裝： | 帶卷 (TR) |
AMIS-492x0
4.3 Transmit Block
The transmit block contains four sub-blocks:
1.
MDS-interface – decodes input signals to generate internal control signals.
2.
Tri-level modulator – generates current signals used as inputs to the slew-rate controller.
3.
Slew rate controller – converts current to three distinct VDRV voltage levels (VS, VH, VL).
4.
Current drive amplifier – op amp designed to drive current drivers for 31.25kbps voltage-mode medium.
4.3.1. MDS-interface
The MDS-interface decodes input signals to generate internal control signals. The POL pin is used to select the polarity of TxE (transmit
enable). The TxE and TxS (transmit signal) are the MDS-MAU interface signals. These three signals are CMOS logic signals powered
by the VDD supply voltage. When POL is connected to GND, TxE is assumed to be active high (positive logic). Likewise, if POL is
connected to VDD, TxE is assumed to be active low (negative logic).
See Table 1 on page 7, Table 11, and Figure 8 to see how
MDS_CTRL Pin 26 can be used to control MDS interface operation.
Table 11 shows the resulting VDRV output for the various
combinations of interface signals.
Table 11: MDS-interface Logic
POL
TxE
TxS
VDRV
Low
High
VS
Low
VH
Low
High
VL
Low
VH
Low
High
VL
Low
High
VS
Figure 8: MDS Interface
4.3.2. Tri-level Modulator
The tri-level modulator switches current signals into a summing node. The slew rate controller converts the current to a voltage signal,
VDRV. The DC level of silence (VS) is nominally 2.5V. Transmission high (VH ) is nominally 2.9V and transmission low (VL) is nominally
2.1V, yielding an amplitude of 0.8V.
Rev. 6 | Page 14 of 22 | www.onsemi.com
相關PDF資料 |
PDF描述 |
|---|---|
| VE-B5K-MW-F4 | CONVERTER MOD DC/DC 40V 100W |
| MAX1068CEEG+ | IC ADC 14BIT 200KSPS 24-QSOP |
| MAX3284EAUT+T | IC RS485/422 RECEIVER SOT23-6 |
| MAX189AEWE+T | IC ADC 12BIT SERIAL LP 16SOIC |
| MS27468T15B35PB | CONN RCPT 37POS JAM NUT W/PINS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AMIS-492X0 | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:Fieldbus MAU |
| AMIS492X0GEVB | 制造商:ON Semiconductor 功能描述:FIELDBUS EVAL BOARD - Bulk |
| AMIS-49587 | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:Power Line Carrier Modem |
| AMIS-49587_P2 | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:Power Line Carrier Modem |
| AMIS49587C5871G | 功能描述:電信線路管理 IC C587- NAF- AMIS49587 RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。