- 您現在的位置：買賣IC網 > PDF目錄385095 > AK5371 (Asahi Kasei Microsystems Co.,Ltd) 2CH A/D CONVERTER WITH USB I/F PDF資料下載
參數資料
| 型號： | AK5371 |
| 廠商： | Asahi Kasei Microsystems Co.,Ltd |
| 英文描述： | 2CH A/D CONVERTER WITH USB I/F |
| 中文描述： | 2聲道的A / D轉換器的USB我/女 |
| 文件頁數： | 12/32頁 |
| 文件大?。?/td> | 256K |
| 代理商： | AK5371 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁當前第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
12
MS0103-E-00
MS0103-E-00
ASAHI KASEI
[AK 5371]
2001/06
Audio Format of the AK5371
The AK5371 supports two audio formats: 16bit/mono and 16bit/stereo. This feature can avoid the unnecessary occupation of USB
bandwidth. 16bit/mono is assigned to <Interlace 1, Alt1>, 16bit/stereo is assigned to <Interface 1, Alt2>. The A/D data on USB bus
is LSB first, Left channel first. When 16bit/mono audio format is selected, the AK5371 outputs left channel data on the USB bus.
Audio format is changed by “Set Interface” Request.
Synchronization
The AK5371 operates as Asynchronous Device. A/D converter in the AK5371 operates asynchronously with USB SOF timing. The
data from A/D converter are sent continuously to a buffer memory while the data are burstly transferred at the interval of SOF on the
USB. In order to arbitrate the difference of timing, AK5371 has a FIFO memory with a capacity of 2-frame depth .The average
sampling rate calculating from USB frame should be in accordance with A/D sampling rate (fs).
The AK5371 sends all A/D samples that were stored in the last frame to avoid overflow or underflow of FIFO. The following figure
shows an example. When sampling frequency is set to 44.1kHz, the AK5371 sends 45 samples once per ten times, and sends 44
samples in other frames. Average frequency is 44.1kHz. See
Figure 7
.
44 samples
44 samples
45 samples
N Frame
(N+1) Frame
(N+9) Frame
44 samples
(N+10) Frame
Figure 7. Synchronization
Power Management Control
When idle state continues for 3ms, the AK5371 goes to suspend state and forces almost all blocks including PLL, ADC block and
mic bias into stopping in order to observe 500
μ
A, which is USB suspend current requirement.
The device resumes the normal operation within 30ms after the device receives resume signal.
In the normal operation, MICBIAS outputs the voltage to supply the microphone’s bias voltage.
SUSN pin shows USB bus status; suspend mode (“L") or normal operation (“H").
SUSN pin can be used for external power control.
The AK5371 is very low power device at both normal state and suspend state. However, note that USB suspend current requirement,
500
μ
A, specifies the current which is totally consumed by not only the AK5371, by also regulator(s), and resistors. Therefore, low
power regulator should be selected to design USB microphone.
Feature Unit Control & Frequency Control
When the AK5371 receives “SET_FEATURE_UNIT_CONTROL” request, the device decodes the request and sets the value. Note
that only CUR value is valid for “SET_FEATURE_UNIT_CONTROL” request, and that MIN/MAX/RES value is invalid.
When the AK5371 receives “GET_FEATURE_UNIT_CONTROL” request, the device decodes the request and returns the value to
the host. CUR/MAX/MIN/RES value is valid for "Get Volume Request", but only CUR value is meaningful for "Get Mute
Request".
When the AK5371 receives “SET_ENDPOINT_CONTROL” request, it changes sampling frequency(fs). If fs is not supported, the
device forces to set the appropriate fs which it supports. When the AK5371 receives “GET_ENDPOINT_CONTROL” request, it
sends back the current value to the host.
相關PDF資料 |
PDF描述 |
|---|---|
| AK5371VQ | AB 5C 2#8 3#12 SKT WALL MT REC |
| AK5380 | 96kHz 24Bit ADC with Single - ended Input |
| AK5380VT | 96kHz 24Bit ADC with Single - ended Input |
| AK5381ET | 24Bit 96kHz ツヒ ADC |
| AK5381VT | 24Bit 96kHz ツヒ ADC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AK5371A | 制造商:AKM 制造商全稱:AKM 功能描述:2ch A/D Converter with USB I/F |
| AK5371AVQ | 制造商:AKM 制造商全稱:AKM 功能描述:2ch A/D Converter with USB I/F |
| AK5371AVQP | 功能描述:IC ADC STER W/USB 16BIT 48LQFP RoHS:是 類別:集成電路 (IC) >> 數據采集 - ADCs/DAC - 專用型 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 類型:數據采集系統（DAS） 分辨率（位）:16 b 采樣率（每秒）:21.94k 數據接口:MICROWIRE?，QSPI?，串行，SPI? 電壓電源:模擬和數字 電源電壓:1.8 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（6x6） 包裝:托盤 |
| AK5371VQ | 制造商:AKM 制造商全稱:AKM 功能描述:2CH A/D CONVERTER WITH USB I/F |
| AK5373 | 制造商:AKM 制造商全稱:AKM 功能描述:24-bit Stereo ADC with USB Interface |
發布緊急采購，3分鐘左右您將得到回復。