- 您現在的位置：買賣IC網 > PDF目錄366550 > AM79C972BKIW (ADVANCED MICRO DEVICES INC) PCnet⑩-FAST+ Enhanced 10/100 Mbps PCI Ethernet Controller with OnNow Support PDF資料下載
參數資料
| 型號： | AM79C972BKIW |
| 廠商： | ADVANCED MICRO DEVICES INC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | PCnet⑩-FAST+ Enhanced 10/100 Mbps PCI Ethernet Controller with OnNow Support |
| 中文描述： | 5 CHANNEL(S), 100M bps, LOCAL AREA NETWORK CONTROLLER, PQFP16 |
| 封裝： | PLASTIC, QFP-160 |
| 文件頁數： | 86/130頁 |
| 文件大?。?/td> | 1580K |
| 代理商： | AM79C972BKIW |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁當前第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁
86
Am79C972
PME_STATUS bit (PMCSR, bit 15) to be set, which in
turn will assert the PME pin if the PME_EN bit
(PMCSR, bit 8) is set.
Pattern Match RAM (PMR)
PMR is organized as an array of 64 words by 40 bits as
shown in Figure 49. The PMR is programmed indirectly
through the BCRs 45, 46, and 47. When the BCR45 is
written and the PMAT_MODE bit (BCR45, bit 7) is set
to 1, Pattern Match logic is enabled. No bus accesses
into the PMR are possible when the PMAT_MODE bit
is set, and BCR46, BCR47, and all other bits in BCR45
are ignored. When PMAT_MODE is set, a read of
BCR45 returns all bits undefined except for
PMAT_MODE. In order to access the contents of the
PMR, PMAT_MODE bit should be programmed to 0.
When BCR45 is written to set the PMAT_MODE bit to
0, the Pattern Match logic is disabled and accesses to
the PMR are possible. Bits 6:0 of BCR45 specify the
address of the PMR word to be accessed. Writing to
BCR45 does not immediately affect the contents of the
PMR. Following the write to BCR45, the PMR word ad-
dressed by the bits 6:0 of the BCR45 may be read by
reading BCR45, BCR46, and BCR47 in any order. To
write to the PMR word, the write to BCR45 must be
followed by a write to BCR46 and a write to BCR47 in
that order to complete the operation. The PMR will not
actually be written until the write to BCR47 is complete.
The first two 40-bit words in this RAM serve as pointers
and contain enable bits for the eight possible match
patterns. The remainder of the RAM contains the
match patterns and associated match pattern control
bits. The byte 0 of the first word contains the Pattern
Enable bits. Any bit position set in this byte enables the
corresponding match pattern in the PMR, as an exam-
ple if the bit 3 is set, then the Pattern 3 is enabled for
matching. Bytes 1 to 4 in the first word are pointers to
the beginning of the patterns 0 to 3, and bytes 1 to 4 in
the second word are pointers to the beginning of the
patterns 4 to 7, respectively. Byte 0 of the second word
has no function associated with it.The byte 0 of the
words 2 to 63 is the Control Field of the PMR. Bit 7 of
this field is the End of Packet (EOP) bit. When this bit is
set, it indicates the end of a pattern in the PMR. Bits 6-
4 of the Control Field byte are the SKIP bits. The value
of the SKIP field indicates the number of the Dwords to
be skipped before the pattern in this PMR word is com-
pared with data from the incoming frame. A maximum
of seven Dwords may be skipped. Bits 3-0 of the Con-
trol Field byte are the MASK bits. These bits corre-
spond to the pattern match bytes 3-0 of the same PMR
word (PMR bytes 4-1). If bit
n
of this field is 0, then byte
n
of the corresponding pattern word is ignored. If this
field is programmed to 3, then bytes 0 and 1 of the pat-
tern match field (bytes 2 and 1 of the word) are used
and bytes 3 and 2 are ignored in the pattern matching
operation.
The contents of the PMR are not affected by
H_RESET, S_RESET, or STOP. The contents are un-
defined after a power up reset (POR).
Magic Packet Mode
In Magic Packet mode, the PCnet-
FAST
+ controller re-
mains fully powered up (all VDD and VDDB pins must
remain at their supply levels). The device will not gen-
erate any bus master transfers. No transmit operations
will be initiated on the network. The device will continue
to receive frames from the network, but all frames will
be automatically flushed from the receive FIFO. Slave
accesses to the PCnet-
FAST
+ controller are still possi-
ble. A Magic Packet is a frame that is addressed to the
PCnet-
FAST
+ controller and contains a data sequence
anywhere in its data field made up of 16 consecutive
copies of the device
’
s physical address (PADR[47:0]).
The PCnet-
FAST
+ controller will search incoming
frames until it finds a Magic Packet frame. It starts
scanning for the sequence after processing the length
field of the frame. The data sequence can begin any-
where in the data field of the frame, but must be de-
tected before the PCnet-
FAST
+ controller reaches the
frame
’
s FCS field. Any deviation of the incoming
frame
’
s data sequence from the required physical ad-
dress sequence, even by a single bit, will prevent the
detection of that frame as a Magic Packet frame.
The PCnet-
FAST
+ controller supports two different
modes of address detection for a Magic Packet frame.
If MPPLBA (CSR5, bit 5) or EMPPLBA (CSR116, bit 6)
are at their default value of 0, the PCnet-
FAST
+ con-
troller will only detect a Magic Packet frame if the des-
tination address of the packet matches the content of
the physical address register (PADR). If MPPLBA or
EMPPLBA are set to 1, the destination address of the
Magic Packet frame can be unicast, multicast, or
broadcast.
Note:
The setting of MPPLBA or EMPPLBA only ef-
fects the address detection of the Magic Packet frame.
The Magic Packet
’
s data sequence must be made up
of 16 consecutive copies of the device
’
s physical ad-
dress (PADR[47:0]), regardless of what kind of destina-
tion address it has.
相關PDF資料 |
PDF描述 |
|---|---|
| AM79C972BVCW | PCnet⑩-FAST+ Enhanced 10/100 Mbps PCI Ethernet Controller with OnNow Support |
| AM79C972 | PCnet⑩-FAST+ Enhanced 10/100 Mbps PCI Ethernet Controller with OnNow Support |
| AM79C972BVIW | PCnet⑩-FAST+ Enhanced 10/100 Mbps PCI Ethernet Controller with OnNow Support |
| AM79C974 | PCnetTM-SCSI Combination Ethernet and SCSI Controller for PCI Systems |
| AM79C974KCW | PCnetTM-SCSI Combination Ethernet and SCSI Controller for PCI Systems |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AM79C972BVC | 制造商:Advanced Micro Devices 功能描述: |
| AM79C972BVC\W | 制造商:Advanced Micro Devices 功能描述:Ethernet CTLR Single Chip 10Mbps/100Mbps 3.3V 176-Pin TQFP Tray 制造商:Advanced Micro Devices 功能描述:5 CHANNEL(S), 100M bps, LOCAL AREA NETWORK CONTROLLER, PQFP176 |
| AM79C972BVCW | 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:PCnet⑩-FAST+ Enhanced 10/100 Mbps PCI Ethernet Controller with OnNow Support |
| AM79C972BVD\\W | 制造商:Advanced Micro Devices 功能描述: |
| AM79C972BVD\W | 制造商:Advanced Micro Devices 功能描述:Ethernet CTLR Single Chip 10Mbps/100Mbps 3.3V 176-Pin TQFP Tray |
發布緊急采購，3分鐘左右您將得到回復。